2 A leather soccer ball has an inside diameter of 8.5 in and a thickness of 0.1 in. Findthe volume of leather needed for its construction.AAn igloo or Eskimo hut is built in the form of a hemispherical shell with an insidediameter of 12 ft. If the igloo is constructed of snow blocks having a uniform thicknessof 2 ft and weighing 40 lb per cu. ft, find ihe weight of the igloo, neglecting theentrance. Also, if fresh air contains 0.04 per cent carbon dioxide, find the amount ofthis gas in the igloo when freshly ventilated.ne exclusive use of SLU. Reproduction, storing in a retrieval system, distributing, uploading or posting online, or transmitting in any form or by anyechanical, photocopying, recording, or otherwise of any part of this document, without the prior written permission of SLU, is strictly prohibited.

The given values are: Outside diameter, d1=8.5 in Outside radius, r1=4.25 in Inside…

Answered: 3 A leather soccer bail has an inside…

3 A leather soccer bail has an inside diameter of 8.5 in and a thickness of 0.1 in. Find the volume of leather needed for its construction, 4. An igloo or Eskimo hut ic h

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Briefly explain the difference between Ultimate Limit State (ULS). Stability, and Serviceability…

A: Ultimate Limit State: The ultimate limit state is also known as the Load and Resistance Factor…

Q: Define the following terminologies: i. Structural Number (SN) ii. Equivalent Single Axle Load…

Q: A silo consists of a right circular cylinder surmounted by a hemisphere. Find the most economical…

A: Most economical proportion : Volume of silo = Volume of cylinder + volume of hemisphere Let K is…

Q: When the length of the board is in inches, what is the formula used for B.F? _____

A: Board foot ( B.F.) is the standard unit used for measurement of lumber

Q: With specific examples, discuss the design issues involved in making products out of plastics vs.…

A: The general design guidelines for the production of plastic and composite-material parts:

Q: Tensile test had made to cylinder shape with diameter 3.0 In and length 5.7 In It had maximum…

A: proof stress- proof stress is define for those ductile metal in which yield point is not very clear…

Q: 2. GIVEN: Flat bed gooseneck trailer Trailer dead weight is 6250 pounds centered 9 feet from the…

A: Axle Load : The wheels applies load of vehicle at both the ends of an axle which is known as axle…

Q: The assembly consists of two posts AB and CD each made from material 1 having a modulus of…

A: The given figure is shown below:

Q: c) Discuss the application of plywood in the construction industry

A: Plywood is a manufactured board that's made up of thin sheets of wood – called plies or veneers –…

Q: stone concrete slab that is used for an office. The slab is 200 mm thick. Sketch the loading that…

Q: TABLE 9.5(a) - MINIMUM THICKNESS OF NONPRESTRESSED BEAMS OR ONE-WAY SLABS UNLESS DEFLECTIONS ARE…

A: Minimum girder depth as per ACI

Q: A timber beam shown in the figure is made up of Sasalit (50% stress grade). Use LRFD. All thegiven…

Q: Calculate the second moment of area in "in4" for a 4"x12" piece of lumber about the X-x and y-y…

Q: Question 22 A beam is what type of loading according to usage? O Environmental Load O Impact Load O…

Q: In construction of slotted floors for pig housing, we can never consider the use of wood because

A: In this question it is being asked that why we don't consider wood flooring in pig slaughter house

Q: A piece of wood is 3" square and 5 ft long. Determine the volume of the lead that will be attached…

A: To find volume of lead?

Q: What is California Bearing Ratio's OBJECTIVES/PURPOSE and its UNIT?

A: Both when compacted and in service, subgrade strength is controlled by the material's physical and…

Q: Define the Compression strength of steel fiber reinforced and unreinforced shotcrete?

A: Compression strength of steel fiber reinforced and unreinforced shotcrete:

Q: Design a rectangular beam for a 5 m simple span to support a uniform dead load of 20 kN/m and l…

A: Here we do not need to find base Base b=350mm is given in question we need to find effective depth…

Q: Select from the following, the type of admixture that you will use if: The work will be carried out…

A: Type B admixture is to be used at the specified Location of Jericho as the temperature in that place…

Q: ot boon sT Consider an inner beam-column joint in the ground floor roof of a eight storey building…

Q: Water at 25°C is pumped into the galvanized iron pipe branch consisting of two 50-mm-diameter pipes…

Q: A cylindrical block of wood 1 m in diameter and 1 m long has a specific weight of 7500 N/m3. Will it…

A: Given, Cylindrical block diameter = 1m Cylindrical block length= 1m Specific weight = 7500 N/m3

Q: 6. A mechanic uses a screwdriver with a handle diameter of 1.5" to install a X-20 UNC bolt into a…

Q: For the below wooden beam, under the given loading and dimensions: ↓↓ 50 kN C 4m w = 10 kN/m Is the…

Q: advantages and disadvantages of making a leaf-spring for a commercial vehicle using pultruded…

A: Leaf springs are one of the most ancient suspension components currently in use in autos. Automobile…

Q: A bridge/joint table is exactly what its name implies. What is the substitute? What is wrong with…

A: A bridge table is a table that just holds back the keys between the two tables in a many-to-numerous…

Q: It is the minimum thickness of two-lane tourism roads. O 9 inches O 12 inches O 6 inches O 10 inches

Q: The allowable deflection for beams is L/240, what is the allowable deflection in mm.?

A: Allowable deflection is the maximum distance that beam can deflect safely without any adverse…

Q: The existing beam is v 12* 16 with 1.44 in. protection, having W / D = 0.54; i is to be replaced by…

Q: A surveyor's steel tape is 100 ft long and has a cross-sectional section of 0.250 inch by 0.03 inch.…

A: Given data, modulus of elasticity = 30 x 10⁶ lb/in². Steel tape length = 100 ft Force on tape = 12…

Q: A double storey reinforced concrete restaurant will be built near the beach in Batu Layar, Johor.…

A: In this Question , RCC IS 456: 2000 code is used and different tables of this code is used. A/c to…

Q: Yarn A has twist of 16 turns/inch and count of 320 denier. It is desired to design a 250 denier Yarn…

A: The given data is: Twist in yarn=16 turns/inch No. of counts=320 denier

Q: Why is it that sacks made of woven polypropylene shall not be stacked more than 3 m high? Give at…

A: To create a lightweight, robust, and heavy-duty textile, polypropylene strips or threads are woven…

Q: There are 16 beams in the second floor of a house with a typical width of 400mm and depth of 300mm…

A: There is typing error in question. Width is given 400mm and depth 300mm which can't be structurally…

Q: *3-48. Determine the tension in the cables in order to crate. 400 N support the 400 N is weight of…

A: Objective: To determine the tension in the cables. Given: Weight of the crate (say w) = 400 N…

Q: The following are examples of Environmental Loads except, O Snow load O Seismic load O Traffic Ibad…

A: Given: Loads To find: Load other than environmental load

Q: A block of wood with a density of 35.3lb/ft^3 floats in a liquid with 3/4 of its volume submerged.…

Question

2 A leather soccer ball has an inside diameter of 8.5 in and a thickness of 0.1 in. Find
the volume of leather needed for its construction.
AAn igloo or Eskimo hut is built in the form of a hemispherical shell with an inside
diameter of 12 ft. If the igloo is constructed of snow blocks having a uniform thickness
of 2 ft and weighing 40 lb per cu. ft, find ihe weight of the igloo, neglecting the
entrance. Also, if fresh air contains 0.04 per cent carbon dioxide, find the amount of
this gas in the igloo when freshly ventilated.
ne exclusive use of SLU. Reproduction, storing in a retrieval system, distributing, uploading or posting online, or transmitting in any form or by any
echanical, photocopying, recording, or otherwise of any part of this document, without the prior written permission of SLU, is strictly prohibited.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1:The given values are:

VIEW

Step 2:To calculate:

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

The long ranger is riding through a sandstorm. Does his mask (a bandanna that covers his nose) significantly decrease the amount of sand he breathes in? assume the bandanna is made of fibers, each 300 μ in diameter. They are woven in a simple weave that blocks 75 % of the projected area; the remaining 25 % is open, with holes up to 75 μ in diameter. For the purpose of this problem, the bandanna may be considered equal to a single row of parallel fibers, each 300 u in diameter, with 75 % of the flow area blocked and 25 % open. The gas velocity approaching the cloth as he breaths is 1 m/s. a). Estimate both the collection efficiency for 10 u particles and the cut diameter for bandanna used as a filter
Reinforced concrete is approximately how many times heavier than wood typically used for construction? Question 5 options: 2 3 4 5
Fy and Fu values of A242 Grade 42 and A709 Grade 36 steel in MPa.
A car (automobile) manufacturer is designing a new bumper (fender). The material choice lies between plastic or steel. Applying the principles of LCA, which do you think is preferable?
Q1. A double storey reinforced concrete restaurant will be built near the beach in Batu Layar, Johor. Based on design life of 100 years with 1 hour and 30 minutes fire resistance, determine the suitable concrete grade and concrete cover for the continuous edge beams of the building to satisfy the requirements for bond, durability, and fire resistance. The cross-section of the beam is shown in FIGURE Q1. 2 H16 150 H10 - 200 6 H25 250 FIGURE Q1 550
In five or more sentences, what are the advantages of using plastics?
If other factors are equal, which piece of lumber is weaker: one with a slope of grain of 1 in 5 or one with a slope of grain of 1in 6?
A 100-foot-long surveyor’s steel tape with a cross-sectional area of 0.006 square inch must be stretched with a pull of 16# when in use. If the modulus of elasticity of this steel is , (a) what is the total elongation in the 100 foot tape and (b) what unit tensile stress is produced by the pull?
Assume you are on the lumber aisle at your favorite hardware store. You see a product labeled as: PT SYP 2x4x96. a)The nominal height (the larger dimension of the cross-section) of the lumber is _____in. b)The actual height (the larger dimension of the cross-section) of the lumber is _____in. c)The nominal width (the smaller dimension of the cross-section) of the lumber is _____in. d)The actual width (the smaller dimension of the cross-section) of the lumber is _____in. f)The nominal length of the lumber is _____ft. g)The actual length of the lumber is _____ft.
Prior to concrete pouring of a slab on grade, a polyethylene sheet it to be laid on the ground. The slab dimension is 30 meters wide and 50 meters length, how many linear meter of 12 feet wide PE sheet you’ll need for this activity? a. 400 l.m. b. 450 l.m. c. 500 l.m. d. 1673 l.m. What is total material of PE sheet, if the cost per 50 m. is Php 7,000? a. Php 56,000.00 b. Php 63,000.00 c. Php 70,000.00 d. Php 238,000.00
Find the FD FG GD GE HG HF
The base has an average thickness of 8 inches and a density of 110 pounds per cubic foot. The curb is 6 inches wide and has an inside radius of 5 feet. Determine the tons of base required.