3,) A closed cylindrical tank, 1.5m in diameter and 3m high contains 2m of water with the air space having a pressure of 150kPa. When the angular velocity is 90rpm, find the pressure at the bottom of the tank at the outer perimeter.

3,) A closed cylindrical tank, 1.5m in diameter and 3m high contains 2m of water with the air space having a pressure of 150kPa. When the angular velocity is 90rpm, find the pressure at the bottom of the tank at the outer perimeter.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 4m long, with one end closed, is inserted vertically with the open end down, into a tank of water…

A: Given data Length=4m Submerged depth=1.0m Neglect vapour pressure Atmospheric pressure=101.5kpa…

Q: A half parabolic gate 3m in tall and 1m wide is submerged and there are two different liquid on each…

A: Given- hg=3mb=1mGL=0.85GR=1.00

Q: 4- Air at 105 kPa and 37°C flows upward through a 6-cm-diameter inclined duct at a rate of Q (L/s).…

A: Answer To determine the differential height between the fluid levels of the two arms of the…

Q: An open cylindrical tank is two-thirds filled with water. If the tank is 60 cm in diameter and 90 cm…

Q: Water in pressurized cylindrical tank 40 ft. in diameter discharges into the atmosphere through a…

A: D = 40 ftd = 4 in or 0.333 ft H1 = 50 ftH2 = 2 ft

Q: 4. A vertical semi-circular area of radius r is submerged in a liquid with its diameter in the…

A: It is given that a vertical semi-circular area of radius r is submerged in a liquid with its…

Q: Q- An orifice is located in the side of a tank with its centre 10 cm above the base of the tank. The…

A: Given- Height of orifice h=10 cm=0.10 m, Water level height H=1 m, Coefficient of velocity C=0.98,…

Q: The jet hits the point surface that is 12 meters. Pressure = 49.05 kPa Cv = 0.97 What is the…

Q: Water flows through a horizont and a length of 100 m. The pres

Q: Q2:B) Calculate the power required to pull (1.5m x 1.5m) flat plate at speed (1 m/s) to the left…

Q: Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe…

A: Specific gravity of oil in pipe A (S1) = 0.9Specific gravity of oil in pipe B S2 = 1.2Difference in…

Q: Water flows through an orifice at the vertical side of a closed cylindrical tank. The water level…

Q: 2) ELEVATION 20oM ELEVATION 30m AIR Po? 150mmøØ SG 0-84 il flows from a tank through a 150mm…

Q: ne tank is filled with liquid with 1.0 specifi- d has a hole at point A. Inside the tank, a lloon…

A: According to given data The tank is filled with liquid with 1.0 specific gravity and has a hole at…

Q: A pressure gage at elevation of 12m at the side of the tank containing liquid reads 100 kPa. Another…

Q: Inclined Plane Surfaces Pressurized by Liquids 4-37. Find the resultant pressure force and its point…

A: Draw the triangular pressure diagram by calculating the pressure at the bottom of the dam. Then…

Q: 9. The total pressure or pressure intensity is zero for any point on inclined surface in space. a)…

Q: Q-9 A horizontal nozzle of 30 mm diameter discharges a steady jet of water into the atmosphere at a…

A: Given data- Diameter of the nozzle d=30 mm=0.03 m, Discharge Q=15 litres/s, Q=15×10-3 m3/s The…

Q: A closed cylindrical tank 1.89m high and 0.99m in diameter contains water of height 1.35m. When the…

A: We know that y=ω2r22gy=2020.992229.81y=4.9954my'=4.9954m-1.35m=3.6454m

Q: A jet of water strikes with a velocity of 26.36 m/s on a flat plate, inclined at 30o with the axis…

A: Velocity v= 26.36m/s Diameter of nozzle =291mm

Q: Find the location in millimeters of the center of pressure, measured from the liquid surface.

Q: A channel of rectangular section, 9ft wide, is discharging water at a rate of 71034gal/min with an…

A: "Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at…

Q: Q1. A rectangular water tank of length 10m and width 6m has a free surface 15m above a 300mm…

A: Given data Cross sectional area Length Diameter Coefficient of discharge

Q: A pump draws water from a 20 cm diam suction pipe and discharges through a 15 cm diam pipe in which…

A: Given,

Q: 10.8 For laminar flow in a tube calculate the position of the average cross-sectional velocity.…

A: Step 1

Q: A water tank has a sloping side inclined at 45° with the horizontal. The total depth of water in the…

A: Given :

Q: 13. For gage pressure at A of -10.89 kPa, find the specific gravity of the gage liquid B. 3.200 m…

Q: i) Which of the following statements about a straight horizontal pipe of 6 inch diameter pressurized…

A: This question is related to the Fluid Mechanics from Civil Engineering. This is mcq type question.

Q: horizontal pipe is diverted upwards with an angle of 25 degrees. Water enters with a velocity of 4.5…

Q: t two points 1 and 2 in a pipeline the velocities re Vand 2V, respectively. Both the points are at e…

A: To find the pressure difference (P1 - P2) -

Q: Figure Q1 (a) shows the tank attached with piezometer tubes. The pressure gauge A is 2.3 kPa. The…

Q: The pressure in the air space above the surface of oil (SG = 0.78) in a closed tank is 125 KPa…

A: As Pabs = PGAGE + PATM SO, PGAGE = 125 - 101.325 = 23.675KPa

Q: Determine the difference of pressure between points A and B in kPa. a 3.3m b 2.4m C 4.3m 2.3m 3.3m…

Q: A channel of rectangular section, 9ft wide, is discharging water at a rate of 71034gal/min with an…

A: NOTE - Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…

Q: Problem 2. Reynolds Transport Theorem. kir with a density of 0.0644 Ib.-m./cu. ft is flowing upward…

A: We knowP1-P2γm=ΔhP1-P2=Δhγmso,v1A1=v2A2v2=2v1v1=80ftsV2=160fts

Q: An open cylindrical tank with a diameter of 37cm and 90cm high is partially filled with water. At…

Q: urrent Attempt in Progress A 1-m³ volume of water is contained in a rigid container. Estimate the…

Q: A nozzle of inner radius 1.06 mm is connected to a hose of inner radius 9.05 mm. The nozzle shoots…

Q: A large tank partially filled with water the air space above being under pressure. A 0.05 m hose…

Q: Water is pumped up from a reservoir to a smaller holding tank. If the flow rate through the pipe is…

A: NPSH is the net positive suction head, which is measured in the centrifugal pump.If the local…

Q: A closed cylindrical tank 1.845m high and 0.945m in diameter contains water of height 1.35m. When…

Concept explainers

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.

Question

3,) A closed cylindrical tank,
1.5m in diameter and 3m high
contains 2m of water with the air
space having a pressure of
150kPa. When the angular
velocity is 90rpm, find the
pressure at the bottom of the
tank at the outer perimeter.

72
1m
TA
Afr
A
A Y2
2m
Уз
D
士
1.5m-
0.75 0.75
Redi

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Given

VIEW

Step 2 Soution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

How can I find the solution for the pressure at point B only? (answer is given)
ire hose has 100 mm diameter which reduces to a 20 mm nozzle discharging at 10+X m/s. (X= 16)Calculate the following: a) How high the water can reach if the nozzle is aimed vertically? b) What is the pressure inside the hose? c) How much extra force will be created at the reducer due to velocity change?
Hydraulics problem
5-9 A 0.75-m³ rigid tank initially contains air whose den- sity is 1.18 kg/m³. The tank is connected to a high-pressure supply line through a valve. The valve is opened, and air is allowed to enter the tank until the density in the tank rises to 4.95 kg/m³. Determine the mass of air that has entered the tank. 2.83
3. Medium lubricating oil (sg=0.85) is pumped through 360m of horizontal 75mm pipe at the rate of 3.14L/S. If the drop in pressure is 300kPa. Compute for the absolute viscosity in Ns/m2 of the oil. a. 0.311 b. 0.206 c. 0.504 d. 0.790
m2
Q6
The flow is opened to the atmosphere at point D which is fed by a very wide reservoir that has a water surface elevation of (5+) meters as shown in the figure given below. Elevation of the horizontal axis BC is 1 meter. At sections AB the diameter of the pipe is (0.2+- meters and CD the diameter of the 100 pipe is (0.3+: meters. The flow is ideal (inviscid) and absolute atmosphere pressure is 9.81 N/cm?. Considering the pipe's diameter is (0.15+; m at section BC, find the discharges and the 100 а. velocities of the flow at other sections (AE, EB, BC, CF, FD). Draw the energy and hydraulic grade lines of the system. b. Assuming the system discharge is constant and has the value you have found in (a), calculate the minimum pipe diameter that the section BC can take and draw the energy and hydraulic grade lines of this situation. Note: Absolute vapor pressure of water is 2.26 kN/m?. 10 A E 2.5 D B m
3-160 A 5-m-long, 4-m-high tank contains 2.5-m-deep water when not in motion and is open to the atmosphere through a vent in the middle. The tank is now accelerated to the right on a level surface at 2 m/s2. Determine the maxi- mum pressure in the tank relative to the atmospheric pressure. Answer: 29.5 kPa 1.5 m 2.5 m Vent Water tank FIGURE P3-160 5 m 2 m/s2
An open tank with piezometers attached on the side contains two different liquids.Determine the elevation of the liquid in piezometer Achoices are:A. 2.2mB. 2mC. 2.4mD. 2.1m Find the pressure at the bottom of the tankchoices are: A. 18.59 Kpa B. 18.85 kPa C. 19.85 kPa D. 18.95 kPa Find the elevation of the liquid in piezometer Bchoices are: A. 0.918m B. 0.819m C. 0.189m D. 0.889m
Water flows through a pipe at 150 L/s that changes gradually in diameter from 165 mm at point A to 473 mm 4.3 m higher than at point A and B are at point respective pressures 49.8 kPa. В. В is point A. The 72 КРа and Determine the head loss of the pipe. а. b. Determine the total energy at point B with datum at point A. Determine the total energy at point A with datum at C. point A.
Homework 14 |A cylindrical vessel closed at the top and bo om is 300mm inn diameter, 1m long and contains water up to a depth of 0.8m. The air above the water surface is at a pressure of 60 KPa. If the vessel is rotated at a speed of 250n rpm about its ver cal axis, nd the pressure head at the bo om of the vessel at the center point and at the edge.