Answer number 28.write your solution pls 16. Find the value of impedance which absorbs a complex power of 2300 VA with a 30degrees angle at 115 V rms.17. A series RLC circuit has R = 100, L = 40 × 10-6H and C = 60 × 10-12F. What is theresonant of the circuit in MHz?18. A series circuit consists of a 120-ohm resistance, a 150 mH inductance and an unknowncapacitance. The circuit is supplied with a voltage V = 100 sin377t. Find the value ofthe capacitance at resonance.19. A parallel RLC circuit has a resonant frequency of 20, 000 rad/sec. If L is equal to 100mH, find the value of C?20. A tuned circuit is resonant at 400 kHz. Its Q is 100. What is its bandwidth?21. A current of 2.5 A flows through a series circuit consisting of a 100 N resistor and anunknown capacitor across a source of 460 V, 50 Hz. What is the value of the capacitivereactance?22. A circuit consists of a 4 N resistor and 300 µF capacitor in series. It is connected acrossa 60 Hz voltage source with a 500 V peak voltage. What is the phasor form of thecurrent?23. The voltage across a given circuit is 15 + j10 V. What is the power supplied to thedrcuit if the current through it is (18 – j5)A?24. The following are in series R = 2, 000 N, L = 600 µH and C= 80, 000 pF. The voltageacross the circuit is 200 V. What is the total impedance expressed in ohms if thefrequency is 100 kHz?25. The maximum instantaneous voltage and current output of an alternator are 300 V and20 A, respectively. What is the power output in watts if the voltage leads the current by30°.26. A two-element series circuit with R = 15 N, L = 20 mH has an impedance of 30 ohmsand an unknown angle. What is the frequency in Hz?27. A 15mH pure inductance is connected in parallel with one microfarad capacitor and a1kohm resistor. What frequency will the circuit be in resonance?28. A 10 ohm resistor is connected in parallel to an impedance Z = 20 – j4 ohms. Find thecircuit power factor?29. The resistor of 100 ohms and unknown impedance coil in series draw 12 A from a 120v, 60 Hz line. If the reactive power taken from the line is 1152 vars, what is the coilinductance?30. A parallel circuit consists of a resistor having a conductance of 14 mhos, an inductivereactor having a susceptance of 8.8 mhos and a capacitive reactor having a susceptanceof 15 mhos. What is the impedance of the circuit?

Answered: Image /qna-images/answer/2cacf87c-94cf-45d1-9f77-b61dafccc133.jpg

25. The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A, respectively. What is the power output in watts if the voltage leads the current by 30°. 26. A two-element series circuit with R = 15 N, L = 20 mH has an impedance of 30 ohms and an unknown angle. What is the frequency in Hz? 27. A 15mH pure inductance is connected in parallel with one microfarad capacitor and a 1kohm resistor. What frequency will the circuit be in resonance? 28. A 10 ohm resistor is connected in parallel to an impedance Z = 20 - j4 ohms. Find the circuit power factor? 29. The resistor of 100 ohms and unknown impedance coil in series draw 12 A from a 120 V, 60 Hz line. If the reactive power taken from the line is 1152 vars, what is the coil inductance? 30. A parallel circuit consists of a resistor having a conductance of 14 mhos, an inductive reactor having a susceptance of 8.8 mhos and a capacitive reactor having a susceptance of 15 mhos. What is the impedance of the circuit?

25. The maximum instantaneous voltage and current output of an alternator are 300 V and 20 A, respectively. What is the power output in watts if the voltage leads the current by 30°. 26. A two-element series circuit with R = 15 N, L = 20 mH has an impedance of 30 ohms and an unknown angle. What is the frequency in Hz? 27. A 15mH pure inductance is connected in parallel with one microfarad capacitor and a 1kohm resistor. What frequency will the circuit be in resonance? 28. A 10 ohm resistor is connected in parallel to an impedance Z = 20 - j4 ohms. Find the circuit power factor? 29. The resistor of 100 ohms and unknown impedance coil in series draw 12 A from a 120 V, 60 Hz line. If the reactive power taken from the line is 1152 vars, what is the coil inductance? 30. A parallel circuit consists of a resistor having a conductance of 14 mhos, an inductive reactor having a susceptance of 8.8 mhos and a capacitive reactor having a susceptance of 15 mhos. What is the impedance of the circuit?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

QUESTION 1 (a) Table Q1(a) is given. Calculate the precision of the 9th measurement. The actual value for 9th resistor is 2000 Q. Calculate the absolute error, percentage error and percentage els come t what accuracy for 9ª measurement. Table Q1(a) Resistor Measurement (N) 1 2002 2010 3 1987 +6d 72 4 2007 5 1999 for pary mot work 6. 1993 17209 7 1997 8. 2008 2010 10 2001 11 1995 12 1991 (b) A DC source is connected in series with a resistor. A ±1% full scale accuracy voltmeter with range of 150 V and ±1.5% full scale accuracy ammeter with range of 100 mA ammeter are used to measure voltage and current in a circuit. The voltmeter and ammeter reading is 80 V and 70 mA respectively. Calculate the limiting error of the power. Determine the power dissipated and the absolute error.
Briefly discuss the 10 electrical hazards in the laboratory and give the corresponding preventive and corrective measures
Q3) The self capacitance of each unit in a string of four suspension insulators is C. The shunting capacitance of the connecting metal work of each insulator to earth is 0-2 C. Calculate (i) the voltage across each insulator and (ii) string efficiency.
ENGINEERING UTILITIES (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATION NEEDED. ANSWER IN 3 DECIMAL PLACES. BOX THE FINAL ANSWER.)
please give me details. indicate the ranges in the answer.
O pA:YY 40 docs.google.com/forms/d/e, Q1: Choose the correct answer for the following: 3- For a (1 k2) copper composition resistor with a temperature coefficient at (20°C) 0.00393, determine the resistance at (80°C) ? * 1.24 Q O 1.42 Q 1.44 Q This is a required question 7-What is the relative increase or decrease in conductivity of a conductor if the area is increasing by (30%) and the length is decreasing by (40%) ? The resistivity is fixed. * G2 =2.1667 G1
Match The following. Energy derived from organic waste Choose. Energy from interior of earth Choose.
QUESTION 1 In the circuit shown, determine the following: a.) The terminal voltage of battery E6 is b (a) 22 (b) 21 (c.) 17 (d) 18 (e) 19 b.) The potential difference, Vge is c V. (a) – 22 (b) 22 (c) - 2 (d) 2 (e) 12 c.) The terminal voltage of battery, E5 is d V (a) 8 (b) 7 (c) 6 (d) 18 (e) 12 d.) The potential difference, Vce is b V. (a) 16 (b) 12 (c) 10 (d) 8 (e) 18 e.) The potential difference, Vdg is e V. (a) 8 (b) – 12 (c) - 8 (d) - 10 (e) 10 a b C 20 E1= 6v, 0.50 E2= 11v, 0.50 E3= 7v, 0.52 = E6= 20v, 0.52 E5= 7v, 0.50 E4= 19v, 0.50 f 20
1. Solve the following resistance problems: a. A 4.2 cm long copper wire has a cross-sectional area of 3.7 mm?. Determine the resistance of that wire. Check the resistivity of Copper int the table given in the textbook. b. Consider a 1.6 cm long silver wire. What is the cross-sectional area of the wire for it to have a resistance of 2.2 x 102 0.
Determine the voltage across resistor R₂, given: R₁ = 58 Q, R₂ = 91 Q, and I₁ = 4.8 A (Round the FINAL answer to one decimal place.) E₁ Click on the image to view a larger version of it.
A. Find a11. Express your answer using three significant figures. B. Find a12 . Express your answer using three significant figures and include the appropriate units C. Find a21 . Express your answer using three significant figures and include the appropriate units D. Find a22 . Express your answer using three significant figures and include the appropriate units
D Question 8 1. AK-type thermocouple as shown in the figure below generates a voltage that is proportional to temperature. Typically, the slope of the voltage vs. temperature line is about 41μV/C (micro-volts per degrees Celsius). Assume that the thermocouple is directly connected to a 20-bit ADC that has a range of 0-5 volts D.C. (You'll find out next week we don't do it this way, and that makes for a reason to come back to class.) Calculate the smallest change in temperature that results in a change of on bit of the ADC. About 3 degrees Celcius O About 1 degree Celcius About 20 degrees Celcius About 0.1 degrees Celcius