25. Sketch the NRZ, NRZI, Manchester, and Differential Machester encoding for 000111010 on the following guide table. Assume that the NRZI signal starts out voltage and the last level signal was high level before this stream in differential (Use a similar quide table as following in your answer sheets)

Q: Data communication Suppose that the spectrum of a channel is between 8 MHz and 10 MHz, and the…

A: In the realm of data communication, the efficient utilization of available bandwidth is crucial to…

Q: The multiplexing of frequencies and timestamps should be treated independently (According to…

A: Modern communication networks use multiplexing as a basic idea because it permits simultaneous…

Q: How are signal collisions prevented when many systems use the same communication channels?

A: Let's discuss about the signal collisions before knowing prevention of it. Signal collisions…

Q: This type of data transmission allows data to be sent in both directions on the same signal carrier…

A: Introduction: This type of data transmission is known as "full-duplex" because it allows data to be…

Q: The data rate (in each direction) necessary for a digitized telephone call is 8 Kbps. This means…

A: Given, A full duplex call requires 16 kbps data rate. Data rate necessary to transport just one HDTV…

Q: a. Assume your university library has a million books. Calculate the number of bytes of data if all…

A: a. With regards to the aforementioned issue, it has previously been stated that the campus library…

Q: How do serialization techniques factor in redundancy and error correction for data transmission in…

A: - We need to talk about how serialization techniques factor in redundancy and error correction for…

Q: what conditions can serial data transfers be faster than parallel data transfers? (Our subject is…

A: Given Under what conditions can serial data transfers be faster than parallel data transfers? (Our…

Q: 1) Communication between network hubs takes place in a) Full-duplex mode b) The method of…

A: Introduction: 1) Communication between network hubs takes place in a) Full-duplex mode b) The method…

Q: How does "fiber optic multiplexing" improve the capacity and efficiency of optical fiber…

A: Fiber optic multiplexing plays a role in optical fiber communication, making it more efficient and…

Q: Block coding ensures synchronization and error detection by providing redundancy. Why?

A: Block coding aids in mistake identification and signal re-transmission. It is known as mB/nB coding…

Q: How does CRC(Cyclic Redundancy Check) detect errors in transmitted data?

A: Cyclic Redundancy Check (CRC) is a method used to detect errors in transmitted data by adding a…

Q: Assume there are one million books in your campus library. Approximate (to the nearest order of…

A: a. With the given problem, it is already mentioned that there are one million books in the campus…

Q: How many 8-bit characters can be transmitted per second over a 9600 baud serial communication link…

A: Introduction :Given ,Async. Mode of transmissionSize of char = 8 bits 9600 baud serial communication…

Q: How does multiplexing improve the efficiency of data transmission over communication

A: Multiplexing works on the proficiency of data transmission over correspondence channels by…

Q: The reason for the varying duration between bytes in asynchronous transmission.

A: What alters the byte gap time during asynchronous transmission? Data is delivered in the form of…

Q: 2. Define another characteristic of Data Communication  3. Give an advantage of half duplex over…

A: Question 2: Characteristics of Data Communication are: Delivery: Main task of data communication is…

Q: What is "Shannon's Capacity Theorem," and how does it relate to the maximum data rate of a…

A: "Shannon's Capacity Theorem," formulated by Claude Shannon in 1948, establishes the maximum…

Q: As a Network Engineer, assume that you are given 9 input-lines that carry digital inputs, and the…

A: Given: As a Network Engineer, assume that you are given 9 input-lines that carry digital inputs, and…

Q: What are the two main synchronization problems that can occur during message transmission? (max of 3…

A: Synchronization problems during message transmission occur when sender and receiver are not properly…

Q: Explain the concept of latency and its different components (e.g., propagation delay, processing…

A: Data transmission is the process of sending data in form of signals from one device to another…

Q: CRC code

A: Given :- In the above question, the code is 1101 and the information word is 11001101 mention in…

Q: Explain the difference between transmission delay and throughput.

A: Below are the differences between Transmission delay and Throughput.

Q: Error detection, handling and correction are very important in any form of data  transmission. With…

A: The error could be a situation where data is shipped by the sender and received by the recipient,…

Q: Network and Communication question Provide Single parity and double parity check implementation

A: By adding up the bits on the surviving drives, the RAID group can figure out what was on the failed…

Q: If DS = 7EA2H and the offset is 438EH, %3D

A: a) The Physical address is 7FA20+438E= 83DAE b) The lower range 7FA20+0000=7FA20

Q: ce of signals used in the Serial Peripheral Interface (SPI)

A:

Q: List the best common data communication protocols from hardware point of view and why are they so…

A: Layered network protocolsNetwork communication relies upon the interaction of many different…

Q: What is the degree of modulation required to establish a desirable AM communication link?

A: Thedegree of modulation is characterized as the proportion of certain amplitude amounts, an…

Q: What differentiates synchronous and asynchronous communication

A: The primary differentiation between these two communication styles is that asynchronous…

Q: How does signal attenuation affect data transmission over long-distance communication channels?

A: Signal attenuation refers to the decrease, in signal strength as it travels through a long-distance…

Q: Exercise (3): The Bandwidth of a voice signal is 3000HZ, what is bit rate required to send this…

A: I have answered the question in step 2. bandwidth w = symbol rate= bit rate / divided by the number…

Q: Computer Science Suppose that you had more than 4GByte of data to send and could only afford one…

A: In data transmission, network throughput is the amount of data moved successfully from one place to…

Q: A 8 bit data block with 1 start bit, 2 stop bit, and 1 parity bit using an asynchronous mode of…

A: In data communication systems, the transmission of information relies on various protocols and…

Q: How do microcontrollers ensure robust error-checking in communication protocols like CAN and I2C?

A: In communication protocols like the Controller Area Network (CAN) and Inter-Integrated Circuit…

Q: How does multiplexing contribute to efficient data transmission over a shared medium?

A: In order to transfer several data streams via shared communication means efficiently, multiplexing…

Q: This kind of data transmission allows for simultaneous data flow in both directions on a signal…

A: Introduction: Because "full-duplex" data transmission allows data to be delivered in both directions…

Q: Explain the concept of optical amplification and its significance in long-distance optical fiber…

A: Optical amplification is a fundamental technology in optical fiber communication that plays a…

Q: Could you kindly provide a more detailed description of each of the four components of the IEEE…

A: IEEE 802.11 is a wireless networking standard that consists of four components:PHY…