1. In a parallel communication, each bit requires a transmitter and receiver. a) True b) False 2. What is the cable that carries the information in parallel transmission called? a) Parallel line b) Data bus c) Data line d) Data link

Q: Why does the time between bytes change during asynchronous transmission?

A: Answer: The amount of time that passes between each byte in an asynchronous transmission might vary.…

Q: Why does the time between bytes change during asynchronous transmission?

A: Given: What factors contribute to the variation in the amount of time that elapses between each byte…

Q: This type of data transmission allows data to be sent in both directions on the same signal carrier…

A: Introduction: This type of data transmission is known as "full-duplex" because it allows data to be…

Q: Why does the time between bytes change during asynchronous transmission?

A: Introduction:   Because Transmission is asynchronous, the time interval between bytes is "variable."

Q: Describe the factors (metrics) that are used to assess the performance of the below-mentioned…

A: a) Unipolar signaling : - In unipolar signalling, all the signal levels are either above or below x…

Q: The transmission of data makes use of both periodic analogue signals and non-periodic digital…

A: The transmission of data involves the utilization of both periodic analog signals and non-periodic…

Q: This kind of data transmission allows data to be transmitted in both directions on a signal carrier…

A: Transmission mode implies moving of information between two gadgets. It is otherwise called…

Q: The transmission of data makes use of both periodic analog signals and non-periodic digital signals;…

A: The explanation is provided in the section that follows.

Q: ith a bit rate of 250 kbps and four with a bit rate of 500 kbps are to be combined using…

A: a) we can allocate eight 250kbps sources into 4 500 kbps sources . Therefore 8 total 500 kbps…

Q: es the time between bytes change during asynchronous trans

A: Introduction: Because the sender and receiver share a common clock, synchronous transmission is…

Q: Is there a reason why the duration between bytes in asynchronous transmission varies?

A: Asynchronous transmission varies: Additional bits, referred to as the  start and stop bits, are…

Q: What causes the difference in the amount of time that passes between each byte during asynchronous…

A: Please find the detailed answer in the following steps.

Q: 1. each call allocated periodie slot(s), can transmit at maximum rate of (wider) frequency band…

A: Time Division Multiplexing It is a method of transmitting and receiving independent signals over a…

Types Of Protocols

A network protocol is a collection of rules that governs the exchange of data between devices connected to the same network. In other words, network protocols are rules that specify how devices communicate or transfer data over a network. The sender and receiver systems must obey the standards to facilitate communication between them.