23.a. What type of squirrel-cage motor is ordinarily used with small air compressors equipped with a relief valve? A. Design B motor B. Design C motor C. Design A motor D. Design D motor 23.b. The most economical voltage for a 150-hp a-c motor is A. 440 volts. B. 800 volts. C. 600 volts.

23.a. What type of squirrel-cage motor is ordinarily used with small air compressors equipped with a relief valve? A. Design B motor B. Design C motor C. Design A motor D. Design D motor 23.b. The most economical voltage for a 150-hp a-c motor is A. 440 volts. B. 800 volts. C. 600 volts.

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter43: About Dc Motors

Section: Chapter Questions

Problem 1SQ

See similar textbooks

Related questions

Q: A 50-h.p. (37.3 kW), 460-V d.c. shunt motor running light takes a current of 4 A and runs at a speed…

Q: 200 V D.C. series motor runs at 500 r.p.m when taking a current of 25 A. The resistance of the…

Q: 22.a. One common type of electronic circuit component that is used to control the voltage and…

A: Select the correct option: 22.a. One common type of electronic circuit component that is used to…

Q: Find the number of resistance sections and the resistance of each section of a starter for a 3.7 kW,…

Q: The armature and shunt field resistance of a 600 V shunt motor are 1.5 ohm and 600 ohms…

Q: -. Calculate the speed of the motor when it draws 25 A rom the source.

Q: A 230 V D.C. shunt motor takes 32 A at full load. The back e.m.f. on full load, if the resistance of…

Q: 4.a. The device which responds to the heat developed within the motor is the A. shading coil. B.…

A: Bimetallic protector(strip) is a device which bends when temperature inside it increases beyond a…

Q: ) The time delay fuse using the strict standard rating for 2Ø, 230 V, 7.5 hp SCIM motor is A. 25 A…

A: We need to find out current rating of fuse for given power and voltage .

Q: 4. A 50 HP, 550V shunt wound motor draws a line current of 4.5 ampere at no load. The shunt field…

Q: DC/AC MOTOR (UPVOTE WILL BE GIVEN. PLEASE WRITE THE COMPLETE SOLUTIONS LEGIBLY. NO LONG EXPLANATIONS…

A: The detailed solution is provided below.

Q: A 55 hp, 440 V, 400 rpm DC shunt motor draws 107 A when operating at rated conditions. The motor has…

Q: A certain shunt motor armature has a resistance of 0.07 2 and current of 50 Amperes at 120 Volts.…

Q: Write the solution neatly. A 230 V d.c. shunt motor, having an armature resistance of 0.05 ohm and a…

A: According to the question we have to find the value of efficiency.

Q: 55 hp, 440 V, 400 rpm DC shunt motor draws 107 A when operating at rated conditions. The motor has…

A: In this question we will draw diagram of dc shunt motor showing all resistance,currents and…

Q: Q1/ A 380 volts 4 pole 60 Hz three phase star connected induction motor has r,=0, X1=X2=1 N,…

A: The three-phase induction motor is rated at 380V 4 pole 60Hz has fed from the 220V constant voltage…

Q: Please Must Show Given Questions in Design for 11KW Motor . A15 kW, 440 V, 4-pole, 50 Hz, 3-phase…

A: I have written this solution as handwritten solution. Hope you find your solution clearly.

Q: What value of resistance should be inserted in the armature circuit of a 200 V, 1000 r.p.m., shunt…

Q: 1. Describe the constructional features and characteristics, of a induction motor that would be used…

A: According to guidelines we need to solve only the first question. According to the question,…

Q: A three-terminal manual starting rheostat has a resistance of 5.2 ohms in its starting resistor.…

A: Here we discuss the concepts related to the DC shunt motor 3-point starter.

Q: 12. A single-phase, 120 V, 60 Hz, 1/2 hp, 1740 rpm split-phase fan motor gave the following test…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: A 50-h.p. (37.3 kW), 460-V d.c. shunt motor running light takes a current of 4 A and runs at a speed…

A: dc shunt motor output power = 37.3kW output current for light load = 4 A and runs at a speed of 660…

Q: A 4-pole, 500 V d.c. shunt motor has 720 wave-connected conductors on its armature. The full-load…

A: We are authorized to answer one question at a time since you have not mentioned which question you…

Q: Final (a) b) 41 (1) ADC shunt motor is rated 10HP, 250V and is connected to 235V source. The…

A: Given data, Rated power 10 HP. Terminal voltage V = 235 V. Armature resistance Ra=0.2 Ω. Field…

Q: A shunt wound de motor has an armature resistance of 2.52 and a shunt field resistance of 1602. The…

A: given de shunt motor

Q: A 230 V D.C. shunt motor takes 32 A at full load. The back e.m.f. on full load, if the resistance of…

A: The solution can be achieved as follows.

Q: What are the following statements are true for DC Motor? I. Motor converts Electrical Energy to…

A: Choose best option What are the following statements are true for DC Motor? I. Motor converts…

Q: 6.a. When you're taking a PM motor apart you should exercise special care not to damage the A. end…

Q: One type of failure that's more common with 200 HP motors than with 10 HP motors is A. rotor bar…

Q: determine "A" through "G" for the DC motor on worksheet 5 when it is running at capacity and its…

A: DC shunt generator Vt=125V IL=16amp Shunt winding current (If) =Vt/Rf If=125/50 If=2.5 amp

Question

100%

23.a. What type of squirrel-cage motor is ordinarily used with small air compressors equipped with a relief
valve?
A. Design B motor
B. Design C motor
C. Design A motor
D. Design D motor
23.b. The most economical voltage for a 150-hp a-c motor is
A. 440 volts.
B. 800 volts.
C. 600 volts.
D. 220 volts.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

A 120 volts shunt motor has an armature resistance of 0.08 ohm and filed resistance of 60 ohms. What current is drawn when its back emf is 114.8 volts?
A three-terminal manual starting rheostat has a resistance of 5.2 ohms in its starting resistor. The holding coil resistance is 10 ohms. This starting rheostat is connected to a shunt motor. The resistance of the armature is 0.22 ohm; the resistance of the shunt field is 100 ohms. The line voltage is 220VDC. a. What is the starting surge current taken by the motor? b. What is the current in the holding coil with the moveablew arm in the run position? c. What is the CEMF with the movable arm in the on position if the armature current is 20 amps?
A 55 hp, 440 V, 400 rpm DC shunt motor draws 107 A when operating at rated conditions. The motor has an armature-circuit resistance of 100 mW and a total field-circuit resistance of 55 W. Draw a schematic of the motor in the space below showing all known quantities (resistances, currents, voltages and load). Show only symbols for unknowns.
AM EPT
Solve properly. thanks
Final 1A DC shunt motor is rated 10HP, 250V and is connected to 235V source. The armature resistance is 0.2 ohm, the field circuit resistance is 125 ohm and the total rotational losses are 380W. The motor is driving a load, and it draws an armature current of 30A, Calculate the output power. b) 41 d) 6490 6870 7492 7460 Boş birak
A shunt wound de motor has an armature resistance of 2.52 and a shunt field resistance of 1602. The terminal voltage is 120 volts and the line current is 8 Amperes. Back emf is developed in the armature when the motor is running considering only the copper loss. Calculate the efficiency of the motor. a. 76.937% b. 80.937% c. 84.896% d. 90.625%
Please answer all subparts please answer in typing format
Answer please in 10 minutes
What value of resistance should be inserted in the armature circuit of a 200 V, 1000r.p.m., shunt motor to reduced its speed to 800 r.p.m. When drawing 20 A. Armatureresistance is 0.5. (Ans.1.9 ohm)
22.a. One common type of electronic circuit component that is used to control the voltage and current to aDC motor is theA. silicon-controlled rectifier.B. resistor.C. capacitor.D. diode.22.b. Which one of the following types of motors can be powered with either AC or DC electricity?A. Servo motorB. Pancake motorC. Universal motorD. Shunt-wound motor
Choose the best