23. Consider a datagram network using 8-bit host addresses. Suppose a router uses longest prefix matching and has the following forwarding table: Prefix Match 00 01 100 otherwise Interface 0 1 2 3 For each of the four interfaces, give the associated range of destination host addresses and the number of addresses in the range.

23. Consider a datagram network using 8-bit host addresses. Suppose a router uses longest prefix matching and has the following forwarding table: Prefix Match 00 01 100 otherwise Interface 0 1 2 3 For each of the four interfaces, give the associated range of destination host addresses and the number of addresses in the range.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: 1.4-6 Maximum end-end throughput (e). Consider the scenario below where 4 TCP senders are connected…

A: Given data : R = 1Gbps Rc = 300 Mbps Rs = 200 Mbps

Q: Consider a datagram network using 8-bit host addresses. Suppose a router uses longest prefix…

A: We need to find the range of addresses for the given scenario. First 3 interfaces are considered.…

Q: Consider a router that interconnects three subnets: Subnet 1, Subnet 2 and Subnet 3. Suppose all…

A: Given Prefix 223.1.17/24. Subnet 1 is required to support up to 100 interfaces…

Q: 1.4-6 Maximum end-end throughput (e). Consider the scenario below where 4 TCP senders are connected…

A: The amount of data that is transferred from source to destination in a predetermined amount of time…

Q: Consider delivering voice through a direct connection network from Host A to Host B. (for example,…

Q: Explain the significance of "split horizon" in routing protocols.

A: In order to avoid routing loops and increase the stability and effectiveness of routing in computer…

Q: 2. The following illustration shows a transmission from Host A to Host B using Network Address…

A: Router is a network device which works at network layer and it is used to connect two networks or…

Q: (b) The Internet Protocol (IP) can sometimes surprise with its flexibility. Since the overall design…

A: Since you are not given the distance between transmission points and data speed, it cannot calculate…

Q: Suppose you are using TCP over a 10-Mbps (10 × 2^ 20 bps) link with a latency 100 ms (RTT 200 ms) to…

A: (a) How many RTTs does it take until slow start opens the send window to 10MB? Solution: =>…

Q: You are hired to design a reliable byte-stream protocol that uses a sliding window (like TCP). This…

A: You are hired to design a reliable byte-stream protocol that uses a sliding window (like TCP). This…

Q: (a) The transmission time of a bit or group of bits is sometimes referred to as their "width" on the…

A: Dear student, As per our guidelines, you have uploaded multiple questions. Experts are only allowed…

Q: assume the data from application has been broken into datagram size of 420 bytes by TCP at sender…

A: 1) In the TCP (Transmission Control Protocol) communication protocol, sequence numbers and…

Q: Use this figure as a reference, if the values are A, B, C and D (3rd octet) with the following…

A: Answer A*************** Specify routing table R1, R2, and R3, using this table! Destination…

Q: Consider a TCP connection with the following parameters: a) Initial ssthreshold = 4 segments b)…

A: Q1 Answer:- We have the given data: Initial ssthreshold = 4 segments Round Trip Time (RTT) = 10…

Q: SUBNET ADDRESSING Consider the router and the two attached subnets below (A and B). The number of…

A: A routеr connеcts two subnеts, A and B. Subnеt A has 175 hosts, subnеt B has 84 hosts, and both…

Q: Consider that only a single TCP (Reno) connection uses one 10Mbps link which does not buffer any…

A: A The maximum window size that this TCP connection can achieve is 10 segments. BThe average window…

Q: - Stations in a slotted Aloha network send frames of size 2000 bits at the rate of 1 Mbps. What is…

A: Approach to solving the question: Let's address your questions one by one: 1. Vulnerable Time in…

Question

23. Consider a datagram network using 8-bit
host addresses. Suppose a router uses longest
prefix matching and has the following
forwarding table:
Prefix Match
00
01
100
otherwise
Interface
0
1
2
3
For each of the four interfaces, give the
associated range of destination host addresses
and the number of addresses in the range.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Given Information:

VIEW

Step 2: Answers:

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

6. Consider a network with some hosts. The traffic from one host to the other is provided. The question is to find the total bytes that are moving in the network from one host to the other and also for all the routes. The total bytes that are transferred for the day is as below. peter ann 1250 peter mary 910 mark mary, 1250 peter mary 450 peter andy 2924 paul peter 1218 paul helen 199 The first name is the source host, the second is the destination host and the number is the bytes that are transferred.
Network & Data Communcations
Suppose we have switches S1 through S4; the forwarding-table destinations are the switches themselves. The tables for S2 and S3 are as below, where the next_hop value is specified in neighbor form: S2: ⟨S1,S1⟩ ⟨S3,S3⟩ ⟨S4,S3⟩ S3: ⟨S1,S2⟩ ⟨S2,S2⟩ ⟨S4,S4⟩ From the above we can conclude that S2 must be directly connected to both S1 and S3 as its table lists them as next_hops; similarly, S3 must be directly connected to S2 and S4. (a). The given tables are consistent with the network diagrammed in exercise 6.0. Are the tables also consistent with a network in which S1 and S4 are not directly connected? If so, give such a network; if not, explain why S1 and S4 must be connected. (b). Now suppose S3’s table is changed to the following. Find a network layout consistent with these tables in which S1 and S4 are not directly connected. Do not add additional switches. S3: ⟨S1,S4⟩ ⟨S2,S2⟩ ⟨S4,S4⟩ While the table for S4 is not given, you may assume that forwarding does work correctly.…
Consider a local area network (LAN) with multiple stations connected to the same bus using the Carrier Sense Multiple Access with Collision Detection (CSMA/CD) protocol for medium access control. Assume that each station has a packet to transmit and follows the CSMA/CD protocol to access the medium. The first station to sense the medium finds it idle and starts transmitting its packet. The second station also senses the medium as idle and starts transmitting its packet, but halfway through the transmission, it detects a collision with the first station’s packet. After detecting the collision, the second station follows the backoff and retransmission procedure specified by the CSMA/CD protocol. Assume that the backoff algorithm uses binary exponential backoff with a maximum number of retries of 10 and that the slot time is 512 bit times. (a) What is the minimum number of slots the second station must wait before attempting to retransmit its packet after detecting the collision? Show…
A router interconnects a subnet, where all the interfaces of the subnets must have the prefix 164.132.62/24. suppose that the Subnet is required to support up to 60 interfaces, provide a network address that satisfies the above.
1. Consider the network depicted in Figure 1. Here, we have a sender, a receiver, and four routers. In this figure, capital letters specify the physical addresses of the devices and numbers specify the logical addresses of the devices. For example, the device marked as sender has a physical address A and logical address 5. Sender B/20 C/35 D/40 A/5 E/50 Receiver F/60 J/95 I/90 H/82 G/70, Figure 1: Network topology Similarly, the router connected to the sender has physical address B and logical address 20 for the interface that is connected to the sender. Now, consider that process Pi of the sending computer wants to send some data to process P2 of the receiving computer. Port addresses of process Pi and P2 are Px and Py, respectively. Show the contents of the segments, packets and frames for transport, network, and data link layers at the sender side of three hops with appropriate figures.
In modern packet-switched networks, including the Internet, the source host segments long, application-layer messages (for example, an image or a music file) into smaller packets and sends the packets into the network. The receiver then reassembles the packets back into the original message. We refer to this process as message segmentation. Figure 1.27 illustrates the end-to-end transport of a message with and without message segmentation. Consider a message that is 8. 106 bits long that is to be sent from source to destination in Figure 1.27. Suppose each link in the figure is 2 Mbps. Ignore propagation, queuing, and processing delays. a. Consider sending the message from source to destination without message segmentation. How long does it take to move the message from the source host to the first packet switch? Keeping in mind that each switch uses store-and-forward packet switching, what is the total time to move the message from source host to destination host? b. Now suppose that…
Consider a TCP connection with the following parameters: a) Initial ssthreshold = 4 segmentsb) Round Trip Time (RTT) = 10 millisecondsc) Timeout period = 40 millisecondsd) Segment size = 3900 bytesThe TCP connection was used to transfer 17 data segments. While sendingthe segments, data segment 7 and data segment 15 were lost the first timethey were sent (but arrived at the receiver properly when retransmitted).There were no other segment losses apart from the aforementioned. Assumethat data segments received out-of-order are buffered at the receiver. Whatis the average throughput obtained in sending all the data segments (inbytes/sec) including draw a diagram to show the communication process in detail.
13. The following figures plot the timeline for sending TCP segments by host A and TCP ACKS by host B, where “seq #” is the value of the sequence number in the TCP header, and "ACK #” is the value of the acknowledge number in the TCP header. Assume that every segment always includes 500 bytes of data, excluding the TCP header. A seg #: 1000 seq #: 1500 seq #: 2000 seq #: 2500 (1) B ACK #: a ACK #: b ACK #: c ACK #: d A seq #: 1000 seq #: 1500 seq #: 2000 seq #: 2500 (2) B ACK #: r ACK #: s TACK 1) In Figure (1), the second ACK sent out by host B gets lost in the network. a) What are the acknowledge numbers a, b, c, and d? b) Will sender A think the segment with seq#=1500 was lost because it never receives the acknowledgement from B containing ACK# = b? 2) In Figure (2), the second TCP segment from host A to host B gets delayed in the network but later arrives at B. What should be the value for the ACK number r, s and t?
Consider a router that interconnects three subnets: Subnet 1, Subnet 2, and Subnet 3. Suppose all of the interfaces in each of these three subnets are required to have the prefix 223.10.128/24. Also suppose that Subnet 1 is required to support at least 50 interfaces, Subnet 2 is to support at least 100 interfaces, and Subnet 3 is to support at least 12 interfaces. Provide three network addresses (of the form a.b.c.d/x) that satisfy these constraints.