21. When the system is not at equilibrium, the reaction quotient Q for any reaction (A) will indicate if more reactants or products will be made. (B) will go up or down as determined by the equilibrium constant (C) will change over time until it is equal to the equilibrium constant. (D) will depend on the reaction stoichiometry. (E) All of the above.

21. When the system is not at equilibrium, the reaction quotient Q for any reaction (A) will indicate if more reactants or products will be made. (B) will go up or down as determined by the equilibrium constant (C) will change over time until it is equal to the equilibrium constant. (D) will depend on the reaction stoichiometry. (E) All of the above.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

1. When solid magnesium phosphate is in equilibrium with its ions, the ratio of magnesium ions to phosphate ions is:
At a certain temperature, 0.940 mol SO, is placed in a 2.00 L container. 2 SO, (g) = 2 SO,(g) + 0,(g) At equilibrium, 0.130 mol O, is present. Calculate K. K. =
Q3. At 298 K, F3SSF(g) decomposes partially to SF2(g). At equilibrium, the partial pressure of SF2(g) is 1.1X10-4 atm and the partial pressure of F3SSF is 0.0484 atm. (a) Write a balanced equilibrium equation to represent this reaction. (b) Compute the equilibrium constant corresponding to the equation you wrote. (c) Some SF2 (at a partial pressure of 2.3X10-4 atm) is placed in a closed container at 298 K with some F3SSF (at a partial pressure of 0.0484 atm). Enough argon is added to raise the total pressure to 1.000 atm. Calculate the initial reaction quotient for the decomposition of F3SSF to SF2.
the equilibrium constant (K) is a quantitative measurement of theextent to which a chemical or physical reaction proceeds to completion. If two reactants ofknown initial concentration are mixed and then the concentrations of the products aremeasured once equilibrium has been established, then the equilibrium constant can becalculated using an ICE table.In this experiment you will measure the equilibrium constant for the formation of iron(III)thiocyanate from the iron(III) cation and thiocyanate anion:Fe3+(aq) + SCN-(aq) FeSCN2+(aq)The product, FeSCN2+, is intensely red, which means that its concentration can be measured byusing an ultraviolet-visible (UV-vis) spectrophotometer. So long as a solution is not tooconcentrated, the absorption of light at a particular wavelength by a chemical species isdescribed by Beer’s Law:A = εℓ[X] where A = absorption of light (unitless number)ε = molar absorptivity constant (cm-1 M-1)ℓ = path length (cm)[X] = concentration (M)The path length for our…
Suppose a 250. ml. flask is filled with 0.20 mol of NO,, 1.6 mol of CO and 0.90 mol of NO. The following reaction becomes possible: NO,()+co(2) NO()+co,@) The equilibrium constant K for this reaction is 0.402 at the temperature of the flask. Calculate the equilibrium molarity of CO. Round your answer to two decimal places.
(a) (i) Define molar mass of a substance. (ii) State the method used to determine the molar mass of a volatile liquid. 2.15g ofa volatile liquid produced 84.3cm' of gas at 37°C and 0.97 atm. calculate the molar mass of the liquia. (iii) (b) (i) State the equilibrium law. TAG (ii) How will an increase in temperature affect the position of equilibrium of the reaction? N2O(g) = 2NO2(g) AH®=+54 kJ molľ Calculate the pH of an equivolume mixture of a 0.04 moldm® solution of CH3COOH and 0,3 moldm solution of CH3COONA (Ka = 2.0 x 10° moldm) (c) %3D
Suppose a 500. ml flask is filled with 0.50 mol of SO, and 0.30 mol of SO,. This reaction becomes possible: 2s0,(e) +0,(x) - • 250, (e) Complete the table below, so that it lists the initial molarity of cach compound, the change in molarity of each compound due to the reaction, and the equilibrium molarity of each compound after the reaction has come to equilibrium. Use x to stand for the unknown change in the molarity of O,. You can leave out the M symbol for molarity. so, so, Initial change equilibrium
Which of the following situations represent equilibrium?(a) Migratory birds fly north in summer and south in winter.(b) In a grocery store, some carts are kept inside and some out-side. Customers bring carts out to their cars, while store clerksbring carts in to replace those taken out (c) In a tug o’ war, a ribbon tied to the center of the rope movesback and forth until one side loses, after which the ribbon goesall the way to the winner’s side.(d) As a stew is cooking, water in the stew vaporizes, and the va-por condenses on the lid to droplets that drip into the stew.
At a certain temperature, 0.760 mol SO, is placed in a 2.50 L container. 2 SO,(g) = 2 SO2(g) + O,(g) At equilibrium, 0.120 mol O, is present. Calculate K.. Ke
A chemist is studying the following equilibirum, which has the given equilibrium constant at a certain temperature: 2 CH,(g) = 3 H, (g) + C,H, (g) 8- = 2. × 10 He fills a reaction vessel at this temperature with 14. atm of methane gas. Use this data to answer the questions in the table below. Can you predict the equilibrium pressure of H,, using only the tools yes x10 available to you within ALEKS? no ? If you said yes, then enter the equilibrium pressure of H, at right. atm Round your answer to 1 significant digit.
Explain your reasoning, please. Thank you.
LRererencesj Isoidan 1 Use the References to access important values if needed for this question. Consider the following equilibrium system at 844 K. 2HI(8) 2 H2 (g) + L (g) If an equilibrium mixture of the three gases at 844 K contains 0.196M HI, 3.37 × 10-2 M H2, and 2.80 × 10- M I2, what is the value of the equilibrium constant K?