20 V R

Q: 9. The instantaneous values of two alternating voltages are given as: v1=60sine and v2=40sin(0 -…

A: Solution !! Horizontal component of v1 = 40VVertical component of v1=0VHorizontal component of…

Q: R32 H₁ 西回原因。 G₁ 2 G3 CM

A: Given,

Q: 4.88 The variable resistor R, in the circuit in Fig. P4.88 PSPICE is adjusted until the power…

A:

Q: If the area of cross section of a conductor is increasing, then the resistance of the conductor…

A: If the area of the cross section of a conductor is increase then resistance?

Q: 3. Determine the voltage across R2 for the first and second diode approximations. Diode: Si, r = 10…

A:

Q: 20. What capacitance value is required for each of the varactors in Figure 3–78 to produce a reso-…

A: Given Data: L = 2 mH f = 1 MHz

Q: Problem B For the Circuit Shown: Derive the equation for the magnitude of the gain. Include a…

A: According to the question, we need to explain the circuit as shown below, Also need to draw the…

Q: 25 15 V C₁ 0.1 μF C₂ C₂, 0.47 μF 0.22 μF

A: Given data, Given circuit diagram is,

Q: 이18 V 4.7 k2 OVc = 12 V OVE 5.6 kn 1.2 k2

A:

Q: A single phase full wave bridge rectifier is used to supply power. If resistive load of 8.5 ohm from…

A:

Q: SAMPLE 2. Determine V across and I passing through Z, if Z is... a) 500 + j300 e b) 100 Q and 10µF…

A:

Q: following figure 4 if R1 = 1000 and VIN = 1.5V answer the following questions: +Vee UIN UOUT Vee R2…

A: Thus question belongs to analog electronics. It is based on the virtual ground concept of op amp .

Q: Q1. It is desired to run the motor at 1000 rpm, Find the value of the field resistance that to be…

A: 1)Given Desired speed N2=1000 rpmV=220 vRa=0.5 ΩRf=200 ΩT=constantArmature current Ia=20 Aspeed…

Q: The n- channel DMOSFET Transistors shown has IDSS = 5mA and Vp = -2V,the value of VGS is. +10V 5.1ΚΩ…

A: The Field Effect Transistor (JFET) is a unipolar device and a three-terminal voltage-controlled…

Q: R1 Vcc ww Rc RE

A: the circuit can be solved in following procedureExplanation:Step 1:Step 2: Step 3: Step 4:

Q: Example:- Design 32KX8 ROM by using 74LS138 decoder and the address store from 30000H, if this…

A: According to the question, we need to design 32 k x 8 ROM by using 74LS138 decoder.

Q: 20. (a) Compute the average value of each waveform shown in Fig. 11.34. (b) Square each waveform,…

A:

Q: Determine the current i

A: To apply the KVL in the circuit, take a positive sign while going from the negative terminal to the…

Q: S 3 + 2 Ri ww R3 www C₁= R2 R₁ = R₁ C₁ = C₁ C₂ = C R₂ = 4R, C2 R4 The switch is open and capacitors…

A: The switch is open and capacitors are uncharged. At t=0 the switch is S closed calculation of…

Q: ä. 50 20. For direct current generator, the ratio between the number of coils to the number of…

A: Practically no. Of coil side will be equal to no. Of commutator segment.

Q: 1) A second order control system with derivative control as shown in Figure 1, the effect of…

A: 1) After adding the Derivative controller , at first calculate the new transfer function of the…

Q: A single phase 220-V shunt DC motor has armature winding resistance is 0.2 2, the field winding…

A:

Q: Determine the values of i1, i2 and i3 for the following figure. 4 ΚΩ 8 ΚΩ 2 ΚΩ 100 V i 4 mA iz 2i, (…

A:

Q: QUESTION 20 What is the capacitance of a capacitor that has 30 ohms of reactance at 60 Hz. a. 90.5…

A: Given information, The value of capacitive reactance is XC=30 Ω. The value of frequency is f=60 Hz.…

Q: I= 11 A a mb C e 10.0 Ω 4.0 Ω m 5.0 Ω 20.0 V g f For the above circuit, what is the current and…

A: The circuit diagram,

Q: B 20 G E'4 V

A: According to the question we have to find the value of voltage drop across AC and the equivalent…

Q: If the load resistance is increased by 25%, the noise voltage will:

A:

Q: Calculate R2

A:

Q: 2 A signal consists of a fundamental frequency of 500 Hz, and the lowest five harmonics: 1000 Hz,…

A: A signal consists of a fundamental frequency of 500 Hz and the lowest five harmonics: 1000 Hz, 1500…

Q: 20. Determine the impedance of the circuit of Figure 2.33. 1k b a Figure 2.33 1 sin2pi1000t 50 mH…

A:

Q: Given the full-wave rectifier circuit shown below and given that the diode is made up of Silicon and…

A: According to Bartleby guidelines we are supposed to solve the first 3 subparts at a time kindly…

Q: Consider two conductors, a spherical conductor with radius a surrounded by a larger spherical…

A: a) surface charge density on the sphere of radius a, sigma_a = q/(4*pi*a^2) -------Answer surface…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.