= 20-2, XL = j 60-12, Xc = - Given: In the series R -L-C circuit; R e(t) = 20 20° volts. Find: a) total impedance b) total current in the ckt. c) voltage drop VR; Vc and V. d) total power and power factor 20ohms 160 ohms -j80ohms

= 20-2, XL = j 60-12, Xc = - Given: In the series R -L-C circuit; R e(t) = 20 20° volts. Find: a) total impedance b) total current in the ckt. c) voltage drop VR; Vc and V. d) total power and power factor 20ohms 160 ohms -j80ohms

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Calculate the average and the root-mean-square value of the output voltage for the network in the…

A: Given circuit is full wave rectifier , we know formula for average value and RMS value for full wave…

Q: A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil…

Q: An L-R-C series circuit is connected to a 120-Hz ac source that has Vms = 73.0 V. The circuit has a…

A: Given a series LRC circuit, having Resistance, R = 76 Ω Impedance, Z = 119 Ω Voltage, V = 73 V (rms)…

Q: QI: Draw the impedance diagram for the series R-C circuit for the figure, then find the : Q2: For…

Q: d. fr and Q-factor e. Phase difference between the voltage and current.

Q: For the circuit shown, the neutral current (A), IN is most likely, VA = 277 V<0° VB = 277 V<120° Vc…

A: In this question We need to determine the current in the neutral. We are solving this problem using…

Q: 13. List the formulas for the Ohm's law used in the analysis of RC circuits. 1. Describe the phase…

A: In this question , some part related to seriss RC circuit and parallel RC circuit is given...We have…

Q: A voltage and current applied to a single phase load is v= 115 sin (300t+40°) and i= 115 sin (250t-…

Q: Q5. A 50 Hz sinusoidal volt is applied consisțirg! of Lomputa ) the following @) tffective valde S…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: VI) For the circuit shown, answer the questions from 15-19, The load Zt = 8+j6 ohms, and the source…

Q: Key =93 Consider the circuit shown below. Here, R = 2092, R2 = 1092, ZL = +jKEYN and Zc = -j102. The…

Q: An alternahng with a value f 16 A. uns tantaneous value eand find fugueney . 50HZ U has an ms Wsuite…

A: (5) f=50 HzIrms=10 A

Q: Power factor correction is a method to do which of the following. ⒸRaising the power factor to…

A: In this question, we need to choose the correct option. What is way to improve the power factor .

Q: d. Calculate the voltage across the resistor R3. e. Find the average power delivered to the circuit…

Q: During fast decoupled Method load flow analysis in one of the loads the calculated reactive power…

A: The power system analysis has non linear equations of power. The equations are involving voltage…

Q: Given the circuit, solve for: a. Total current b. Total apparent power c. Total real power d. Total…

Q: Fill in the Blank: If the two wires are running in parallel then the impedance to ground from each…

A: Same The impedance to ground for both will be same .

Q: Determine the power factor of the system with v(t) = -120sin(wt - 30)V and i(t) = -12sint(wt - 50)A.…

Q: A balanced three-phase A-connected supply delivers power through a three-phase wire in an industrial…

A: NOTE: Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: Impedances are marked in perunit on a 100MVA. 100 KV base. The load at bus 2 is 52 16MW - 132 MVAR,…

A: In this question we need to find a bus voltage at bus 1 and bus 2 .

Q: Q.22: For the magnetically coupled circuit shown, find the voltage across (-J10Q) 10:00V 52 JS2 JSS…

A: The solution is given below

Q: Please answer in typing format

A: Circuit is a series RL circuit.Voltage V= 40<25° VImpedance Z = 8<40° Ω a)By ohms law,Current…

Q: Given Zc - j339 , R₁ = 414 , RL = 12420 2 and a=0.24, what is the magnitude of the source voltage Vs…

Q: A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil…

Q: Predict the output when the input three phase signal is given to the circuit shown in figure.3. IA…

Q: The reactive factor is the cosine of the phase angle between the voltage and the current Select one:…

Q: Pa balanced sphase system the Sequeuce is Positive and'aline Valtage Voe=208-70V Fhe tot is balancet…

A: We convert the delta connected load to star to draw per phase equivalent circuit

Q: 8. Three impedance Z1=1-j4, z2=-6. and z3 = 4 +j3 respectively are connected in series parallel. Z1…

Q: 3. In the transformer circuit shown, find the primary current I (Polar form, in Apms). Refer all…

Q: The Full-load and No-load of a regulator are 5.2V and 5.3V, respectively. Then the % load regulation…

Q: 1. What is the phase relationship between R, L, and C components in a series AC circuit? 2. What is…

Q: Two impedances, Z1 = 2+j6 Q and Z2 = 6-j12 0 are connected in series with a 220-V 60-Hz supply. At…

A: In this question, choose the correct option What is frequency if both impedance is connected in…

Q: 1. Draw an RLC parallel circuit and draw current triangle (using phasor representations) if source…

A: In this question we will describe parallel RLC circuit...

Q: o.) Find Curmnt Iy and Voltage Vx short -Circuited, b.) if the terminal a-b is Find the hew Current…

Q: L=0.15H R = 120 VR- C=100uF V=100v f=50HZ

A: Series RLC circuit

Q: Power factor correction is a method to do which of the following.

A: The objective of the question is to understand the purpose of power factor correction in an…

Q: Three Impedances each of (9 - j18)N are connected in mesh across a three-phase 415V ac supply.…

Q: c) Drive the expression for maximum phase leads of m given network V. in R₁ min C₁ wwww R2

Q: The figure shows a 3-phase bala Time left 1:06:30 sequence electrical system. Vcn = 200 /0° Vrms.…

A: Given,

Q: The 3-phase power equation in terms of phase voltage and phase current is VLI_Coso /3VplpCoso…

A: Power in in terms of phase voltage and phase current is givan as P=3VpIpCOSΦ

Q: Ex2: Two trausformers A and B are Connected in parallel Their impedances in secondary terms are…

A: The load shared by each transformer is given by Similarly load shared by transformer B is given by…

Q: Q: For the following SLD, take Sg = 100 MVA and VB = 22 kV at Bus 1 to: 1. Draw the impedance…

A: 1)To find the per unit impedance on given base of 100 MVA and 22 kv - Per unit impedance of…

Q: Pz:- The of abaancat Y conmected load is----- Each Phase of the load cousistof loL30 S2 Find the…

Q: and the new peru impedance of the motor is a load absorbs 50 MVA at 0.8 pf leading at line to line…

Question

Given: In the series R-L-C circuit; R = 20-2 , XL = j 60-N , Xc = - j 80-0 and
e(t) = 20 20° volts.
Find: a) total impedance
b) total current in the ckt.
c) voltage drop V R; Vc and V.
d) total power and power factor
20ohms
160 ohms
-j80ohms

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

part (a)

part (b)

part (c)

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Pz:- The of abalanced Y connected load is- Each phase of the load cousist of loL30 s2 Find the Line Voltages at the terminat actives Reachive and somflex Power Per Phase then Find the total Powers For Heree phase load. VAB =10010for 4
Answer Number 6 Write your Solution Pls Box your Final answer.
please answer d-e
Reply as soon as possible and clearly, do not use italics 1) For the circuit in Figure, what is the value of S1, S2, S3, S4 and ST? Response format: a complex number in rectangular format. 2) What is the power factor of the circuit? (Response format for power factor: a number real rounded to two decimal places) and What is the value of the impedance seen by the source? ( Response format for impedance: a Complex number in rectangular format.)
= = Impedances Z₂ and z3 in parallel are in series with an impedance z₁ across a 100V,50Hz AC supply. Z₁ (6.25 +j1.25)ohms, Z₂ = (5 + j0)ohms and Z3 (5 - jxc)ohms. Determine the value of capacitance Xc said that the total current of the circuit will be in phase with the total voltage. What is then the circuit current and power?
Draw an RLC parallel circuit and draw current triangle (using phasor representations) if source phase is o degree and the source current is leading source voltage 30 degrees. Draw voltage and current phasor diagram for circuit.
(a) The load impedance (Rectangular form) of pf = 0.8 lagging when connected across terminals A and B that will draw the maximum power from the source. (b) The total impedance of the circuit in ohm (Polar form). And The Power in the load in W. (c) The Power loss in the source in W.
A balanced load is connected in star across a 3 phasec415V 50Hz supply. The load consists of a coil of resistance 25 ohms and inducrance 0.5 henry in paeallel with a purw resistance of 28 ohms and a pure capaciror of 60microfarads capacitance ,in each branch. Calculate a. The line currents? Need full working and answer has to be 9.3A Formola for inductance XL= 2×3.142FL FORMOLA FOR CAPACITOR XC= 1/2×3.142×FC
Three coils connected in series across a 100 V, 50 Hz supply have the followingparameters:R1 = 18 Ω, L1 = 0.012 H; R2 = 12 Ω, L2 = 0.036 H; R3 = 3.6 Ω, L3 = 0.072 HDetermine the potential drop and phase angle for each coil. USE SERIES AC CIRCUITS METHOD NOT KIRCHOFF LAWS. PLS SHOW COMPLETE SOLUTION AND ROUND OFF TO FOUR DECIMAL PLACES , WRITE LEGIBLY PLS INLUDE ALSO THE CIRCUIT DIAGRAM:
"Three impedeances, A = 6+j3 ohms, B = 5+j6 ohms and C=2-j8 ohms are connected in parallel. Determine the equivalent impedance Zab" %3D O 3.94 j0.776 ohms O 3.94tj0.776 ohms O 4.93+j7.76 ohms none
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the angular frequency of the ac source? What is the period of ac source? What is the circuit impedance? What is the power factor? What is the real power of the circuit? What is the rms value of the circuit current?
4) Given: R = 700-N, Xc = - j 500-N, e(t) = 150 sin(wt) V Find: a) Total impedance of the ckt. b) Total current in phasor and sinusoidal form c) Voltage drop across the resistor and capacitor in phasor and sinusoidal form d) Total Power and Power factor