2.2) You have at your disposal lamps which nominal value are 120Volts and the nominal power are multiple of 300 Watts (e.g. 300W, 600W, 900W, 1200W, etc.). Select the lamps L1, L2, L3, L4 and L5 that will ensure that the two channels Ch1 (Channel 1), and Ch2 (Channel 2) are working at the maximum of their capacity. Justify your selection with your calculations.

Q: A single solar cell is a photovoltaic device has the following distinct properties: 1. An area…

A: Solar cell is a device that converts light(solar) energy into useful electrical power. It is always…

Q: Another resistor is made out of aluminum (= 3.5.107) with the same length and resistance as the one…

A:

Q: There are eight 3V/200mA rated photovoltaic cells that are connected in series and eight more…

A: Given data Rating of the each photovoltaic cells 3V/200 mA Number of photovoltaic cells contains is…

Q: answer the following based on the 3-phase transfomer configuration in figure 7, worksheet4.…

A: The primary sides of given bank of transformers are connected in delta and the secondary side as…

Q: E h im R₁ 9.50 Ohms R₂ 19.00 Ohms Consider the LR circuit shown in the figure above: ell L=69.00 mH…

A: As per the guidelines of Bartleby we suppose to answer first three subpart only for solution of…

Q: 1602 assUme

A: Given data, vt=10cos2πf0tf0=60 HzR = 100 Ω Circuit diagram is given as,

Q: Given the following Resistances and Inductors in Series and Voltage Source: R1 = 84 ohms %3D R2 = 13…

A: given r and l circuit

Q: Vdc0 U=12 V Circuit #1 Ried LED www Ried_series Vdc0 U= 12 V Current in LED (A) Circuit 0.03 #₂ 0.02…

A: Given Data:An LED illumination circuit with,Supply voltage Set-current of the diodes V-I…

Q: Q2.The periodic triangular current in shown in Figure 1 has a peak value of 180 mA. Find the average…

A: Given figure, Peak current, Ip=180 mA

Types of Thyristors

With four layers of alternating P- and N- materials, a thyristor is a solid-state semiconductor device. It acts as a type of bi-stable switch and it conducts when the gate receives a current trigger and continues to conduct until the voltage is reverse biased across the device or by some means until the voltage is removed. The silicon-controlled rectifier is considered synonymous with thyristors by some sources. Thyristors are defined as more complex by other sources as it contains at least four-layer of alternating N-type and P-type substrate. They find large applications in the control of electrical power supplies, electric motor speed control, and ranging of light dimmers because thyristors can control large amounts of power supplies and voltage with a small device. The circuit symbol of the thyristor is given below.