Answered: 2.2 A rectangular pontoon has a mass of… | bartleby

Related questions

Question

QUESTION 02
2.2
A rectangular pontoon has a mass of 240 metric tons and a total length of 18 m.
The centre of gravity is 0.3 m above the centre of cross-section and metacentric
height is to be 1.2 m when the angle of heel 10 degree. The freeboard must not be
less than 0.6 m when the pontoon is vertical. Find the breadth and the height of the
pontoon if floating in fresh water.

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

Item 2 Consider the crane system in (Figure 1). It can be operated so that the steel beam ratates around the orange axle. The crane is supported by a steel cable attached to it 6.0 mm from the upper and making a 30 angle. The steel beam is 32 1n in length and weighs 25,000 N. The beam's unique design causes the center at gravity to be at a point 12 m along the beam from the ground. Figure 6.0 m 300 Y Part A If 0 = 71" and the metal crate hanging on a 4.5 m massless cord weighs 17,000 N, determine the tension in the steel cable supporting the crane. Express your answer with the appropriate units. T = Submit ▾ Part B. TA Value Submit Request Answer F₁ - Value O E Request Answer Units Determine the horizontal component of the force experienced by the steel beam at the axel base.. Express your answer with the appropriate units. Enter positive value if the direction of the force is to the right and negative value if the direction of the force is to the left. ? C Units ? Review | Constants
Two builders carry a sheet of drywall up a ramp. Assume that W = 2.10 m, L = 3.20 m, 0 = 25.0°, and that the lead builder carries a (vertical) weight of 187.0 N (42.0 lb). What is the (vertical) weight carried by the builder at the rear? The builder at the rear gets tired and suggest that the drywall should be held by its narrow side. What is the weight (in N) he must now carry?
A plank 2.00 cm thick and 16.3 cm wide is firmly attached to the railing of a ship by clamps so that the rest of the board extends 2.00 m horizontally over the sea below. A man of mass 67.7 kg is forced to stand on the very end. If the end of the board drops by 5.40 cm because of the man's weight, find the shear modulus of the wood. 75376.05
Consider a square-faced beam supporting a section of a building. a) Before installation, the length of the beam is found to be l0 = 15.02 m (figure a). After installation and construction, the length is remeasured and found to be l = 14.98 m (figure b). Determine Young's Modulus Y in N/m2 for the beam if it supports a mass m = 35000 kg and has a side length d = 1.9 m. b) Suppose that after the beam is installed it needs to be repaired. The weight it supports is removed and replaced with a new mass m2 (figure c). After the new mass is supported, the side length is remeasured and found to be larger with a difference of Δd. Assuming that this side length deformation is uniform and small, write an expression for determining Poisson's ratio v for this beam if its Young's modulus Y is known.
Hi I need help with this question: Logs sometimes float vertically in a lake because one end has become water-logged and denser than the other. What is the average density (in kg/m3) of a uniform-diameter log that floats with 28.0% of its length above water?
Suppose a person’s femoral diaphysis is idealized as a solid circular cylinder with a diameter of 2 cm. The ultimate stress in tension is 120×106 pa. Calculate the maximal tension force the femoral diaphysis can sustain.