2. The power dissipated by an electric appliance is 60 W. What is the current flowing throughit if it is connected to a power source of 220 V?3. A water heater draws a 20 A from a 120 V power source 8 m away. What is the minimumcross section of the wire that can be used if the voltage applied to the heater is not to belower than 110 V?

Note :- As per guidelines we are supposed to answer only one question. So I request you to please…

Answered: 2. The power dissipated by an electric…

2. The power dissipated by an electric appliance is 60 W. What is the current flowing through it if it is connected to a power source of 220 V?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 200 V, single-phase domestic energy meter is connected to a constant resistive lamp load 5 A. It makes 1100 revolution in 10 hours. What is meter constant in rev/unit?
Testing a Battery Without a Tester The internal resistance says a lot about the state of the battery. To calculate the actual internal resistance of the battery, MULTIMETER proceed as follows: • Measure the source voltage (voltage when no current is flowing) (Vo) and terminal voltage (voltage when current is flowing) (Vc). CE CAT I Calculate the voltage drop across the internal resistance OFF V 200m 20M (V, - Vo- Vc). CURRENT CLAMP 2. 2M • Measure the load current (1). Calculate the internal resistance (R = V/ I). OFF 20- -200K 1mV/A 200- 20K 10mV/A 600 2K ... A ZERO 10 200 10 COM The battery being tested has a CCA rating of 640 A. The battery manufacturer specifies that the maximum internal resistance should not exceed 2.5 + cold cranking amps (CCA) rating of the battery. What is the maximum acceptable internal resistance value for this battery?
Please assume a price for electric energy of $0.15/kWh. If washer A costs $750 and uses 200 kWh of energy per year to operate, and washer B costs $300 and uses 800 kWh of electricity per year to operate, which of the two washers costs less to own and operate over a period of ten years?
How much energy will be consumed of a 500 W Water Heater runs for 20 hours continuously? If the company charges 2 cents per kWh, how much amount the consumer will be charged?
What is the power out from a supply that has 500W of power supplied and is 75% efficient?
4. Supposed that the battery in the circuit shown below is 12 Volts. Suppose that the resistors are each 100 Ohms. What is the EMF of the battery? And what is the change in electrical potential along the loop shown from the point A back to the point A? + a) about 12 V, 0 V b) 0.12 V, 0 V c) 1200 Ohms, 14 V d) 1200 Volts, -6 V
3. In Figure, the battery voltage is V=10 volts, and the values of the resistances, in ohms, are 100, 220,and Kas shown. Find: (a) Total resistance seen by the battery, (b) Current measured by the ammeters shown in the figure, (c) Power output of the battery, (d) Power input to each resistor. V 10082 220 Ω 1ΚΩ
23.)
Explain the following terms such that the difference between the terminologies used become clear. a. Charge and current b. Power and Energy c. Loop and Mesh d. Node and reference node e. Mesh current and branch current
2. In Figure, the battery voltage is V = 65 volts, and the values of the resistances, in ohms, are 38, 17, and 27, as shown. Find: (a) Total resistance seen by the battery, (b) Current measured by the ammeters shown in the figure, V= 65 V 38 2 17 2 27 2
please solve all 4 parts Part A Find i for the circuit. Part B Find the power supplied by the voltage source. Part C Reverse the polarity of the voltage source in the circuit shown in the figure, and find i for a new circuit. Part D Reverse the polarity of the voltage source in the circuit shown in the figure, and find the power supplied by the voltage source for the new circuit.
How is electric power generated in a power system, and what are the various sources of power generation?