2. Given the tank configuration shown below, find the hydrostatic force on the dome if the air pressure at the upper end of the manometer is 1814 psf. -Air -4-ft diameter 20 psi 5 ft 2 ft Water 2 ft Gage fluid (SG = 3.0)

2. Given the tank configuration shown below, find the hydrostatic force on the dome if the air pressure at the upper end of the manometer is 1814 psf. -Air -4-ft diameter 20 psi 5 ft 2 ft Water 2 ft Gage fluid (SG = 3.0)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

3. Water flows through the horizontal branching pipe which is fixed by a flange as shown in the following figure. At section 1, the pipe continues to the left and hence the gauge pressure is not zero (see Figure below). At sections 2 and 3, gauge pressure is zero (atmosphere). A₂ 14 kPa A₂ 60⁰ stationary? A₂ For this problem: A₁= 600 cm² V₁=3 m/s A2= 100 cm² V₂= 3 m/s A3 = 300 m/s g= 10 m/s² p= 1000 kg/m³ What is the velocity at section 3 (V3)? What is the horizontal force F that the flange applies to keep the pipe system
Two pipes A & B carries an oil of specific gravities 0.9 & 1.2 respectively. The center of the pipe A is 30 cm above the pipe B. The height of oil in right limb is 50 cm. Also, the mercury level difference is found in right limb as 90 cm. Find the pressure difference between these two pipes in kPa. Also find the pressure equivalent in water head in mm. The difference of pressure between two pipes (PA-PB) (Unit is in kPa) ? Equivalent to Water head in mm ?
I need the answer as soon as possible
• A simple U tube manometer is given below. The pressure at which side is higher? o Left o Right o Left = right • In order to calculate the pressure difference at locations 1 and 2 (P2 - P1), we need to know the length of the inclined tube L, as is shown below. o True o False A fow section fow device Fluid
uservoir discharges into a 55-inch pipe that discharges freely, as shown below. What is the pressure in the pipe at point A? Consider friction. Use f =0.02 Elev 155 ft Inv. @ A 134.2 ft 55 in 140 ft Inv. 120 ft 420 ft 900 ft 1450 ft a. 502 psf b. 502 psi c. 457 psf d. 457 psi e. 36 ft ,what is the velocity at point B? a. 17.5 fps b. 36 fps c. 3.6 fps d. 4.57 fps e. 50.2 fps ar
Part 1|A U-tube manometer is connected to a closed tank containing air and water is shown. At the closed end of the manometer the air pressure is 20 psia. Determine the reading on the pressure gage for a differential reading of 5 ft on the manometer. Express your answer in psi (gage). Assume standard atmospheric pressure and neglect the weight of the air columns in the manometer.
Plss answer ASAP
Question 1 1.1. Calculate the total force (kN) on the bottom of the closed tank shown in the Figure below if the air pressure is 62 000 Palgage). Air 0.45 m Oil (sg -0.85) 0.80 m Water 1.5 m 1.1 m If the length of the tank in the Figure below is 1.45 m, calculate the total force on the bottom of the tank. NB: The tank is open on top. 1.2. im Tank is 1.45 m long Oil 1.25 m (sg 0.80) Water 2.5 m 2.0 m
Homework help
The system in the figure is at 70°C (SG = 0.983). Determine the pressure at point C.
A tank 13 ft deep and 5 ft wide is layered with 6 ft of oil (y = 50.0 lbf/ft3), 5 ft of water, and 2 ft of mercury (y = 846 lbf/ft3). Compute (a) the total hydrostatic force and (b) the resultant center of pressure of the fluid on the right-hand side of the tank.