2. Construct the influence line for: a.) Ra b.) Rb c.) Vf d.) Mf TE: Moving loads will have

Q: A thin and weightless beam is supported by a pin connection at 4 and by a roller at B (see figure…

A:

Q: *1-44. The 150-kg bucket is suspended from end E of the frame. If the diameters of the pins at A and…

A:

Q: Q.4 An example simple truss is shown in Figure. The deck in this bridge is concurrent with the…

A:

Q: A beam is part of the framing system for the floor of an office building. The floor is subjected to…

A: Service dead load moment= 65 ft-kipsService live load moment= 63 ft-kips

Q: *1-44. The 150-kg bucket is suspended from end E of the frame. If the diameters of the pins at A and…

A: Given : Weight of bucket = 150 kg Dia of pin A = 6mm Dia of pin D = 10 mm To Find : Average shear…

Q: There is a P = 188 KN load applied in the mid-span of the below simply supported beam with the given…

A:

Q: a T2 is secured to a wall by cables as shown. T1 = 58 N, T2 = 50 N, a = = 5 m, c = 6 m. ermine the…

A:

Q: You didn't solve the problem correctly could you resolve it and please clarify your steps the…

A:

Q: If the shear at point A on a beam is zero, then A.the slope of the bending moment at A must be zero…

A:

Q: For the distributed loads shown (System 1). a) Reduce the distributed loads to three concentrated…

A: The beam must be in equilibrium and for that it has to fulfill conditions which area as follows:…

Q: Three forces are applied to lever ABD. (a) Draw Mohr's Circle for Point H, (b) determine the max…

A: free body diagram at H Draw Bending stress diagram Shear stress diagram

Q: For the beam shown, using the Müller-Breslau principle, do the following: (a) Draw the influence…

A:

Q: 1.W.1/The cantilever beam in Figure below has a rectangular cross section with dimension 20…

A:

Q: Q4 Draw the influence lines for (a) the vertical reaction at B, (b) the shear just to the right of…

A:

Q: Beam AC is attached to the wall and is supported by column BD at the other end, as shown in the…

A: Objective: To determine- A) vertical reaction at A B) load carried by the column at B C) maximum…

Q: A |C 3 m- +1.5 m→1.5 m→| 150 mm

A: Let maxi distributed load on the beam is Wthenreactions and shear force…

Q: 1-..........is vertical and horizontal shearing stress at the Point of interest in beam a) Lp) b)…

A: Multiple choice questions related to shear stress in beam are given. We need to choose correct…

Influence Lines

The graphs that show the variation of a function at a specific point on a beam or truss due to a unit load placed at any point along the structure are known as influence lines in engineering. Some common functions that are studied with influence lines are shear, moment, and deflection. In designing beams and trusses, it is important to use influence lines in structures where loads would move along their span such as bridges, crane rails, conveyor belts, floor girders, etc. The influence lines help to study where a load will create the maximum effect for any of the functions.