2. A standard vapor compression system produces 25 Tons of Refrigeration using R 12 as refrigerant while operating between a condenser temperature 42 degree Centigrade and an evaporator temperature of -25 degree Centigrade, Determine a) the refrigerating effect b) the mass flow rate of R 12 in kg/s c) the power supplied in kW d) the volume flow rate in L/s.

2. A standard vapor compression system produces 25 Tons of Refrigeration using R 12 as refrigerant while operating between a condenser temperature 42 degree Centigrade and an evaporator temperature of -25 degree Centigrade, Determine a) the refrigerating effect b) the mass flow rate of R 12 in kg/s c) the power supplied in kW d) the volume flow rate in L/s.

Name: 2. A standard vapor compression system produces 25 Tons of Refrigerat
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 2. A standard vapor compression system produces 25 Tons of Refrigeration using R 12 asrefrigerant while operating between a condenser temperature 42 degree Centigrade and anevaporator temperature of -25 degree Centigrade. Determine a) the refrigerat

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q 4) A simple vapour compression plant produces (5 tonnes) of refrigeration. The enthalpy values at inlet to compressor, at exit from the compressor, and at exit from the condenser are (183.19, 209.41 and 74.59 kJ/kg) respectively. Determine :- (i) The refrigerant flow rate, (ii) The C.O.P. (ii) The power required to drive the compressor. (iv) The rate of heat rejection to the condenser.
Work is done on a system in (mark all): a) Refrigeration cycle b) Power cycle c) Heat pump cycle
1. A standard vapor compression refrigeration system uses Ammonia as refrigerant. The Ammonia leaves the evaporator at – 20 degree Centigrade and the condenser pressure is 1200 kPa. The flow rate is 30 kg/min. Determine a) the tons of refrigeration b) the power required c) the COP.
A refrigeration systerm using refrigerant 11 is lo have a refrigerating capacity of 80 kW. The cycle is a standard vapor-compression cycle in which the evaporating temperature is -15°C and the condensing temperature 30°C. Determine the volume flow of refrigerant measured in liters per second at the inlet to the compressor. 213.02 B) 123.01 c) 62.61 314.84
A Rankine Engine-Generator unit receives 27,000 kg/hr of steam at 1.2 MPa and 150°C and exhausts to a condenser temperature of 22 C. Brake steam rate is 4.74 kg/kW-hr, mechanical efficiency is 90 % and generator efficiency is 94 %. Determine: a) ideal cycle thermal efficiency, b) indicated engine efficiency, c) generator output (kW), d)the condition of turbine actual exhaust
Consider a vapor compression refrigeration cycle working with R134a circulating at a flowrate of 90 kg/s. Compressor inlet is saturated vapor at 140 kPa and exits at 1200 kPa and 80oC.Condenser exit is 44oC. Find:a) Draw T-s and P-h diagrams and schematic block diagram of the cycleb) Compressor work inputc) Refrigeration capacityd) Isentropic efficiency of the compressore) 2nd law efficiency of this cycle
9) What is the refrigeration effect?A: It is the energy transfer per kg of refrigerantB: It is the energy transfer per oC of refrigerantC: It is the energy reject per kg of refrigerantD: It is the energy reject per oC of refrigerant
Homework: A counterflow heat exchanger is located between a collector and a storage tank. The fluid in the collector side is a water-glycol mixture with cp=3840 J/kg. °C and a flow rate of 1.35 kg/s, whereas the fluid in the tank side is water with a flow rate of 0.95 kg/s. If the UA of the heat exchanger is 5650 W/°C, the hot glycol enters the heat exchanger at 59°C, and the water from the tank at 39°C, a) estimate the heat exchange rate; b) if FRUL is 5.71 W/m².°C and collector area is 16 m², what is the ratio FR/FR?
Refrigerant 22 is the working fluid in a Carnot vapor refrigeration cycle for which the evaporator temperature is -10°C. Saturated vapor enters the condenser at 36°C, and saturated liquid exits at the same temperature. The mass flow rate of refrigerant is 10 kg/min. Determine the COP, (A) 5.72 B) 8.53 Ⓒ10 D) 3.68
An ammonia simple saturation cycle operates at 35 psia suction pressure and 172 psia condenser pressure. For a load of 1600 Btu per minute, determine: a) The refrigerating effect b) The COP c) The gallons per minute ( GPM ) of cooling water in the condenser if water temperature is increased by 10 F.