2) Given the cross sectional area below. The horizontal neutral axis is 129.0mm from reference corner 1. The moment of inertia around this neutral axis is 1073352100.6mm". 1 30mm 2 30mm 3 30mm 4 300mm 300mm F100mm- 100mm - -200mm- - 200mm- 400mm 50mm a) Draw the shear stress distribution of the section if there is a shear force on the section of 10kN. b) What percentage of the shear force is carried by the cross section between 2 and 3?

Q: (1) (2) P A В C 0.45 m 1.30 m The assembly above starts out at 52 degrees celsius. What is the final…

A:

Q: The 641-N force is applied to the 110-kg block, which is stationary before the force is applied.…

A:

Q: 4. If 0 = 30° and = 6 KN , determine the magnitude of the resultant force acting on the eyebolt and…

A:

Q: - Simply supported beam AB is subjected to the loading as shown below. Determine a) the slope at A,…

A: Force in the vertical direction -  RA + RB = 0       .....1 Sum of the moment at the point A -  ∑MA…

Q: Determine the horizontal and vertical deflection at point C. Use E = 200 GPa and 1=20x10^6 mm^4. 2 m…

A: E = 200 GPa I = 20 × 106 mm4Determine the horizontal and vertical deflection at joint C. Lets solve…

Q: What must be the pull in a (7)(10) meters tape in order to eliminate the sag and temperature…

A:

Q: Exercises: 1. Determine the X and Y components of each of the forces shown. F = 390 lb 12 40° 30 P=…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: The beam below, use the double integration method to determine the deflection at point A (do not use…

A: To determine the deflection at point A using the double integration method.   Applying the Double…

Q: A line of slope 4:10 has been scribed on a cold-rolled yellow-brass plate, 6 in. wide and in. thick.…

A: Given data:- A line of slope 4;10 Width of brass plate =6 in1 ft12 in=0.5 ft Thickness of brass…

Q: Figure B 0 I A B HA FC 1 of 3

A:

Q: 200 mm 30 mm -25 mm V В 250 mm 30 mm 125 mm If calculating the shear stress at point B, what is the…

A: Step 1

Q: l-and-socket connection in the horizonta ate the magnitudes of the forces P ar e ball end B of the…

A: Find…

Bars

In civil engineering, bars refer to steel reinforcement bars or rebars. These are structural members primarily used for reinforcement purposes in masonry works. A bar is characterized by its cross-sectional area, which is negligible compared to its length. Bars are usually manufactured by steel which is uniform throughout the length, or by meshing multiple steel wires. Other materials of the bar include carbon steel, glass fiber, carbon fiber, and basalt fiber. The reinforcing bars are coated with epoxy resins and other materials to enhance some of their properties including corrosion resistance.