2- A message signal given by m(t) = 3 cos (400 t+n/2) is sampled with the minimum sampling rate (i.e. Nyquist rate). If the number of levels is 13, compute the following: a. Sampling rate, fs- b. Signal-to-quantization noise ratio (SNR). c. Average quantization power, Pg. d. Number of bits per sample, l. e. Total bit rate, R₂. f. Minimum bandwidth. g. If we record this audio for 7 minutes. What is the file size for this record in bits?

2- A message signal given by m(t) = 3 cos (400 t+n/2) is sampled with the minimum sampling rate (i.e. Nyquist rate). If the number of levels is 13, compute the following: a. Sampling rate, fs- b. Signal-to-quantization noise ratio (SNR). c. Average quantization power, Pg. d. Number of bits per sample, l. e. Total bit rate, R₂. f. Minimum bandwidth. g. If we record this audio for 7 minutes. What is the file size for this record in bits?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

3、The relationship between the signal frequency fc and sampling rate Ts is ( ) according to the Nyquist sampling law A、 fcTs>1 B、 2fcTs>1 C、 3fcTs>1 D、 4fcTs>1
Q5: A signal s(t) band - limited to 4 KHz at a rate 50% higher than Nyquist condition the and sub interval = 0.09375. 24 signal peak amplitude is ± + 2 Find the actual sampling rate, number of levels, total bits of actual sampling rate and total bits of 20 signals.
Refer to the pictures for the question
What is a minimum number of sampling frequency required to have distortion free reconstruction of a digital signal from its samples?
digital signal prossesing
Hi .. Please solution this question and required points . Thank you.
A Delta modulator is used to encode a speech signal x(t) = b sin Wmt band-limited to fm = 10KHz with sampling frequency, fs-100 KHz. For b = +4-volt peak signal voltage, 1) Find the minimum step size to avoid slope overloading. 2) Calculate Signal to quantization noise ratio.
The Nyquist sampling interval, for the signal sinc(700t) + sinc(500t) is?