1A 50 m tape weighs 2.5 kg. Ever y time measure ment is performed, the tape is supported points at its end and at the 9 m and 27 m marks. 1f a standard pull of 7.5 kg is appied. Deiermine the folowing : Correction one tapc Icngth. due to sag for b.) Correct distance betw een the endr of the tape - a une using the found The tape was used to measure same support loc ation s. If the une was to be Same the correct mcasure ment. 70 long, det er mıne

Q: Can I have the answers in 3 decimal points

A: Therefore moment at the section

Q: A large reservoir supplies water for a community. A portion of the water supply system is shown.…

A: a)Average velocity of water in the pipe Here discharge, Q = 1310 l/s = 1.31m3/s We know discharge in…

Q: 1- Determine the location y of the centroid C of the beam having the cross-sectional area shown 150…

A:

Q: Express the following values using scientific notation, engineering notation, and using an…

A: Standard Notation = 264360000 JoulesScientific Notation = 2.644 × 108 JoulesEngineering Notation =…

Q: Please calculate the centroid x and y bar, and Ixx for the following shapes. Show all work on an…

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: Describe implicit time method.

A: Describe implicit time method.

Q: Exercise 5: Identify the surfaces with the appropriate letter that would appear in the FRONT view,…

A:

Q: A clockwise couple M = 4.5 N m is resisted by the shaft of the electric motor. (Figure 1) Part A…

A: Given: The moment M is 4.5 N.m. Consider the figure,

Q: Determine the vertical distance H from the lower edge of the cross-section to the y coordinate of…

A: Given figure,

Q: please help

A: The AON DiagramConstruction of the AON Diagram:Based on the given dependencies, here's the AON…

Q: Please calculate the centroid x and y bar, and Ixx for the following shapes. Show all work on an…

A:

Q: 5. Calculate the centroid of a wire rod bent into the shape of an arc defined by x(y) = 3y² from the…

A: The curve x = 3y2 Boundary condition (0,0) and (12,4)

Q: dy x³ex² dx ylny

A: Hello dear this is the solution of your problem Please see the attached solution, thanks

Q: A water supply system contains two parallel lines, each consisting of a pump along 400 ft of 8-inch…

A:

Q: Use the method of compsite areas to calculate the centroidal coordinates of the plane regions shown…

A:

Q: Locate the centroid C(x,y) of the plane area shown below. Arrange your calculations in a tabular…

A: ###Locate the centroid of the plan area and make calculation in tabular format ####Centroid C

Q: Target Range (R) [m] σG A. P P, = (4 t)² R4 where: Pr = power received from the radar in units of…

A:

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.