18 MPа 20°. Stress component is shown in the figure. By using the Mohr Circle : Determine 10 MPa a. Normal stress(o) and shear stress (t) at face a and b b. Principal stress and maximum shear stress c. Provide the answer on stress particle 6 MPa Use the scale 1cm = 5MPA 20° a

Q: identify any zero force members

A: There is force at joint where two members are connecting.

Q: What are the disadvantages of the conflict between the supplementary general conditions and general…

A: Following are the differences between  the supplementary general conditions and general condition:

Q: Distinguish between free float and total float?

A:

Q: What are the Shear-Flow Resultants?

A: There is a wide variation in shear flow in the open sections and closed cross sections. In case of…

Q: What are the most important ideals and rules of DSDM? DSDM is a good method to use when making plans…

A: DSDM (Dynamic Systems Development Method) is an agile project delivery framework that provides a set…

Q: did you come up with 100 k-ft for the BMD? I'm probobly missing it but I'm unsure of how you got

A:

Q: A high rise building will be built in a reclaimed area in Metro Manila. Concrete piles will be used…

A: Concrete pile 400 mmC-1 = 1800 x 2000 MMC-2 = 1600 x 2000 MMTo determine :Minimum testing…

Q: Explain why Hasofer-Lind's reliability index important?

A: Hasofer-Lind's reliability index or better known as first order relaibility method is a…

Q: Explain how the process of pumping large volumes of water from a well can alter the position of a…

A: How process of pumping can affect the ground water table:

Q: Explain - Explain why groundwater is more difficult to clean than surface water.

A: Groundwater and surface water are two primary sources of fresh water on our planet. However, they…

Q: In the given figure on page 5 (Figure 2: Truss Elements) what are the part/s of the truss that are…

A: TIE The parts of the truss that are under tie are the horizontal members that are under tension.…

Q: You are currently working as an intern in a structural design company. In a project, your group was…

A: Given data in question  Proposed plans Internal hinges To find out  Which plans can't be used and…

Introduction to Engineering Design

Students are often confused with engineering and design. The term engineering design has two words with different meanings, engineering, and design. The term engineering implies applications of laws and principles of science to design and analyze physical structures and components. In civil engineering, students apply the concept of physics and chemistry to design and build structures and buildings. In engineering disciplines, the term design means determining the dimensions, loads, and associated influences on the component due to the applied loads such as stresses and deformations. The estimation of such parameters is crucial to make the component or structure foolproof.