17. The velocity of the water flow which is formulated by V=Q/A will logically tend to a. Occurs in the upper reaches of the river b. Occurs in the lower reaches of the river c. Happened to Alluvial Fan d. Happening on stream

17. The velocity of the water flow which is formulated by V=Q/A will logically tend to a. Occurs in the upper reaches of the river b. Occurs in the lower reaches of the river c. Happened to Alluvial Fan d. Happening on stream

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: 8.5 A small reservoir has a spillway crest at elevation 200.00 m. Above this elevation, the storage…

A: A small reservoir has a spillway crest at elevation 200.00 llp0w The storage and outflow from…

Q: A trapezoidal channel has a bottom width of 6 m and side slopes of 2 horizontal to 1 vertical. The…

A: The flow happens by means of gravity from the higher head to the lower head. The direction of flow…

Q: Water is flowing at a steady rate through a homogeneous and saturated horizontal soil strip of 10 m…

Q: What does a negative flow rate mean? A. This value is incorrect and shall be indicative of wrong…

A: The negative flow rate means that it is backflow. The negative flow rate indicates the direction of…

Q: 5. When depth of flow is more than critical depth, it is called as: a) Supercritical flow b)…

A: 5. The water profile is classified based on the flow of water longitudinally. They are classified as…

Q: The elevations of water surfaces in reservoirs A and B are 300 ft and 250 ft, respectively, and…

A: To Determine the elevation of the surface of reservoir C, El C.

Q: A uniform flow occurs at a depth of 3.15m in a rectangular channel 6.75m wide with n=0.015 laid on a…

A: Given data Uniform flow depth y1 = 3.15 m Width of channel b = 6.75 m manning's coefficient n =…

Q: For the following flows, determine the components of rotation about the various axes. (a) u= xy°z, v…

Q: Q4] A triangular channel of apex angle 90° and a rectangular channel of the same material have the…

A: Triangular channel (Channel-1) Apex angle = 90° Depth of flow = y1 Rectangular channel (Channel-2)…

Q: A drainage canal in the shape of trapezoid with a bottom width of 2,3m and a side slope of 1…

A: B=2.3m y=2.8m n=0.012 S=0.0004

Q: For the following flows, determine the components of rotation about the various axes. (a) u = xy³z,…

Q: The stream function y = 4xy in which y is in cm² per second and x and y are in metres describe the…

Q: 4. Calculate the force exerted on a stationary curved vane that deflects a 0.025-m-diameter stream…

Q: The velocity components in the x and y directions for an incompressible flow are given as u = (-5 +…

A: Given: velocity component in x direction= u= -5+6x Velocity component in Y direction = v= -(9+6y)…

Q: Find the flow for a rectangular channel, 5 m wide for uniform at depth of 2 m. The channel has a…

A: A = Flow Area, (ft2) n = Manning's Roughness Coefficient. R = Hydraulic Radius, (ft) S = Channel…

Q: Give Answer fast and right.

A: Calculations:Given data y = 2.438 - depth of flow in meters B = 12 - bottom width in meters z =…

Q: Determine the flowrate for the symmetrical channel shown in the figure if the bottom is smooth…

Q: A) what is the number of drop of the flownet? B) What is the flow of water in the unit of cm^2/min?…

A: The given figure shows a concrete dam on-site and its corresponding flow net.The coefficient of…

Q: 2. Water flows at a rate of 90lt/s from reservoir A to reservoir B through three concrete pipes…

A: given data, L1=6000m,D1=0.3m,f1=0.018; L2=4000m,D2=0.23m,f2=0.015; L3=2500m,D3=0.2m,f3=0.012 since…

Q: Consider an irrotational region of flow composed of a line source of strength V. /L at location (−a,…

A: The figure is shown below,

Q: The velocity components in the x and y directions for an incompressible flow are given as u = (-5 +…

A: Please refer the attached image for complete solution. THANK YOU.

Q: If u = xy + 2y³x. v = -0.5y² + 6x³2 and w = 5y²x - y³z + x, then for a steady and incompressible…

A: Given- Velocity components- u=xy+λy3x,v=-0.5y2+6x3z,w=5y2x-y3z+x, Flow is steady and incompressible,…

Q: 8.5 A small reservoir has a spillway crest at elevation 200.00 m. Above this elevation, the storage…

A: A small reservoir has a spillway crest at elevation 200.00 m The storage and outflow from reservoir…

Q: The velocity components in the x and y directions for an incompressible flows are given as = (-5 +…

A: u=-5+6x,v=-9+6y,

Q: The three components of a stream flow are given as u=y², v=-xy, w=0. Compute the z-component of the…

A: Given Data: Components of stream flow given. u=y2v=-xyw=0 To find out- Z- component of the angular…

Q: The stream function y = 4xy in which y is in cm² per second and x and y are in metres describe the…

A: The given figure is shown below:

Q: form flow of water in a wide channel with a velocity of 8 m/s and flow depth of 0.8 m. Water flows…

A: Data provided- V1 = 8 m/s , y1 =0.8 m Total energy at (1) =E1 E1 = y1 +V122g=(0.8+822×9.81)…

Q: Provided below is the cross-sectional area, verticals, depths, and velocities of a lake. Assuming…

Q: A wide river with a water surface elevation 1/8000 of depth of flow D. If the depth of flow in the…

A: Discharge ratio- Q1/Q2=2.58 Surface slope decrease by 40%, Elevation=1/8000. % change in discharge=?

Q: For the following flows, determine the components of rotation about the various axes. (a) u = xy°z,…

Q: The 4m wide square cross-section is 2.5m deep with a flow rate of 10m^3/s. Determine the depth of…

Q: The stream function y = 4xy in which y is in cm² per second and x and y are in metres describe the…

Question

17. The velocity of the water flow which is formulated by V=Q/A will logically tend to
a. Occurs in the upper reaches of the river
b. Occurs in the lower reaches of the river
c. Happened to Alluvial Fan
d. Happening on stream

Expert Solution

Step 1

Given data in question

Velocity of water

Continuity equation

To be discussed

Continuity equation will logically tend to be used in

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

Example 12.3. A small reservoir has a spillway crest elevation 200.0 m. Above this elevation, the storage and outflow from the reservoir can be expressed as: Storage: S=36000 + 18000y m³, Outflow Q=10y m³/s, where y is height of water above spillway crest in m. Route an inflow hydrograph which can be approximated by a triangle as: 1=0 at t=0, 1=30 m³/s at t=6 h and I = 0 at t = 26 h Assume at t= 0.y=0 and use At = 2 h
7.Reynolds found laminar flow occurs when Re<1000 and turbulent occurs when Re<4000 O true O False
Civil Engineering 1. A main irrigation canal with a bed width of 2.5 meters and a side slope of 1.5 vertical, 2 horizontal is to be constructed at a uniform land slope/gradient. The capacity of the stream is 35 m³/s. If n=0.025, determine depth and the slope of the land. Show the full solutions and formula used.
A wide river with a water surface elevation 1/8000 of depth of flow D. If the depth of flow in the river is decreased by one third and the surface slope is decreased by 40%. If he ratio of the discharge is 2.58. Determine the percentage change in discharge. A 70.25% B-61.24% C 61.24% D -70.25%
Example 6.8 For the following flows, determine the components of rotation about the various axes. (a) u = xy®z, v = - y°z2, w = = yz? y°z? 3 3 (b) u = 3xy, v = とミ 2 (c) u = y, v = – ấr V = -
In a rectangular open channel, 2.0 m wide, water flows at a depth of 0.8 m. It discharges over an aerated sharp crested weir over the full width, with depth over weir crest being 0.25 m/ Cc = 0.61. Adjusting for velocity head of approach, what would be the discharge through the channel? √29= 4.43 units.
2. For an incompressible and Newtonian flow, show that:
Solution added
C is roughness coefficient. Hazen Williams Formula: H?=10.67??^1.85/?^1.85?^4.87
If u = xy + λy³x. v = -0.5y² + 6x³z and w = 5y²x - y³z + x, then for a steady and incompressible flow, value of λ will be