16. In performing water content determination, the readability of the balance for specimen greater than 200 grams is ... A. 0.01 B. 0.001 C. 0.1 I D. 1 17. Which of the following clay mineral has a range of liquid limit between 55-120%? A. Illite B. Montmorillonite C. Kaolinite 18. True or False. Peat and highly organic soils can have water contents up to about 500%.

16. In performing water content determination, the readability of the balance for specimen greater than 200 grams is ... A. 0.01 B. 0.001 C. 0.1 I D. 1 17. Which of the following clay mineral has a range of liquid limit between 55-120%? A. Illite B. Montmorillonite C. Kaolinite 18. True or False. Peat and highly organic soils can have water contents up to about 500%.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Coarse sand and medium sand (assuming same mineralogical composition) will have the same particle density. True False
A sample of gray silty clay has a mass of 126 kg. Laboratory tests results give a moist density(ρ) of 2.05 g/cm3, a specific gravity of solids (Gs) of 2.67, and a moisture content (w) of 14.7%.First determine all entries in the phase diagram. Then determine the void ratio (e), the porosity(n), the degree of saturation (S), the dry density (ρd), the dry unit weight (γd), and the moistunit weight (γ).
A sample of saturated clay was placed in a container and weighed. The weight was 6N. The clay in its container was placed in an oven for 24 hours at 105˚C. The weight reduced to a constant value of 5N. The weight of the container is 1N. If Gs = 2.7, determine: a) Water Content b) Void Ratio c) Bulk Unit Weight d) Dry Unit Weight e) Effective Unit Weight
Laboratory test results for a sample of clay soil for the purpose of evaluating the potential for volume change (swelling, expansion) are shown Liquid limit = 60% %3D Plastic limit = 24% %3D Particles smaller than 0.002 mm = 44% %3D Compute the plasticity index O 44 68 O 24 O -44
The liquid Limit and plastic limit of a soil are 35% and 15% respectively. If the flow index is 10%, then toughness index is
A clay sample has a void ratio 0.50 in dry state and specific gravity of solids is 2 .7 then its shrinkage limit is (in %)
Problem#1: An undisturbed sample of silty sand was brought to the laboratory at its natural water content, and the following measurements were made: Total mass at the natural water content: 1523.6g Mass of oven-dried sample: 1318.3g Total volume of sample: 728.2cm3 Density of the mineral solids: 2.7g/cm3 Calculate the porosity n, void ratio e, volumetric water content 0 and dry bulk density pb.
A certain saturated sand (S = 100%) has a moisture content of 27.9% and a specific gravity of solids of 2.61. It also has a maximum index void ratio of 0.90 and a minimum index void ratio of 0.33. Compute its relative density and classify its consistency. (Table on the right) Solution: Given the values of mmoisture content, specific gravity and degree of saturation, the void ratio can be estiamted as: e = Thus the relative density is found to be Dr = • According to the table, the soil is classified as %; soil. TABLE 3.3 CONSISTENCY OF COARSE-GRAINED SOILS AT VARIOUS RELATIVE DENSITIES (data from Lambe and Whitman, 1969) Relative Density, D,(%) 0-15 15-35 35-65 65-85 85-100 Classification Very loose Loose Medium denseª Dense Very dense "Lambe and Whitman used the term "medium," but "medium dense" is better because "medium" usually refers to the particle size distribution.
It is needed to determine the moist unit weight of the soil for field compaction testing. A silty soil sample has a mass of 612 grams. The soil sample was then covered in beeswax and the combined weight was 650 g. The soil covered in wax, was then immersed in the water and the graduated cylinder registered a volume difference of 404 ml. The wax was gently peeled off the soil. Moisture content = 12% Specific Gravity = 2.78 But if the wax has a specific gravity of 0.94, determine the following: Dry unit weight of the soil Void ratio of the soil % of air in relation to the soil solids of the sample
1.4 A soil specimen is 38 mm in diameter and 76 mm long and in its natural con- dition weighs 168.0 g. When dried completely in an oven the specimen weighs 130.5 g. The value of G, is 2.73. What is the degree of saturation of the specimen?
During Atterberg limit tessts in the Naboratory,the studens obtained the following results froma clayey soil. Wumber of Blows (N) Molsture Content \ 38/4 16 36/5 20 33.1 28 2/7 0 Plastic limit tests: Students conducted two trials and found that PL= 17 2% for the first trial and PL = 18.4% for the second trial. Assume that the liquid limit of the soil iS LL= 29.0% a. Determine the flow index. b. Determine the liquidity index of the soil if the in situ moisture content is 22.0%.
The wet weight of a soil specimen is 207 g. The dried weight of the specimen is 163 g. If the volume of the specimen is measured before drying is 110 cubic centimeter, determine the Void ratio if specific gravity of solids is 2.68.