A 22-mm-diameter steel [E = 194 GPa; a = 11.8x10-6/°C] bolt is used to connect two rigid parts of an assembly. The bolt length is a =155 mm. Determine the minimum clamping force that must be provided by the bolt when T₁ = 15°C so that the clamping force it exertswhen T₂ = 60°C is at least 2.0 kN.aAnswer: F₁ = iKN

Answered: Image /qna-images/answer/2aa55901-5477-40a2-a677-0961c7084700.jpg

Answered: 155 mm. Determine the minimum clamping…

Engineering

Civil Engineering

155 mm. Determine the minimum clamping fo when T₂ = 60°C is at least 2.0 kN. a

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A rectangular beam has a width of 300 mm and an effective depth to the centroid of the tension reinforcement of 500 mm. The tension reinforcement consist of 6-25 mm ø bars placed in two rows. Compression reinforcement consisting of 2-25 mm ø bars placed 62.5 mm from the compression face of the beam.f’c= 27.58 MPa, fy= 413.7 MPa. a)Determine the depth of the compression block b)Determine the maximum steel ratio c)Determine the design moment capacity of the beam
The pipe assembly is subjected to the force of F = {600i + 800j - 500k} N. Determine the moment of this force about point A.
2. The pipe assembly is subjected to the force of F = (600i + 800j - 300k) N. Determine the moment of this force about Points A and B, specifically. 0.5 m B. 0.4 m 0.3 m 0.3 m
Please solve the follow up qestion.
2
"D.60. Compute the ultimate strength capacity of the positive moment beam design below. f'c= 28 MPa, fy= 414.6 MPa, bf= 760 mm, t= 85 mm, hw= 440 mm, bw = 420 mm ds= 10 mm, ct= 30 mm, cb = 35 mm. Steel bar details: compression side at top (single layer): 3 - 16 mm dia. , tension side (double- layered): upper layer is 4 - 28 mm dia. and lower layer is 4 - 28 mm dia." Use the editor to format your answer br Ct t Bar diameters and positioning in the figure given are just representations. Refer to the problem ds hw statement for the number of bars and bar diameters to use in your computation. 25 mm Cb bw
Please help, I promise to give good feedback. Please do not just guess. Thank you!
Determine the maxi mum shear stress deue loped in the beam 5 KN/m Ø4 cm Ø3 cm 3 N/m 0.2 m 0-2m 0.2
Plz provide diagram
Two plates each 25 mm thick and 130 mm wide are fastened by three 20 mm diameter rivets. Assume that the applied load P = 70 kN is distributed equally among the three rivets. Determine the tensile stress (MPa) in the plate at the critical section. Determine the bearing stress (MPa) in each rivet. A 18.18 (А) 53.05 B) 21.82 В) 46.67 900 c) 25.45 c) 74.27 P. D) 26.67 D) 33.95