1500 lb 4500 b A 2.5 m. E NA- ID 1- 96 in. 8 ia

Q: 5. A metallic top-hat stringer reinforced wing skin (function of the material A=150) has a width of…

A: The function of the material = 150Width =1.5 mUnsupported length =0.5 mApplied compressive load =120…

Q: A mild steel bar, 1.5 m long, has a square section 40 mm x 40 mm. The bar is subjected to a two-…

A:

Q: Link AB is to be made of steel for which the normal stress is 450 MPa. Determine the cross-sectional…

A: Given data,  Normal stress = 450 MPa Angle = 35 ° Point load = 20 kN UDL = 8 kN/m To find out the…

Q: (2) The cantilever beam is subjected to the load P and has cross section as shown. What is the ratio…

A: when a point load acts on cantilever top portion is under tensile stress and bottom is compressive

Q: The bending stress in a beam is section modulus. O(A) Inversely proportional to two times O(B)…

A: Bending stress equation : Bending stress =σMoment of inertia =IBending Moment =MVertical distance…

Q: 2. For the truss shown below, determine the stress in members AC and BD. The cross-sectional area of…

A:

Q: Problem 4: The beam is made from three boards nailed together as shown. If the moment acting on the…

A: Given Three wooden planks are nailed together and a moment of 650 N-m is applied.  Required  A-…

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.