(2) The cantilever beam is subjected to the load P and has cross section as shown. What is the ratio of the magnitudes of the maximum tensile and compressive flexural stresses over the a-a cross section? b. 3/7 с. 7/3 f. 10/2 i. 1/1 а. 7/2 e. 3/10 h. 10/3 d. 2/10 g. 2/7 250 mm- 20 mm 60 mm i C 200 mm -2 m -1 m 15 mm 15 mm

Q: I would appreciate it if you could explain what you mean when you say "GIS."

A:

Q: Why are Construction Photographs needed?

A: There are various reason for the Need of construction photograph some of them are mentioned here:

Q: Any recommended papers or txt books on this matter?

A: The answer provided for the given question is a perception how wastewater treatment works. The…

Q: can you reorganize this please? Its a bit confusing to read and understand

A: Given data ,  water content = 45% The density of the solid particles  = 2500 kg/m3   To find out the…

Q: Describe government standards?

A: Government is defined as the group of people or a system in operation which has the right of…

Q: 14.1 What is the meaning of the acronyms CMU, URM, UMB?

A: To find : Meaning of acronyms CMU, URM and UMB

Q: What is the role of Internet of Things (IoT) in construction safety?

A: The Internet of Things (IoT) plays a significant role in enhancing construction safety in several…

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.