150 mm 250 mm 30 N 300 mm 500 mm х Prob. 2–111

Q: 2) The truss is carrying two masses m (mg=100 N). It is supported by a rope at A and pin support at…

A:

Q: SITUATION. The suspended load exerts a force F-800lbs at A and bar OA weighs 300 lb. Assume that the…

A:

Q: The frame ABCD in figure 6, has two cables tied at B, BG and BH. If the tension in cable BG is 1000N…

A: FBG = 1000 N FBH = 1500 N Find: (a)  The moment about A of the force exerted at point B by both…

Q: P-11 The 10-kg collar A and 20-kg collar B are held in place on the smooth bars by the 3-m cable…

A:

Q: Cable OA is used to support column OB and exerts a force of 9 kN on the column at O: (a) Determine…

A: Given: a= 5m, b = 3m, c=9m Required : Angle between OA and OC length AC projected component of 9KN…

Q: Q.4) Rod AB is in the x-y plane and supported by two cables as shown. The tension in cable AC is 910…

A:

Q: Calculate the tension in the cable, and the reactions at A and C 100 mm 100 mm 300 mm 400 N C 400 N…

A:

Q: Determine the tension in cable AB and the horizontal and vertical reaction components pin C exert on…

A:

Q: 10- The antenna OD shown is supported by the three cables as shown. D(0,0,40) i- The unit vector of…

A: Given data: antenna OD is supported by the three cable.

Q: 2.123 A container of weight Wis suspended from ring A. Cable BAC passes through the ring and is…

A: Given: W = 270 lb The tension is the same in both portions of cable BAC. Solution: Free body…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A:

Q: Problem 4) Assume the loads applied to the beam result in a uniformly horizontally distributed load…

A: A loaded beam is given in the as shown and it has been asked to determine intensity of uniformly…

Q: F1=100N Let F₁ = [F1] N and let F₂ = 350 N. g) Determine the magnitude FA of the force at pin A. h)…

A: Given:F2=350 NSupport A is a hinge support.Therefore, there will be two support reactions( 1…

Q: The rigid body ABC is held in place by ball and socket joints at A and C, and cable DE which passes…

A: Given: Ball and socket joint at A and C  Point coordinate: A, (0,0,600) B, (600,0,600) C, (800,0,0)…

Q: Q.3) The L-frame in figure below supports forces from two cables. Cable "EAD" passes through a…

A: Given: Force in cable EAD = 800lb and in OCG = 400lb Required  Moment about point B, A and O.

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.