Find the equivalent capacitance between points A and B forthe group of capacitors shown in Figure 21-39. 15 FB82F22 uFA FIGURE 21–39 Problems 68 and 72

Answered: Image /qna-images/answer/1a98ed75-ead3-4c6f-bcaf-b8ac28d68f42.jpg

Answered: 15 F 8.2pF 22 F

Science

Physics

15 F 8.2pF 22 F

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter8: Capacitance

Section: Chapter Questions

Problem 8.3CYU: Check Your Understanding The radius of the outer sphere of a spherical capacitor is five times the...

See similar textbooks

Related questions

Q: The resistance of a uniform copper wire 50.0 meters long and 1.15 mm in diameter is 0.830 ohms at…

Q: Ο 3 Ω Α 9Ω Α Ο 18 Ω 9 V

Q: 16 Which of the following, on average, has the highest electrical resistance value? F Conductors G…

A: Let's check each option one by one F Conductors Incorrect conductors are the good conductor of…

Q: 6. The only metal that is a liquid at room temperature is O Copper O Silver O Mercury O Sodium

Q: Determine the experimentally resistance (R) from the slope, and calculate δ%.

A: Given data The first observation for voltage is, V1=24.00 V The second observation for voltage is,…

Q: 3. Two Resistances R1 = 3 N and R2 = 6 N are connected in series with an ideal battery supplying a…

A: R1 = 3 ohm R2 = 6 ohm ∆V = 9 volts

Q: 1. At 20.0°C, the carbon resistor in an electric circuit connected to a 5.0 V battery has a…

A: The objective of the question is to find the current in the circuit when the temperature of the…

Q: 1. A temperature-stable resistor is made by connecting a resistor made of silicon in series with one…

Q: 5. The temperature of a sample of tungsten is raised while a sample of copper is maintained at…

Q: In (Figure 1), let Cı = 2.90 µF, C2 = 5.40 F, and Vab = +63.0 V.

A: Answer Part c Value = 40.988 unit =Volt Part D…

Q: 1. The ballistic pendulum is a simple device to measure projectile velocity v by observing the…

Q: A silver wire is 6.9 m long and 0.79 mm in diameter. What is itsresistance?

A: Given: The length of the wire is L=6.9 m. The diameter of the wire is d=0.79 mm. The…

Q: 2. A 50 m long wire with a cross-sectional area of 5.5 mm2 has a resistance of 31 Ω at 0 °C.…

Q: 1. At 20.0°C, the carbon resistor in an electric circuit connected to a 5.0 V battery has a…

A: The objective of the question is to find the current in the circuit when the temperature of the…

Q: An electric iron operating at 120 volts draws 10 amperes of current. How much heat energy is…

A: Potential difference V = 120 volts. Current I = 10 A. Time t = 30 s. Energy E = V x I x t

Q: A device which tests the resistance to wear of two materials A and B is shown. If the link EO has a…

Q: 1. The current passing through a resistor in a circuit is 0.37 A when the voltage across the same…

Concept explainers

Proper Length

The theory of special relativity explains the connection between space and time to objects that move in a straight line at a constant speed. The objects move at the speed of light. When an object approaches light speed, its mass is endless and cannot move faster than light. The most crucial postulate of Einstein's special relativity is that the laws of nature do not change in each frame of reference.

Question

Find the equivalent capacitance between points A and B for
the group of capacitors shown in Figure 21-39.

15 F
B
82F
22 uF
A FIGURE 21–39 Problems 68 and 72

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1 Given

Step 2 Calculation

Step 3 Calculation

Step 4 Result

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Check Your Understanding Determine the net capacitance C of each network of capacitors shown below. Assume the C1= 1.0 pF, C2=2.0pF, C3=4.0pF, and C4=5.0 pF. Find the charge on each capacitor, assuming there is a potential difference of 12.0 V across each network.
Check Your Understanding When a cylindrical capacitor is given a charge of 0.500 nC, a potential difference of 20.0 V is measured between the cylinders, (a) What is the capacitance of this system? (b) If the cylinders are 1.0 m long, what is the ratio of their radii?
Check Your Understanding The potential difference across a 5.0-pF capacitor is 0.40 V. (a) What is the energy stored in this capacitor? (b) The potential difference is now increased to 1.20 V. By what factor is the stored energy increased?
(i) A battery is attached to several different capacitors connected in parallel. Which of the following statements is true? (a) All capacitors have the same charge, and the equivalent capacitance is greater than the capacitance of any of the capacitors in the group, (b) The capacitor with the largest capacitance carries the smallest charge, (c) The potential difference across each capacitor is the same, and the equivalent capacitance is greater than any of the capacitors in the group. (d) The capacitor with the smallest capacitance carries the largest charge. (e) The potential differences across the capacitors are the same only if the capacitances are the same, (ii) The capacitors are reconnected in series, and the combination is again connected to the battery. From the same choices, choose the one that is true.
Check Your Understanding The capacitance of a parallel-plate capacitor is 2.0 pF. If the area of each plate is 2.4 cm2, what is the plate separation?
If you wish to store a large amount of energy in a capacitor bank, would you connect capacitors in series or parallel? Explain.
When discharging a capacitor, as discussed in conjunction with Figure 21.39, how long does it take for the voltage on the capacitor to reach zero? Is this a problem?
Suppose that the capacitance of a variable capacitor can be manually changed from 100 pF to 800 pF by turning a dial, connected to one set of plates by a shaft from 0° to 180°. With the dial set at 180° (corresponding to C — 800 pF), the capacitor is connected to a 500-V source. After charging, the capacitor is disconnected from the source, and the dial is turned to 0°. If friction is negligible, how much work is required to turn the dial from 180° to 0°?
Check Your Understanding Repeat the calculations of Example 8.10 for the case in which the battery remains connected while the dielectric is placed in the capacitor.
What If? The two capacitors of Problem 13 (C1 = 5.00 F and C2 = 12.0 F) are now connected in series and to a 9.00-Y battery. Find (a) the equivalent capacitance of the combination. (b) the potential difference across each capacitor, and (c) the charge on each capacitor.
Check Your Understanding Continuing with Example 8.12, show that when the battery is connected across the plates the energy stored in dielectric-filled capacitor is U=kU0 (larger than the energy U0 of an empty capacitor kept at the same voltage). Compare this result with the result U=U0/K found previously for an isolated, charged capacitor.
(i) Rank the following five capacitors from greatest to smallest capacitance, noting any cases of equality, (a) a 20-F capacitor with a 4-V potential difference between its plates (b) a 30-F capacitor with charges of magnitude 90 C on each plate (c) a capacitor with charges of magnitude 80 C on its plates, differing by 2 V in potential. (d) a 10-F capacitor storing energy 125 J (e) a capacitor storing energy 250 J with a 10-V potential difference (ii) Rank the same capacitors in part (i) from largest to smallest according to the potential difference between the plates, (iii) Rank the capacitors in part (i) in the order of the magnitudes of the charges on their plates, (iv) Rank the capacitors in part (i) in the order of the energy they store.