The water tank has a paraboloid-shaped roof. If one liter of paint can cover 3 m2 of the tank, determine the number of liters required to coat the roof. (144 – x²)12.5 m-12 mProb. 9-112

The equation of the roof is, Differentiate the above equation with respect to x. The length of the…

Answered: (144 – x²) 12.5 m -12 m Prob. 9-112

Engineering

Civil Engineering

(144 – x²) 12.5 m -12 m Prob. 9-112

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: limitation of reverse osmosis water treatment technology

Q: Calculate "exact" alkalinity of the water containing 130 mg/L of bicarbonate ion, 25.00 mg/L of…

A: Given: HCO3-=130 mg/lCO3-=25 mg/lpH=9.3

Q: A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The…

A: For the water storage tank, well mixed at internal temperature 60°C Total Exterior surface area =…

Q: How does an estimate of chlorinity allow us to determine salinity? Explain what principle is…

A: Chlorinity is the weight of chlorine molecules in grams per kilogram of saltwater or seawater after…

Q: Sketch and describe briefly typical process of raw water treatment system.

A: The natural water which is not subjected to any artificial treatment is known as raw water. The…

Q: What are the disadvantages of surface condensing systems?

A: The surface condenser is indirect heat exchange and the vapor and condensing medium is separated by…

Q: What are the advantages of surface condensing systems?

A: The surface condenser advantages as follows: 1. The atmospheric phenomenon is used as boiler feed…

Q: 1. To finish the design of the effluent discharge channel, determine the amount of activated carbon…

A: Step 1: try to write down equation Step 2: simple mole calculation Step 3: weight of carbon Step…

Q: Describe recuperation test for an open well.

A: Recuperation test

Q: An activated sludge system (sketched below) is operating at equilibrium with the following…

A: Given data- Flow rate Q=500 m3/hr, BOD=150 mg/L, MLSS=2000 mg/L, Volume V=4000 m3, To Find- The…

Q: A plant treating 189.25 MLD of water is using 50 mg/L of alum [Al(SO,)3-14.3H;0] as a coagulant. The…

Q: Although gas station owners lock their tanks at night, a gas station owner was the victim of theft…

A: Given that, Specific gravity of gasoline = 0.733 Density of gasoline = 733 kg/m³

Q: Predict the total pressure drop for a wood chip and compost bio-filter that is 1,5 m deep with 50%…

A: Simply a layer of different organic filter is called biofilter. A mixture of compost and wood chips…

Q: Calculate the size of the septic tank in your home according to the number users in your home.

A: As per company's guidelines we can only answer first question. Kindly post other questions as…

Q: Disinfection, sedimentation, flocculation, coagulation, and filtration are processes for a surface…

A: Coagulation is defined as a water treatment process in which chemicals which are known as coagulants…

Q: Draw a graph showing the emulsification breaker effect over time points (W X Y Z) .

Q: Determine the number of gallons of latex paint that will be used to paint the side of the house…

A: Given, Cross sectional of a house 30 sqm coverage per gallon of latex paint

Q: For a fixed gas flow rate and drift velocity, calculate the ratio of plate areas for two…

A: The relation between area of plane and efficiency of precipitator is as follows : A=-QWEln(1-n)…

Q: A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The…

Q: The surface water with 6000 m³/d of flow rate will be treated for hardness removal using lime-soda…

A: The steps to solve this are: 1. Find total hardness and ALkalinity 2. Find Carbonate hardness and…

Q: An aerated grit chamber receives wastewater at a peak flow rate of 41,920 m³/d. If the depth of…

A: Given data: Q=41920 m3 /day Depth =2m Velocity = 0.2 m/sec

Q: lorine concentration to inactive 2 logs of Cryptosporidium at a water temperature of 25oC, if the…

A: Vb =QKlnNoN , Vb = volume of compact chamber =2×2×1 =4m3 Q =…

Q: Potential buyers of a house ask for an inspection prior to the purchase. The inspector notes that…

A: Introduction- A basements, often known as a basement, is one or more floors of a structure that are…

Q: A desalination RO membrane system operates with an incoming salt water flow rate of 1,000 m3 / h,…

A: Let Q1 be the discharge and C1 be the concentration of the chemical from channel A. Let Q2 be the…

Q: Q4-B/ (6.0 Marks) In titration for alkalinity (5.0 ml) of 0.02N Sulfuric acid is used to reach the…

A: The alkalinity of water can be attributed to the presence of hydroxide ions (OH⁻), carbonate ions…

Q: A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The…

Q: 3. Problem 5-18 (modified), Davis and Cornwell, Introduction to Environmental Engineering, 6th Ed.:…

Q: How many gallons of 12-percent sodium hypochlorite solution are needed to disinfect a reservoir 20…

A: Given data: Hypochlorite strength = 12% Diameter of the reservoir D=20 ft Depth of the reservoir h=6…

Q: A batch drier removes water from a solid material at a rate of 30 lb/hr during the constant rate…

Q: Define the numerous kinds of vibratory compactors that are utilized in the compaction process.

Q: Discuss the principle, construction, operation, uses, advantages and disadvantages of Evaporating…

Q: A large rank contains 100 gal of brine in which 10 lb of salt is dissolved. Brine containing 0.2 lb…

A: Here as given, Brackish water containing 0.2 lbs entering tank at 6gal/min Salt entering tank rate=…

Q: Compute the quantities of lime and soda required to soften raw Ex water containing alkalinity of 220…

Q: b. Find the DO at 12 10. A water treatment plant treats the water at the rate of 33 MGD. Average…

Q: what is the effect of alkalinity on flocculation?

Q: 3. Following information obtained from the Cooper's Town water reservoir. To complete a 100,000 m³/d…

A: Let's address each part of the question based on the provided water chemistry data from Cooper's…

Q: 1. A natural water with a flow of 4.0 MGD is to be treated with a commercial-grade alum dosage of 80…

Q: A 14 mgd wastewater treatment plant has a primary clarifier that treats an influent with 800 mg/L of…

A: The given data is: The waste-water discharge. Q=14 mgd The solid concentration, C=800 mg/l The…

Q: A roof system has a total surface area of 3,450 sf, which will be covered by 3-tab asphalt shingles…

A: The total surface area is 3450 sf. It is known that in Asphalt 3-Tab Roof Shingles, there are 26…

Q: Explain what is meant by permeability and describe how to interpret the permeability ratings of…

Q: This rectangular duct is to be wrapped with insulation. How many inches ofinsulation are needed to…

A: The duct is rectangular with width as 16 in and height as 8 in. Consider the insulation material has…

Q: If a surface is 40% impervious, how much rainfall is absorbed, how much runs off?

A: If a surface is 40% impervious, it means that 60% of the rainfall is absorbed and 40% of the…

Question

The water tank has a paraboloid-shaped roof. If one liter of paint can cover 3 m² of the tank, determine the number of liters required to coat the roof.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 10 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Describe the difference between primary, secondary, and tertiary water treatment.
2. a) A Co-60 source gives a dose rate of 400 μSv/hr at 1 m. At what distance from the source must a barrier be placed if the dose rate at the barrier must not exceed 25 μSv/hr? b) Using the values of HVL, calculate the thickness of the following materials w/c would give the same protection at the original distance of 1 m from the source: lead, concrete (HVL lead = 1.1 cm, HVL concrete = 6.3 cm)
Sketch a typical treatment process scheme for the treatment of raw water containing a turbidity of 19 NTU, Mn concentration of 0.07 mg/L, Fe concentration of 0.3 mg/L, TOC of 2 mg/L, coliform (#/mL) 800 and color of 18 CU.
to remove surface water on highway surface must be used * O cross slope O shoulder slope curb and gutter O side slope
The shake-deflate baghouse on the power plant has 12 compartments, each with 100 bags (cylindrical) that are 0.2 meter in diameter and 7 meter long. Total gas flowrate is 300,000 m3/h which carries 60 g/m3 of particulate matter concentration. The pressure drop of a freshly cleaned baghouse is found to be 250 Pa, while the bags are operated until the pressure drop of 750 Pa. The cleaning frequency is twice per hour. The particle collection efficiency is 95%, and filter
discuss the materials requirement as per Indian standards for RCC water tank. considering , leakage , low permeability and durability.
A well-mixed, insulated water storage tank is to be maintained at internal temperature 60°C. The environmental temperature around the tank varies from -25°C to 30°C. The tank's exterior surfaces (total = 125 m²) have four different levels of insulation as indicated in the table. Surface Component Area, Effective RSI, 2 2 m². °C/W m² Surface A 60.0 Surface B 30.0 Surface C 30.0 Surface D 5.0 Say that just one surface can be selected to have its insulation upgraded such that its effective RSI would be doubled. Which should be selected to achieve the greatest reduction in heat loss? 10.0 15.0 4.0 0.5
a) Draw a neat sketch of Activated Siudge Process and discuss how SVI, return sludge wasted sludge and organic load effect the design of aeration tank in activated sludge process?
Please help!
Direction: An activated sludge system (sketched below) is operating at equilibrium with the following information. Waste water related data: flow rate=500 m³/hour, influent BOD = 150 mg/l, effluent BOD = 10 mg/l. Aeration tank related data: hydraulic retention time = 8 hours, mean-cell-residence time=240 hours, volume = 4000 m³, mixed liquor suspended solids = 2000 mg/l. Influent, Aeration tank Secondary Effluent clarifier Sludge recycle Solids wasted 2. The mass (in kg/day) of solids wasted from the system is
Subject environmental engineering solve question 12
question below