14. A bar of 2 m length, 20 mm breadth and 15 mm thickness is subjected to a tensile load of 30 kN. Find the final volume of the bar, if the Poisson's ratio is 0.25 and Young's modulus is 200 GN/m². Be 600

Q: Calculate the maximum stress in a 5mm thick steel plate with an 18 mm diameter round hole, given h…

A: Given,Thickness of steel plate = 5 mmH gross = 12 cmTensile load = 8.5 KNTo find - maximum stress in…

Q: A hanger rod is stressed to 0.9167 N/mm2 , when a tensile load of 18 N is acting on it as shown in…

A:

Q: Find the final length of the bar of an aluminum alloy with a modulus of elasticity of 68.8 GPa,…

A:

Q: The is a rope that just cannot stretch more than 0.6 cm from a tensile force of 500N without…

A: Given: Tensile force applied on the rope, T=500 N mass of the rope, m=0.5 kg length of the rope,…

Q: An AISI 1020 steel rod 22 feet long is anchored between two rigid supports. At 90 degrees Fahrenheit…

A: For AISI 1020 steel rod, E=29000 ksi=29×106 psi and α=6.5×10-6 in/in.°F. Let Ti be the initial…

Q: 1. A frame is shown to the right. The link BC is t = 6mm thick (into the page) and has width, w…

A:

Q: You are given a square rod of 6061-T6 aluminum (cross-section = 4mm X 4mm, length = 2.3m).  The…

A:

Q: Give the following problem a try. If you get stuck, here is one way to work it: Essential Solution…

A:

Q: A composite section 2 m in length, consisting of a steel tube with outer diameter 24 mm and…

A: Given data: Calculate the inner diameter of the steel tube.

Q: In a standard tensile test a steel rod of 7/8 in. in diameter is subjected to a tension force of 17…

A: given data - v= 0.25 to determine - ratio of G/D

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.