14) Calculate the strong-axis plastic moment capacity Mp of the built-up section made up of a channel section and two L80x80x10 angle sections (all are of S275 steel: Fy = 275 MPa and Fu = 430 MPa) given that the strong-axis moment of inertia Ix of the channel section is 6.7x10" mm* and the shape factor for the channel section is 1.25. channel section built-up section 300 mm ww 008

Q: The cantilevered W530 x 150 beam shown is subjected to a 8.5-kN force F applied by means of a welded…

A: F=8.5kN To find equivalent couple force system at point O

Q: 01. Consider the beam cross section shown below: = 3 in? = 60 ksi = 3 ksi = 7.5V(Sc) = 7.5v(3000…

A: As the beam specifications are given: As=3 in2 fy=60 ksi fr= 7.53000 psi=0.41 ksi Es=29000 ksi…

Q: Consider the simply supported truss as defined in the figure and parameter table. Find the force in…

A:

Q: Refer to the Column Interaction Given: F’c = 27.5 Mpa Fy = 414 Column diameter 400mm Main bar…

A: Step 1: Refer to the interaction Diagram so you can find the pg. and use the formula for the Area…

Q: Deflection Given: the beam cross-section shown have the following cross-sectional properties  f'c…

A: Gross moment of inertia(Ig)Critical internal moment(Mcr)Maximum service load(Ma)Critical moment of…

Q: 4-43 The center post B of the assembly has an original length of 124.7 mm, whereas posts A and C…

A: The normal stress at A(&C) and B is 189.315 MPa and 21.3675 MPa, respectively.Explanation:From…

Q: 40KN The beam, having the cross-section «I», is 60kNm subjected to a loading as shown in the figure.…

A: Any Beam or structure under the application of loading shows the bending deformations due to that…

Q: The idealize model for suspension bridge is shown in the figure. The truss are pin connected at a,…

A: We have to determine the design diameter of the cable if the allowable tensile stress is 150 MPa and…

Q: Determine the maximum tensile and compressive bending stress in the beam if it is subjected to a…

A:

Q: 00144 0.01am 0.09m 0.0144m 0.09m For the beams shown below: 1- Draw shear force and bending moment…

A: Note:-As per the guidelines we are only supposed to answer first question. With three sub parts.…

Q: 1- The reactions at A and E. 2- The deflection at C.

A:

Beams

In structural engineering, a beam is a component made of a variety of materials (including steel alloys, and wood) that can resist loads applied laterally to the beam axis. Members, elements, rafters, shafts, and purlins are all terms used to describe beams.