13. A vertical sided rectangular tank ABCD is to be constructed such that sides AB and AD have lengths 60 m and 30 m, respectively. The formation level is to change uniformly from 82 m above datum along AD to 80 m above datum along BC. Readings were taken with a level in the following order: Rod Reading (m) Rod Station BM near A BS 1.085 Elev 87.64 m IFS 2.230 GL at A IFS 2.580 GL at D FS 1.755 GL at E (The intersection of AC and BD) BS 1.595 GL at E IFS 0.995 GL at B FS 1.145 GL at C Estimate the amount of excavation required in the construction of the tank.(GL-ground level)

Q: A hydraulic jump occurs in a rectangular channel having a discharge of 3.45 m^3/s of water per meter…

A: as per guidelines provided to us we are restricted to solve only 1 question if multiple question are…

Q: hould be the height of the water, h, in the cut so that the stability of the saturated clay is not…

A:

Q: 3, m 21 8.5 m B (6.2. 3.0) 4.4 kN *, m a) At pcint o. k) KN k) kN-m

A:

Q: A) What is the over Consolidated Ratio (OCR) at the midpoint of the clay layer? B) What is the total…

A: Given:Required:Over consolidation ratio Total horizontal stress at midpoint of clay layer

Q: The soil material is supported by a retaining wall to a height of 6m. The unit weight of soil is 16…

A:

Q: raw the total, effective and PWP diagrams for the following soil profile. The ground water was…

A: Total stress at a layer present at a certain depth below ground level is the total weight of the…

Q: In a 6-ft Parshall flume, the gage reading in the approach well is 2 ft. The submergence is 90%, for…

A: W = 6 ft (width of the Parshall flume)H = 2 ft (headwater depth)Correction factor = 14

Q: A sight is taken with an Engineer's Level at rod held 200 meters away and an initial reading of 2.3…

A: Given data,distance=D=200minitial reading of 2.3 metersnumber of division=n=7final reading=1.7length…

Introduction to Engineering Design

Students are often confused with engineering and design. The term engineering design has two words with different meanings, engineering, and design. The term engineering implies applications of laws and principles of science to design and analyze physical structures and components. In civil engineering, students apply the concept of physics and chemistry to design and build structures and buildings. In engineering disciplines, the term design means determining the dimensions, loads, and associated influences on the component due to the applied loads such as stresses and deformations. The estimation of such parameters is crucial to make the component or structure foolproof.