13-3 A refrigerant 22 refrigerating system operates with a condensing temperature of 35°C and an evaporating temperature of -10°C. If the vapor leaves the evaporator saturated and is compressed isentropically, what is the COP of the cycle (a) if saturated liquid enters the expansion device and (b) if the refrigerant entering the expansion de- vice is 10 percent vapor as in Fig. 13-3? Ans. (a) 4.71, (b) 4.20 13-4 Refrigerant 22 at a pressure of 1500 kPa leaves the condenser and rises vertically

13-3 A refrigerant 22 refrigerating system operates with a condensing temperature of 35°C and an evaporating temperature of -10°C. If the vapor leaves the evaporator saturated and is compressed isentropically, what is the COP of the cycle (a) if saturated liquid enters the expansion device and (b) if the refrigerant entering the expansion de- vice is 10 percent vapor as in Fig. 13-3? Ans. (a) 4.71, (b) 4.20 13-4 Refrigerant 22 at a pressure of 1500 kPa leaves the condenser and rises vertically

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

4. Describe each of the three methods of heat transfer, in your own words. Make sure to explain how you can tell that that kind of heat transfer is happening.a. Conductionb. Convectionc. Radiation
Which of the following will have a higher rate of heat transfer. With conduction heat transfer. A. pulverized shale stone B. the stone and the pulverized shale will have the same heat transfer as they have the same conductivity constant. C. a solid block of shale stone D. the pulverized shale will have a higher heat transfer as it has a higher duction coefficient
Give two reasons why it is important to pay attention thermal expansion and contraction in real life situations.
Subject: Thermodynamics IPlease present your solution in a readable and orderly manner.
An electric hot water heater consumes 3.1 kilowatts of electricity and converts it to heat. How long will it take the water heater to heat a 67 gallon tank of water from 10 degrees Celsius to 50 degrees Celsius? (1 kilogram of water is 0.37 gallons, 1 Calorie = 4200 J). It may be helpful to refer back to the weekly handout for guidance on this problem. Your final answer should be in minutes (rounded to the nearest 10 minutes).
1. Discuss all the processes involved in engineering design 2. The resistance of a copper wire used to make a motor is 0.5 Ω at 25 oC and 0.8 Ω at the motor’s operating temperature. Determine the operating temperature and the rise in temperature of the motor, given that copper has a temperature constant of 234.5 oC. 3. What are the possible energy sources and energy transfer systems of a purely mechanical machine?
. thermodynamics- A platinum resistance thermometer has a resistance of 5 ohm at 0°C and 2.5 ohm at 100°C Calculate the temperature when the resistance indicated is 10 ohm.
Q1: If a calorimeter is not assumed to be adiabatic, how would one calculate the heat transfer? Guide Questions: What are the parameters to be considered and the equations to be used? What law of thermodynamics does this transfer of heat to the surroundings touch? Is an adiabatic system automatically considered as a closed system? Please help me understand by also attaching a reference/book/journal article. This would help me in my essay. Thank you.
To demonstrate thermal expansion/contraction we saw a video clip with a sphere and ring (like the ones pictured here). The ring was dipped in liquid nitrogen, and then the sphere would no longer fit through it. What could now be done to the sphere so that it would fit through the ring again? O Dip the sphere in liquid nitrogen. O Use a blowtorch to heat the sphere up. O Nothing can be done to the sphere, only the the ring can be altered. O Put oil on the sphere to make it slippery.
PROBLEM: VA-34 FROM THE BOOK: ENGINEERING THERMOFLUIDS, M. MASSOUD.
Find in inches the thickness of the insulation in this refrigerator wall.
Select correct statements about the comparison between the science of heat transfer and the science of thermodynamics O We can use either one to calculate the time of cooling or heating processes One is about the non-equilibrium situation, and another one deals with equilibrium. O One is about the rate of heat transferred, and another one is about the amount of heat transferred O Time does not play any role in thermodynamics, but it does in heat transfer