1,25 1425 evode aw -1.00 (A) 1 -1.25- 45° - .75 2.50 B) .50 .25 60° .50 1.00–4 -2.50- D) 2.00- UNSPECIFIED TOLERANCES: MATERIAL STEEL 2-PL DEC IN.(x.xx)±.01 THIRD ANGLE PROJECTION DWN BY REDRAWN BY C.O.ABENDROTH R.SCHOFIELD SCALE 1:1 3-PL DEC IN.(x.xxx)± CHKD MŽ TITLE +.010 DRILLED HOLES .002 SLIDING TOOL BLOCK DWG NO. 11A017 |ANGLE +O 30' 14 Unit 5 E.

Q: Distinguish nominal diameter and gross diameter of bolt

A: Nominal diameter:Nominal diamater can be described as the pitch diameter of the thread of the…

Q: On what is the flexure formula based?

A: The flexure formula is given by: Where, M is the bending moment. I is the moment of inertia. σ is…

Q: How do you read the tolerance for the bolt?

A: Given :-  Bolt drawing   Find :-  How do u read the tolerance of the bolt = ?

Q: If the pitch of a thread is 1/18 inch, how many threads are needed for the threaded section of a…

A:

Q: The thread depth is  measured along the ----------------- of the thread. Pitch Crest Angles Face

A: Thread: A thread is a simple machine structure mainly used to convert the the linear motion of force…

Q: I need the answers to this question.

A: The explanation of the above terms have been explained below.

Q: What is the length of a belt that is used for a 4” pulley and a 10” pulley that have a center to…

A:

Q: What size UNF bolt made from SAE grade 5 steel is needed to carry a static tensile load of 3000lb…

A:

Q: Figure I1.24 shows a Humpage gear used in a lathe headstock. The number of teeth on the wheels B, C,…

A:

Q: Technician A says a metric bolt with the marking of 8.9 has more yield strength than a 10.9 bolt.…

A: Technician A is not correct as the 10.9 grade bolt has more strength than 8.9 grade. Grade 10.9 is…

Q: What is the LMC of shaft C?

A: The Least material condition (LMC) tells about the minimum material can be used to produce the…

Q: In most cases, pre-loading a bolted tensile joint increases the fatigue factor of safety. has no…

A:

Q: 20 BUTT-2A .688 R. .626 DIA..003 5.50 13 812 6.000 -1.000 UNLESS OTHERWISE SPECIFIED: MATERIAL:…

A: 5. Pitch  6. BUTT is designation for  9. Standard or precision class of fit

Q: What would the full-body diagram of this boom be?

A:

Q: If a spline is transmitting 2,000 lb-in torque, what would be the major spline diameter for a 4A…

A:

Q: M25x6-4h5h-23   describe each part

A:

Engineering Drawing

Technical drawing has been around since ancient times. As in the ancient Renaissance, complicated drawings were created, including Leonardo da Vinci's drawing. Modern engineering drawing, including its specific orthographic projection with scale conventions, began in Europe (France) during the early stages of Industrialization. L.T. C. Rolt also made some of Marc's drawings for its block-making machinery (in 1799) that also may have contributed significantly to British engineering technology. Since he learned the art of presenting three-dimensional(3D) items in a two-dimensional(2D) plane, as we now term mechanical drawing.