12.7/ Determine the flow rate of air through an axial bush seal. The outer diameter of the inner cylinder is 100 mm and the radial clearance is 0.1mm. The length of the seal is 50mm. The pressures upstream and downstream of the seal are 1.4 and 1.01 bar, respectively. The viscosity of air can be taken as 1.85×10PA s.

12.7/ Determine the flow rate of air through an axial bush seal. The outer diameter of the inner cylinder is 100 mm and the radial clearance is 0.1mm. The length of the seal is 50mm. The pressures upstream and downstream of the seal are 1.4 and 1.01 bar, respectively. The viscosity of air can be taken as 1.85×10PA s.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

2. Estimate the diffusion at 25°C for oxygen dissolved in water using Stokes-Einstein equation and Wilke-Chang correlation. For Stokes-Einstein equation, assume that the radius of oxygen molecule is half the collision diameter in gas (R.=1.73×10° cm).
[I] [S] Vo 1/[S] 1/ Vo 0 mM 0.1 mM 0.333333333333 mM per minute 0 mM 0.2 mM 0.50 0 mM 0.3 mM 0.60 0 mM 0.4 mM 0.666666666667 0 mM 0.5 mM 0.714285714286 Calculate the Vmax, the Km, and the slope (Km/Vmax) for the control (with [I] = 0 mM) and for each non-zero concentration of inhibitor A ([I] = 0.1, 0.2, 0.3, 0.4, and 0.5 mM). Which type of reversible enzyme inhibition is illustrated by inhibitor A?
Learning Goal: A bar moves along a path without rotating as shown in (Figure 1). The position of point B can be described by the equation r3 = (95t)i + (4.5t +0.4t²)j, where the coordinates are in meters when t is in seconds. The dimensions of the bar are L₁ = 0.6 m and L2 = 1.8 m, and the angle is 0 = 60°. Figure 49°F Rain off and on L2 Bà A L1 с Po Y < 1 of 1 P W Ex
Chemistry What is the mole fraction of the ethanol in the overhead stream, OH-1, of the single unit flash if the inlet mole fraction is 0.40 methanol and 0.60 ethanol? Enter only a number. No units are required.
A drum 6 inches in diameter and 40 inches long contained acetylene at 250 psia and 80°F. After some of the acetylene was used the pressure was 200 psia and the temperature was 70°F (a) what portion of the acetylene was used, and (b) what volume would the used acetylene occupy at 14.7 psia and 60°F. R(acetylene) = 59.35 ft-lbf/lbm-R Answer: a. b. V = % mass
69 Gpa, = 0.35)is loaded by an axiel force of 3N, m24mm 12mm 15mm (al Delermine he avetuge ponnal stress ln sechon AB and BC of the chaft at locations away from thefillet Section AB, = Section BC, o rid (O)Determine the change of thee diameter in seien AD due to Polsson's effect. Section AB, Ad%= (c) Determine te hrbest nonnd stress al the filt consideing sTnss concentration. Athe fillet, o= (d) Determine the nommal and shear stresses on the oblique surface that has an inxline angle of Fwiththe nomal cross secbon of the shaft in section AB as shown. pwa the otlique
3. Determine the porosity of a sweet Vidali onion, which is composed of 93.8% water, 1.04% protein, 0.45% fat, 4.48% carbohydrate, and 0.46% ash. The apparent density of the onion was measured by the liquid displacement method. Toulene was used as the pycnometer liquid. All the measurements were carried out at 20°C and the density of the toluene at that temperature is known to be 865 kg/m³. The date obtained from liquid displacement measurements are: Weight of the empty pycnometer: Weight of the pycnometer filled with toluene: Weight of the pycnometer containing only onion: Weight of the pycnometer containing the onion and toluene: 75.87 g 126.58 g 85.87 g 127.38 g
10. The 1/v axis of a reciprocal plot is labeled 10°. The 1/[S] axis is labeled [S]': (M)'x 10.) The plot intersects the two axes at "2" v: (nmoles × literx min')" and "-4," respectively. What are Vmax 66 and Km ?
The thermal conductivity of Kr is roughly half that of Ar under identical pressure and temperature conditions. Both gases are monatomic such that Cv,m = 3/2 R.
Methane at 20 °C and 1 atm pressure has a viscosity coefficient of 1.09x10-4 poise. Calculate the number of collisions per second in 1 mL of the gas at 0 °C and 0.1 atm pressure assuming that the collision diameter to remains constant.