12. Which of the following conditions should be met by a system block such that the output will not be linearly distorted? i. The magnitude response within the system bandwidth must be constant. ii. The phase response within the system bandwidth must be constant. iii. The time delay within the system bandwidth must be constant. iv. The time delay within the system bandwidth should be linear with frequency. A. i and iv only B. ii and iii only C. ii and iv only D. i and iii only E. i, ii, and iii only

12. Which of the following conditions should be met by a system block such that the output will not be linearly distorted? i. The magnitude response within the system bandwidth must be constant. ii. The phase response within the system bandwidth must be constant. iii. The time delay within the system bandwidth must be constant. iv. The time delay within the system bandwidth should be linear with frequency. A. i and iv only B. ii and iii only C. ii and iv only D. i and iii only E. i, ii, and iii only

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Choose the correct statement(s) that describe the diagram below. $(1) A.A.K Phase detector 0 (1) K, f'(-)dt Select one or more: a. Used to analyze the modulation trapezoid b. Used to demodulate angle modulated signals c. Linear PLL model Od. Narrowband to wideband conversion e. Non-linear PLL model Loop filter Loop amplifier Demodulated output
Good day! Question: What is the importance of Modulator and Demodulator (functions) in FM.
PARTICULAR CONCEPT AND EXAMPLES OF : 1. Random Processes.1.2. Spectral characteristics.1.2.1. Power density spectrum.1.2.2. Definitions of noise
Analog communication lab solve all please
modulating signal amplitude wideband FM dependent %m carrier swing Prompts Submitted Answers It determines the rate of frequency shift Choose a match frequency deviation The peak to peak frequency deviation Choose a match narrowband FM FM with modulation index between 1 and 10 Choose a match modulation index The ratio of actual frequency deviation to the maximum Choose a match modulating frequency allowable frequency deviation expressed in percentage. midband FM Frequency deviation of the carrier is to the Choose a match amplitude of the modulating signal. proportional inverse proportional
The baseband signal modulates a 98 kHz carrier sine wave. Using frequency and amplitude labelling similar to that in Figure 2, sketch the spectrum of the modulated signal using a template, similar to that in Figure 3, for the following modulations: AM with the amplitude of the carrier wave being 20 V DSBSC SSB – the lower sideband SSB – the upper sideband
Problem1: the figure shows multiple modulation schemes for the signal that is given by the dashed line sinusoidal function, the X-axis is the time axis is seconds and the Y-axis is the amplitude. Answer the following: 1. What is the modulation scheme in A? 2. What is the modulation scheme in B? 3. What is the sampling frequency? 4. What is the value of the duty cycle in A?
1. If we add a Zero into a system: I. The gain slop will be increased by 20db/decade at its corner frequency. II. The gain slop will be decreased by 20db/decade at its corner frequency. III. Gain will not be affected. IV. None of the above. 2. If we add a Pole into a system: I. The phase will be increased by 90 degrees. II. The phase will decrease by 90 degrees. III. Phase will not be affected. IV. None of the above. 3. In systems, the Integrator add slop to the system gain equal to: I. 20 db/decade. II. -20 db/decade. III. 0 db/decade. IV. None of the above 4. The purpose of the Lag Compensator is: I. Improve the study state response of the close system. II. Speed up the transit response. III. All the above. IV. None of the above. 5. In the Lead Compensator: I. Z > P. II. Z < P. III. Z = P. IV. None of the above.