12. Ts.2} 1, Ts,1}

Q: Convert 5 acre · ft to gallons. 1629020.1945o gallons

A: Given data 5 acre.ft to gallons

Q: dx 5e²t-3

A:

Q: a) If a pipe with an inner diameter of 36 mm is subjected to an axial load of 5.20 x 105 N and the…

A: a) Given: Inner diameter=36mm or 0.036mAxial load (F)=5.2×105NMaximum allowable stress…

Q: a1) The vectors Cand M are given by C--si+j-3k and M-i+zj+ 2k. Determine: a) The vector product of C…

A: Those physical quantity which have both mass and direction, is known as vector quantity. Some…

Q: 3) The figure below shows the relationship between shear stress and shear rate for two fluids, A and…

A: Introduction Shearing forces cannot be resisted by a fluid at rest. As a result of such factors, It…

Q: F = 4 kN F, =5 kN F, = 8 kN A) F2 = 8.cos45.i + 5.sin45.j B) F2 = 5.cos45.i + 5.sin45.j 2 C) F2 =…

A: GivenF1=4 kNF2=5 kNF3=8 kNExpress F2 force as a vector form

Q: Calculate the Resultant Condition of the PIN in the drawing below: 1.000 O 1.060 0.982 O.995 0.008 C…

A: Given:  For pin LMC = 0.995 Geometric tolerance = 0.008 Bonus = MMC - LMC = 1.000-0.995 = 0.005

Q: A light fixture of negligible mass, has three applied forces acting on it as shown. |F,| = 4 kN 1.2…

A:

Q: Which best represents the Slope-field and streamlines for dy = y? – 9 dt

A:

Q: What are the forces cx and cy? Force F = 150

A: Given data F=150lb

Q: Units are IPS. Just need a general direction on which sketches to make first, which extrusions to…

A: Find Draw the given object step by step.

Q: Determine the angle between vector A a) Gnd in degrees bj De termine the magnitude Of the vector […

A: Solution: Note: Dear Student! As per our guidelines, we are only allowed to answer three sub parts…

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.