- 12 kN -2m1m+ 25° 75 mm -4 m- 300 mm 200 mm I - Change the angle of the grains of 25° to 32.4° - Change the height of the cross-section from 300 mm to 147.10 mm Determine the normal and shear stresses that act perpendicular and parallel to the grains due to the loading.

Q: The member shown has a rectangular cross section, determine the state of stress that loading…

A:

Q: (c) Determine the principal stresses (d) Determine the maximum in-plane shear stress. 10 ksi 16 ksi

A: Given data : Normal stress in X direction (σX)=-10 ksiNormal stress in X direction (σY)=0 Shear…

Q: Determine the reaction at the roller at C of the beam shown below. Take EI= constant. Use the Method…

A: Solution:

Q: *1-32. Determine the largest intensity w of the uniform can be applied to the frame without causing…

A:

Q: The stresses shown in the figure act at a point in a stressed body. Determine the normal and shear…

A: Given: Sx=7200 psi Sy=2300 psi  θ=64o  To find: Normal and shear stresses

Q: A prismatic bar has a cross-section of 25 mm by 50 mm and a length of 2000 mm. Under an axial load…

A: Width B=25 mm Depth D=50 mm Length L=2000 mm Load P=100 kN Elongation ∆L=2 mm Tensile stress & %…

Q: 3. Determine the required diameter of the pins at A and B to the nearest 1mm if the allowable shear…

A:

Q: *2-32. The rectangular plate undergoes a deformation shown by the dashed lines. Determine the shear…

A: Shear strain refers to the relative displacement in relation to a fixed layer in any perpendicular…

Q: a b 45 MPa 60° a

A: Given: Shear stress  To find: Normal stress and principal stress on inclined plane

Q: Transformations (strain) Q43 A strain guage rosette is placed on the outside surface of a loaded…

A: Given data  εx = 578 microstrain  ( at θ = 0°) εy = 947 microstrain ( at θ = 90° )  εx' = 57…

Q: A thin polymer plate PQR is deformed so that corner Q is displaced downward by a distance L = 1.45…

A:

Q: Show the step by step solution for problem 2-12

A:

Planar Stresses