12 k2 24 k2 10 kΩ a 36 V 2 ΚΩ 3 mA 1 k2 Vo 9,

Q: Two resistors, 18 ohms and 24 ohms, are to be connected in parallel across the certain voltage…

A:

Q: 3. D2 has a Vz of approximately 10 volts. Type in the calculated voltage for TP7 with -5 volts…

A: We need to find out the voltage at given point in the given circuit.

Q: QUESTION 2 The source in Figure 2 has an internal resistance of 120 Ohm. Determine the load power…

A: 2) To calculate the load power when the load resistance is 25 ohm

Q: A Va www 40 ww BV Vb 80 € 5

A: We need to find out the current through given resistor by using of nodal analysis for given circuit.

Q: Find the current that passes through the 19 resistor. A 46 6V @ D 352 www E Iz I₂ F 19 www 222 •…

A: We will apply kirchoffs rule here  1- current rule - at any junction or node incoming current must…

Q: 47 2 100 2- 2.2 k2 560 2 Figure 5-5 The total resistance in the circuit in Figure 5-5 is 709.2 k2 A)…

A:

Q: the circuit shown in figure (1), solve the circuit using chhoff's laws to determine currents and…

A:

Q: Rs 120 N Vs 20 V RL The source in Figure 2 has an internal resistance of 120 Ohm. Determine the load…

A: we need to determine load power.

Q: Consider the circuit shown. VDD M₁ M₂ V₁ V₂ VDD = 2.5V and I = 0.25mA. VT=0.5V and k' = 0.1mA/V².…

A:

Q: The total resistance of a series ci is the quotient of the total voltag increases as more loads are…

A: The total resistance of a series circuit: is the quotient of the total voltage and the total…

Q: detemine the currents I,I2 E, =18V Junction RuleI,4I,= Ig. Oloop rule: 18+0.5I2t 6エ,12.5エ2…

A: KIRCHHOFF’S LAW KCL: The algebraic sum of all currents at a node is zero. KCL is applicable for…

Q: R1 a Req R2 R3 d

A:

Q: For circuit with series and parallel resistors, the supply voltage, Vsupply 120 Volts and the…

A:

Q: What is Ammeter A4 is measuring - A- line current, B- Phase current, C- neither "a" nor "b", D- both…

A: The function of an ammeter is to measure the current flowing the ammeter and the ammeter is always…

Q: without overloading the circult? 4. Acar lot uses incandescent lamps to supply outside lighting…

A: We will connect all the lamps one by one and will see how much current is demanding each lamp  If…

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.