*12-36. The beam is constructed from four boards which are nailed together. If the nails are on both sides of the beam and each can resist a shear of 3 kN, determine the maximum load P that can be applied to the end of the beam. 13AN 100 mm 30 mim |150 mm 30 mr -2 m 30 mm 30 min

Q: 5) The beam is supported by a pin at A and a shaft link BC. If P = 15 KN, determine the average…

A: Given data  Force p = 15 kn Diameter = 18 mm Each pins are double shear . Find the shear  stress in…

Q: 2-The crimping tool is used to crimp the end of the wire E. If a force of 20 lb is applied to the…

A:

Q: me average

A: The tensile force for the mechanishm is .The diameters of the rod are  and .The diameter of the pin…

Q: - The nails are on both sides of the beam and each can resist a shear of 2 kN. In ddition to the…

A:

Q: Determine the maximum tensile and compressive bending stress in the beam if it is subject to a…

A:

Q: DRAW THE DIAGRAM OF EVERY ANALYZED PART AND LABEL THE VALUE OF SHEAR AND MOMENT. B 10 KN 3m C 3m D…

A: For AC,For BD,For DE,

Q: If A and B are both made of wood and are 3 8 in. thick, determine to the nearest 14 in. the smallest…

A: Provided that both the elements A and B are 3/8 inch thick. The applied force of 800 lb will have…

Q: The beam is made from two plastic pieces glued together at the seam A.  If it is subjected to the…

A: Answer: The vertical shear force resisted by the flange of the beam at the critical section is…

Q: Determine the maximum shear stress in the strut if it is subjected to a shear force of V = 20 kN.

A: Given data V=20 KN