11. The unknown solution is prepared by transferring 500.0 μL into a test tube and adding the BCA working reagent solution and DI water. The final volume in the test tube is 5.00 ml. What dilution factor is applied when calculating the protein concentration of the unknown solution? 1.00 200. 10.0 5.00

11. The unknown solution is prepared by transferring 500.0 μL into a test tube and adding the BCA working reagent solution and DI water. The final volume in the test tube is 5.00 ml. What dilution factor is applied when calculating the protein concentration of the unknown solution? 1.00 200. 10.0 5.00

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

A student added a total of 75 mL sodium hydroxide to titrate an amino acid solution with 0.5M NaOH. They also calculated that they added a total of 14 mL of sodium hydroxide to arrive at pH 2.6 and a total of 32 mL of sodium hydroxide to arrvive at pH 4.8.What was the initial concentration of the amino acid solution in milimolar (mM)? The calculations must be presented such that those can be recapitulated by the marker. Provide the answer with no decimal places. Show all details of your working out. State the answer in a full sentence.
Answer the following questions. Questions Nos. 1-2
In order to adjust the Potassium Permanganate solution, 0.0544g Na2C2O4 was taken and necessary experimental procedures were performed on it and the titrant consumption was found to be 7.9 mL. What is the KMnO4 concentration? A. 0.040B. 0.044C. 0.021D. 0.027
Y Do you predict that this salt bridge will become stronger, become weaker, or be unaffected as pH increases from pH-7.2 to pH=7.97 The salt bridge will become stronger. The salt bridge will become weaker. The salt bridge will be unaffected. Previous Answers Correct At pH=7.2 the glutamic acid (Glu) side chain will carry a charge of -1 (at 3 pH units above the pK, for Glu, the side chain will be almost fully ionized whereas the histidine (His) side chain will carry a charge of < 0.5 (at pH pK, the charge on His would be +0.5; since pH 7.2 is above its pK, it will carry less (+) charge as it becomes more deprotonated). As the pH increase to 7.9, the charge on Glu will remain-1 and the charge on His will decrease; thus, this salt bridge is predicted to become weaker as pH is raised from 72 to 7.9. Part B Justify your answer with calculations of partial charges on these amino acid side chains at pH 7.2. (Hint: Consider lessons from Coulomb's law, and the Henderson Hasselbalch equation)…
30.0 mL of a 0.20 M solution of the weak base methylamine is titrated with 0.10 M nitric acid (HNO3). The Kb of methylamine can be found in Appendix I. Calculate the pH at each volume of base addition as listed below and report your answer to two decimal places The initial pH (after 0.0 mL of nitric acid addition) is The pH after 10.0 mL of nitric acid addition is The pH after 30.0 mL of nitric acid addition is The pH after 60.0 mL of nitric acid addition is The pH after 65.0 mL of nitric acid addition is
What is the solubility of the metal salt MX2 if the Ksp value is 4x1012. Select one: a. 104 M b. 2*106 M c. 2*10-4 M d. 1.3*103 M e. 4*1012 M
Standardization of 1N H2SO4 Titration 1 Titration 2 Titration 3 Titration 4 Mass of flask and Sodium Carbonate 1.5067 g 1.5098 g 1.5076 g 1.5077 Final buret reading (mL) 22 mL 22mL 21.5 mL 22.5 mL Volume of Sulphuric acid used (mL) 30 mL 30 mL 30 mL 30 mL What is the result of my titration?
A multivitamin sample has a label claim of 500 mg ascorbic acid (176.12 g/mol). According to quality assurance guidelines for stability, it has an acceptable range of 90.0%-110.0% of the label claim. After production, the multivitamin was analyzed through acid-base titration, and the sample needed 25.40 mL of a 0.1101 M NaOH titrant to reach the end point. After 3 months, the same multivitamin was analyzed again, and this time 23.34 mL of the same 0.1101 M titrant was used. After 6 months, the same multivitamin was analyzed again, and this time, 22.48 mL of the same 0.1101 M NaOH titrant was needed to reach the end point.
The recipe for PBS says to dissolve compounds in 800 ml of water, adjust the pH to 7.4, then add water up to 1 litre. The final pH should still be 7.4, because the pH of buffer solutions remains stable when they are diluted as long as the concentration of its constitutive acid and base is not too low. Why do you think the protocol does not say to dissolve compounds directly in 1 litre of water?
A student was titrating a solution of hydrazine (H₂NNH₂) with a nitric acid solution. Determine the pH at a particular point in the titration. Do this by constructing a BCA table, constructing an ICE table, writing the equilibrium constant expression, and use this information to determine the pH. Complete Parts 1-4 before submitting your answer. The Kb for H₂NNH₂ is 3.0 x 10-6. Based on your ICE table and the equilibrium expression for Kb, set up the expression for Kb in order to determine the unknown concentrations. Each reaction participant must be represented by one tile. Do not combine terms. [0] [0.200 + x] [0.175 + x] [0.200] [0.200 -x] [0.175 -x] 0 1.70 Kb 4.77 x 10-1⁰ = 12.3 [0.0200] [0.100] [0.0200 + x] [0.0200 -x] 10.8 [0.140] 2 [0.100 + x] 2.10 x 10-² A student was titrating a solution of hydrazine (H₂NNH₂) with a nitric acid solution. Determine the pH at a particular point in the titration. Do this by constructing a BCA table, constructing an ICE table, writing the…
Please answer 13.3 and 13.4