11) For the circuit shown in the figure, determine the currents 1, 12, & 13 for the 7.0- O resistor, the 8.0-2 resistor, and the 4.0-O resistor, respectively.

Q: Q) The frequency is relating to time period--- Square proportional. O Not related. Directly…

A: In this question Choose the correct options What is relation between frequency and time period.

Q: 1. Are the theoretical calculations and measured values are equal? Explain?

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: 1. The cascaded RF filters of a TRF receiver have 590µH inductors. The ganged capacitors vary from…

A: According to the question, The cascaded RF filters of a TRF receiver have 590µH inductors. The…

Q: Calculate the power saving in percent for the H3E system of an AM signal modulated to 57%. Your…

A: Given: Modulation percent of the H3E system of an AM signal = 57 %. To find: Power saving in %.

Q: Thevenin and Norton Equivalent: 15). For the circuit in Fig. 4.109, find Thevenin equivalent between…

A: We need to find out thevenin equivalent circuit and norton equivalent circuit

Q: 8 Look at the photo of the boys on the charity Write the correct answer. 1 Paul and Donny _are a is…

A: Given

Q: Q-01 (What is called Buck Converter & What is called Boost Converter?)  give two examples for each.

A: Explanation: The buck converter is a ubiquitous DC-DC converter that correctly converts an excessive…

Q: Solve for the number of luminaires. The type of structure is an indoor basketball court having a…

A: It is given that: Length (l) = 40 feet Width (w) = 60 feet Height (h) = 17 feet ceiling cavity…

Q: Q1: Fill in the blanks with appropriate words. 1. I . her for everything she . (A) thanking / did…

A: Use appropriate parts of speech and proper tenses to solve these

Q: Question 10 What is the stability condition of the given system? A) Stable B) Unstable Marginally…

A:

Q: Vending machine. After joining a circuit design company, you are asked to design the control circuit…

A: We need to design the control circuit of a vending machine that sells a type of bottled soft drink.…

Q: 2. A TRF receiver is to be designed with a single tuned circuit using a 10µH inductor. The ideal…

A: According to the question,

Q: Calculate the number of luminaires required in the room of length 12.46m and Width 5.91m. If 100 W,…

A: Given Room length = 12.46 m Room width =5.91 m Utilization factor (UF)=0.71 Maintenance factor (MF)…

Q: It has been desired to install a diesel power station to supply power in a suburban area having the…

A: As per the Bartleby policy we can answer only three sub parts at a time. As you have not mentioned,…

Q: The imaginary power of any circuit is transferred in both directions The power triangle represents…

A:

Q: a) Plot both the engineering stress versus engineering strain and true stress versus true strain…

A: Note: As per Bartleby guidelines, I have provided solution of first three questions a, b and c. You…

Q: Which of the following do not apply to a primitive network? (a) It has two terminals. (b) It is…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Q: When solving the equation why is 1 used rather than 1000? Thank you

A: I will explain you for one part, the same applicable for all the parts

Q: Please explain DES, triple DES, IDEA, and AES with examples.

A:

Q: What is the primary focus of materials science? A) Studying the behavior of gases B) Investigating…

A: The main goal of material science is to comprehend the composition, behaviour, and structure of…

Q: > A point source emits 30 W of sound. A small microphone has an area of 0.75 cm is placed 10 m from…

A:

Q: d) None of these. 5. Materials which easily allow the passage of electric current are known as: a)…

A: Answer 2- The power is defined as a rate of doing work.  So, option (c) is correct.   Answer 4- An…

Q: Q2 The following reading were recorded for voltage measurement 10.1. 9.7. 10.2, 9.6 9.7, 10.1, 9.6,…

A:

Q: Provide Your Answer as  letter A if the first statement is True , Letter B if the second statement…

A: Given the statements as follows- 1. The passing general average rating shall be seventy percent…

Q: Signal presentation element is used to transmit the signal from the plant to the observer. True or…

A:

Q: 200 200 20 0.53

A:

Q: SUBJECT: COMMUNICATIONS 1: PRINCIPLES OF COMMUNICATION SYSTEMS FOR ENGINEERS TOPIC: Introduction to…

A: 1) What  are the challenges in electronics communication at present 2) what has been the role of EE…

Q: Look at the photo and answer the questions

A:

Q: if i use Voltage division instead of nodal analysis. where do you suggest i start, and How do I…

A:

Q: can you do the other part of the question too

A: Since you have posted multiple questions with multiple sub-parts, we will provide the solution only…

Q: If the L[ eat cos5t] = (s-a)/( s² - bs + 48), determine the value of a.

A: It is given that: Leatcos5t=s-as2-bs+48

Q: In any instrument, the systematic errors can be reduced by * .making

A: The explanation is as follows.

Q: Which of the following is not a passive component in an electrical circuit? a) Resistor b) Capacitor…

A: Passive elements are components in electrical circuits that do not introduce energy into the…

Q: Please solve question number 17, 18 and 19 for me. ***If you need the value of R or R' use R=5…

A: As per the guidelines of Bartley we supposed to answer first question only since the remaining…

Q: im still confused on how 5/6 is part of the answer can someone explain

A: When the KVL is applied at mentioned node, it gives the equation V-802000+V-04000+V-012000=0. On…

Q: Computer operations True are affected if voltage unbalance of input is more than 2.5 perecent False

A: Computer operations are affected if voltage unbalance of input is more than 2.5 percent

Q: Answer the following questions. If we would like to connect 5 stations using full mesh topology,…

A: Mesh Topology : In this type of topology every device is connected to another device via a dedicated…

Q: please solve question number 2,3,4,5

A: Step-2->

Q: can you please help me on a home work question. havent worked with this stuff in 47 years

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.