102 1 Ω X/0° V (102 -j1 Ω 2I Z₁ Question) Find the ZI value and the maximum power required for maximum power transfer in the circuit above. In the circuit, X=51. Question) Find Zl for the maximum power transfer and calculate maximum power. In the circuit X=51. O a. Zl = 0.40-j0.20 ohm, Pmax=41453.44 W O b. Zl = 0.40 + j0.20 ohm, Pmax=2114125.31 W O c. ZI= 0.40 + j0.20 ohm, Pmax=812.81 W O d. Zl = 4.40 + j2.40 ohm, Pmax=928.93 W O e. Zl = 0.40-j1.00 ohm, Pmax=325.12 W O f. ZI= 0.40 + j0.20 ohm, Pmax=406.41 W O g. Zl = 0.40 + j0.40 ohm, Pmax=406.41 W Oh. Zl = 0.40 - j0.20 ohm, Pmax=541.87 W

102 1 Ω X/0° V (102 -j1 Ω 2I Z₁ Question) Find the ZI value and the maximum power required for maximum power transfer in the circuit above. In the circuit, X=51. Question) Find Zl for the maximum power transfer and calculate maximum power. In the circuit X=51. O a. Zl = 0.40-j0.20 ohm, Pmax=41453.44 W O b. Zl = 0.40 + j0.20 ohm, Pmax=2114125.31 W O c. ZI= 0.40 + j0.20 ohm, Pmax=812.81 W O d. Zl = 4.40 + j2.40 ohm, Pmax=928.93 W O e. Zl = 0.40-j1.00 ohm, Pmax=325.12 W O f. ZI= 0.40 + j0.20 ohm, Pmax=406.41 W O g. Zl = 0.40 + j0.40 ohm, Pmax=406.41 W Oh. Zl = 0.40 - j0.20 ohm, Pmax=541.87 W

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

To find: The loop currents using elimination & substitution methods
The reactance of a generator is given as 0.1 pu based on the generator of 17 KV, 300 MVA. Determine the pu reactance on a base of 17 KV, 250 MVA. New pu reactance is.......
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three- phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT RO- SO- To- : IR Is IT UL-380 V CARGA 1 P₁ = 950 W cos p1=0,5 ind. CARGA 2 P₂=1.140 W cos p₂=1 CARGA 3 P3=760 W cos p3=0,5 cap.
A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 250 MVA rating, R1 = 0.02 pu (on the 250 MVA base), initial output P1 = 200 MW. G2: 350 MVA rating, R2 = 0.015 pu (on the 350 MVA base), initial output P2 = 300 MW. 0.03 pu (on the 300 MVA base), initial output P3 = 150 MW. G3: 300 MVA rating, R3 = The frequency of the system is 60 Hz. Assuming D = 1 pu on a common base of 1000 MVA, what is the new generation output for G3 for a load increase of 75 MW? Select one: O a. 190.55 MW O b. None of these O c. 203.38 MW d. 166.01 MW
A string of suspension consists of four (4) units. The Voltage between each pin and earth is 0.12 of the Self-Capacitance of the unit. The Voltage between the Line Conductor and earth is 135KV. Find the Voltage distribution across each unit and the String Efficiency
Kindly solve what is ask with complete solution and circuit diagram so that I can understand. I want a handwritten solution and write the givens. Thank you very much ma'am/sir.
X₂=0.1 1 XL +03 Soto X₁ = 0.2 X = 0.1 X = 0.1 Above is the one-line diagram of a simple power system. Each generator is represented by an emf behind the subtransient reactance. All impedances are expressed in per unit on a common base. All resistances and shunt capacitance are neglected. The generators are operating on no load at their rated voltage with their emfs in phase. A symmetrical fault occurs at bus 1 through a fault impedance Z, =j0.08 per unit. a) Using Thevenin's Theorem, determine the impedance to the point of fault and the fault current in per unit. b) Find the bus voltages and line currents during the fault. 2 O oto
Two impedances Z1 = 2 + j2 ohms and Z2 = 5cis(-45) ohms, if they will be in parallel, what would be the equivalent circuit impedance ? O 1.53 cis (-20.7) ohms 2.46 cis (-15.5) ohms 2.83 cis(18.5) O 14.14 cis (0) ohms
Parts D and E. Thanks
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three- phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT RO- SO TO IR Is IT U₁-380 V CARGA 1 P₁ =950 W cos p1=0,5 ind. CARGA 2 P₂=1.140 W cos p₂=1 CARGA 3 P3=760 W cos p3=0,5 cap.
What is a microgrid and what are its advantages
For the circuit given in Figure 1, a) Find the Thevenin equivalent circuit with respect to terminals a-b b) When a 5000 resistor is connected to terminal a-b, find the voltage on the resistor wwwwwwmm c) It will be connected to a-b terminals and its voltage on 5000 load will be 132 kV rms. What should be the capacitive reactance value that will increase it? wwwwwwwww d) What happens to the short-circuit current when the a-b terminals are short-circuited? 2+1202 000 m da 127/6 kV rms ob 1.5 +/902 000 w 12725 kV ms