In fast decoupled method, the strong coupling between the following is used, a. Q and V b. Pand V c. Pand Q d. Pand 6

Q: How do you realize a subtractor using full adder?

A: as per the guidelines we need to solve  only first question. we need to design full subtractor using…

Q: (a) Refer to the circuit as in Figure Q1(a), a switch has been in position A for a long time and…

A:

Q: 0.1 µF D Vs, 0.1 μF Vm Vo Vs 100 KO Vs 100 KO - Vm V8- (b) (a)

A: a) During positive half cycle of the supply, the diode is forward biased, so current flows through…

Q: 2. Design a power supply by specifying their rating to the nearest standard values. C3 (220 VIEO H0…

A:

Q: -) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: Q1// What is the purpose of conducting experiments (o.c) and (s.c) on asingl- nhase transformer?

A: TRANSFORMER: The transformer transfers power from one circuit to another circuit without a change…

Q: A second order control system has a damping ratio as 0.6 and natural frequency of oscillations as 11…

A: Given- 2nd order control system- Damping ratio=0.6, Natural frequency ωn=11 rad/sec, To Find- The…

Q: 6. A 1-phase full converter delivers ripple free current to RL load with R=1592. The source voltage…

A: Given data Resistance, R=15Ω Source voltage, Vrms=230 V Supply frequency, f=50 Hz Firing angle,…

Q: With base MVA of 150 and base voltage of 33. If the reactance of the transformer is 0.23 pu. The…

A: Base MVA S= 150MVA Base voltage VB = 33kV Reactance per unit = 0.23  Reactance?

Q: dabull (CME 446) 1 If F3=0.1 and Z3=45 Q, then the impedance of the next stage in the multi-section…

A: Given: Γ3=0.1Z3=45 Ω

Q: Q5. For the following center tapped transformer, show the waveform across each half of

A: The given circuit diagram is a center-tapped transformer-type rectifier. the input voltage is 100 V.…

Q: what is the use of DC/DC tension converter DC/DC booster MT3608

A: Types of mostly used DC DC Converter Step up Converter ( Boost converter) Step Down Converter (…

Q: a buck converter, what are the benefits and disadvantages if the changes of duty cycle is drastic…

A: Duty cycle : Duty cycle in the power system is defined as the ratio of the time during which a load…

Q: Find i in the network using superposition. 5Ω 10 Ω 2 A 5Ω 4Ω 20 V

A: This theorem is used to find current in any particular branch. To apply this minimum 2 sources are…

Q: Q5. For the following center tapped transformer, show the waveform across each half of the secondary…

A: The waveform across each half of the secondary winding is shown by Vac & Vbc waveforms in the…

Q: 11- The output current corresponding to maximum efficiency for a transformer having core loss of 100…

A: we have given P=100WR=0.25Ω

Q: Design a DC power supply using FWR to perform the following requirements. Find V_dc, V_rms,…

A:

Q: lain the operation of a full subtractor with necessary diagrams. What is the difference between half…

A: Full Subtractor : It is is a combinational circuit that perform subtractor it consist three bits. It…

Q: What is the effect of applying reverse voltage on a pn junction?

A: According to question answer rule of Bartleby we have to solve only one question so I solve (a)…

Q: The principle operation of LVDT is based on the variation of Select one a. Self inductance b.…

A: Right Answer option C.Mutual Inductance

Q: A transformer is operating at rated Voltage and Current and supplying a resistive load. With the…

A: The copper loss depends on the load resistance. When the load is increased, the copper load…

Q: Q5. For the following center tapped transformer, show the waveform across each half of

A: The given circuit diagram is a center-tapped transformer-type rectifier. the input voltage is 100 V.…

Q: Identify the correct junction and loop rules, the solve for the missing currents using Kirchhoff’s…

A:

Q: A current of 12 A is reversed in a 3-H coil in 24 ms. The induced voltage is

A: In this question,  We need to determine the induced voltage across the inductor?  We know Induced…

Q: 4- Liquids dielectrics are mainly used as a. Impregnants in high voltage cables b. In capacitors c.…

A: In this question we will write about liquid dielectric uses...

Q: If the core of LVDT is at the middle, then the output voltage will be a. maximum b. minimum c.…

A: LVDT :  The linear variable differential transformer is an electrical transformer which used to…

Q: 3-IS there a relationship between splicing losses and bending losses if we take into consideration…

A: Splicing Loss:  Splice loss refers to the part of the optical power that is not transmitted through…

Q: Q5. For the following center tapped transformer, show the waveform across each half of the secondary…

A: Consider the circuit given in the figure: When we treat transformer with input terminal A as…

Q: These question from electronics two course

A:

Q: Q5. For the following center tapped transformer, show the waveform across each half of the secondary…

A: An device which convert alternating signal in to pulsating direct signal. The half wave rectifier…

Q: Q5. For the following center tapped transformer, show the waveform across each half of the secondary…

A:

Q: 2. 1 H F 100 cos 2r V 2H 1H 2Ω Given: t=2s k=? energy stored in the coupled inductors=? ele ele

A: Given here a magnetically coupled circuit and asked to 1)find the coupling co-efficient(k) 2) and…

Q: For the given circuit below, a step down transformer gives an RMS voltage of 230 V/ 10.2-0-10.2 V…

A:

Q: Question-4: In the bridge type circuit shown below, the diodes are assumed to be ideal. The…

A:

Q: Primary AC Source Transformer Secondary AC/DC Full-wave Rectifier Capaictor m Non- linear, Load…

A: The given circuit is shown below.

Transmission Line Parameters

The performance of a power system is mostly determined by the producing stations and transmission lines in the system which can be studied with the help of transmission line parameters.