10. Discuss the stability of the system, and determinate the number of roots in right hand side,If the characteristic equation is: s7+2s°+s°+2s*-s³-2s²-s-2=0.

Answered: Image /qna-images/answer/45b19e9b-8c59-486b-b668-6b05b502b48c.jpg

Answered: 10. Discuss the stability of the…

10. Discuss the stability of the system, and determinate the number of roots in righ If the characteristic equation is: s'+2s°+s° -s-2=0.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Let Zeq be the equivalent impedance of a parallel connection of an inductor with inductance L and a…

Q: A circuit is shown in the figure. C = 8x104 F, L = 4×102 H, and R = 9 Q2. The AC source has a…

A: The circuit diagram is shown below,

Q: Determine Voltage Vout and the Current on the 0.01micro farad capacitance. * c, -0.01 uF R, -1 ka V-…

Q: Q2/ For the network shown in figure (Q:), the switch has been open for a long time before closing at…

Q: VZ(100) sen(ot + 30°) V2(0.25) sen(157t – 40°) 100 sen(wt - 90°)

A: Since as per bartleby guidelines i am supposed to answer only one question and if it has subparts…

Q: Consider the circuit shown below left. ww 100 Ω 5 V SW1 500 mH ww 100 02 ww Rth Vth SW1 a ell 500 mH…

Q: Q2/ For the network shown in figure (Q:), the switch has been open for a long time before closing at…

A: In circuit the sudden turn on and turn off of the switches causes the transient condition occurs.…

Q: 5. The critical frequency for an RL circuit occurs at the frequency at which the resistance is equal…

A: For the RL circuit,We need to prove the critical frequency,fCRIT=R2πL.We need to determine the phase…

Q: Find the steady-state current in an LRC-series circuit when L = h, R = 20 2₁ C = 0.001 f, and E(t) =…

Q: circuit shown in Figure, find its Vrms (gen) and inductive reactance. After that, solve for its…

A: In this question we will find total impedance , total current and voltage across all components...

Q: The circuit shown is to be designed so that VL,dc =12V and VLr,p-p =2V. • mF 1. The required…

A: This circuit is full wave Rectifier with RC load. Capacitor is used as filter. Ripple voltage = 2V…

Q: Find the natural frequency for Ve for the following circuit given the following parameters. Solve…

A: R1 = 4 ohmR2 = 9 ohmR3 = 10 ohmC = 1 mF = 1 * 10-3 FL = 3mH = 3 * 10-3 HWe need to find the…

Q: By adopting COSINE as the base function for phasors, what part of the Euler's identity is used? A…

A: In this question we need to choose a correct option.

Q: A series RL circuit is connected to a sinusoidal voltage source at t = 0. In general, which of the…

A: When we apply AC source (sinusoidal),the complete response is sum of transient and steady state…

Q: The current in the circuit in the followin figure is known to be i B₁e -2000t cos1500t + B₂e-2000t…

Q: By adopting COSINE as the base function for phasors, what part of the Euler's identity is used? A)…

A: We need to select correct option for given statement.

Q: H.W 2 An AC circuit includes two sections AB and BC in series. The section AB consists of two…

A: The circuit is drawn below according to the given description in a question. The voltage across…

Q: By applying Kirchhoff's Voltage Law to a series RL circuit, we obtain the differential equation: di…

Q: A 10 resistor and a 5 μF capacitor are connected in parallel. This parallel combination is also in…

Q: Consider the R-L-C circuit shown in the diagram. An engineer was able to connect the circuit using a…

A: In this question, we need to determine the voltage across each terminal. we know Inductive reactance…

Q: RS), T= 1Sec S(st) 1/s

Q: Consider the circuit shown below left. ww 100 Ω 5 V SW1 500 mH ww 100 02 ww Rth Vth SW1 a ell 500 mH…

Q: 3 kN 3 mH ww C1 6 µF R3 1 kN v(t) R2 2 kN ww

Q: HW 1.5: A voltage v(t) = 100 cos(60t + 20°)V is applied to a parallel combination of a 40-k2…

A: Given,

Q: Two parallel capacitors C1 and C2 are in series with two series inductors L1 and L2 and connected to…

Q: 12 cos 3t V R + Vo L m Write your answer in Volts. 4 sin 2t A 10 V If we would like to use…

A: For the given circuit calculate amplitude of v0 considering only the contribution of sinusoidal…

Q: A source provides a sinusoidal current i,(t) of 60 Hz to two resistors and a capacitor, so that…

Q: (a) If x(t) = e-tu(t) + u(t-1). Find x(t) in the simplified form and plot it. /L) Chinon stimunur…

Q: 8. Two signals vi(t) = 1.5cos(wt+0.2) and v₂(t) = .62cos(wt-1.7) are added. Find the phasor sum.

A: In this question, We need to determine the phasor of the sum of the both signals. We are solving…

Q: Consider the elrouit below, given that Z1 is a 2H inductor, 22 is aBohm resistor, 23 is a 12 ohm…

Q: j2 2 ell 10.640° 10 2 -15 2 20 i, Find the currents i, İ, and i, in this sinusoidal steady-state…

A: The equivalent circuit with assumed mesh current in each mesh is shown below: In above circuit, the…

Q: 6. a sinusoidal current is in phase with the voltage. It has an active power of 50VARS and reactive…

A: given here reactive and active power and asked to find the apparent power.given here series RLC…

Q: Let Zeq be the equivalent impedance of a series connection of an inductor with inductance L and a…

Q: In the following circuit: A sinusoidal current Is(t)=10sin(5t) is applied in series with R=0.2MQ and…

Q: In the circuit shown in Figure, find its Vrms (gen) and inductive reactance. After that, solve for…

Q: A series RC circuit consists of a 2MQ-resistor and an uncharged capacitor, C=5μF. The circuit is…

A: Given here the data related to the RC series circuit and asked to find the voltage across the…

Q: Perform the following complex number conversions: a) Convert the following complex number to its…

A: here we have to convert the numbers

Q: A 42- nF copacifor har a curent of if)= a) rottage across the capaci tor A. Find : 6.) evergy vtored…

Q: 3. A series RL circuit has a voltage E 15sint, a resistance R 25 ohms, A series RL circuit has a…

A: The solution is given below.

Q: For the circuit below, A. Find the Impedance of C. B. Find the Impedance of L. C. Find the Phasor…

Q: Q1/ For the network shown in figure (Q1), the switch has been in position "a" for a long time. At…

Concept explainers

Sinusoids And Phasors

Sinusoids are defined as the mathematical waveforms that are used to describe the nature of periodic oscillations.

Circuit Theory

Electric circuits are a network that comprises of a closed-loop, which helps in providing a return path for the current through a switch. When the switch is activated, the load operates, and the current accepts a path to finish the circuit at a low potential level from the opposing high potential level. Electric circuits theory is a linear analysis that helps in establishing a linear relation of voltage and current for R (resistance), L (inductance), and C (capacitance).

Question

10. Discuss the stability of the system, and determinate the number of roots in right hand side,
If the characteristic equation is: s7+2s°+s°+2s*-s³-2s²-s-2=0.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the natural frequency for V, for the following circuit given the following parameters. Solve for the differential equation symbolically so that you can use the same result in the next question. Otherwise you will have to repeat the process with new numbers. Also be wary of the given units. C = 8mF, L = 9mH, R1 = 62, R2 = 9N and R3 = 102 t=0 R. R2 12v R3
QUESTION: this question is realted to subject ORDINARY DIFFERENTIAL EQUATION. plz solve on A4 page and step by step. and send quickely thanks
Meaning of this method? m2t = α + bet-1 + dm2t-1+ f%Δ(Rt – rt) + goct + g1ct-1 + g2ct-2 + εt
An AC circuit contains a 24-Ω resistor, a 15.9-mH inductor, and a 13.3-µF capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. P = I2 / R = VARsL = √VA squared - P squared = VARsC = VARsL(present) - VARsL(needed) =
A 30-ohm resistor and a 0.1 H inductor are in series with a voltage source thatproduces a voltage of 120 sin (377t + 10°) V. Find the components for thecorresponding phasor domain current source transformation. Note: Please write and answer neatly with solutions, thank you!
Preform AC Steady-State analysis for the circuit calculating the time response function for VRC2, the green probe. R1 50 L1 10mH V1 C2 33u VOFF = 0 VAMPL = 15 FREQ = 200 AC = 0 R2 100
4. Evaluate the expression using phasor, write your answer in pbasor and sinusoidol form 25° i4) = - 20 cos (ot - 40°) + 15 sin (3t - ) + Gosin (ot + 20°) - 6osin (st - 70°)
INCLUDE DIAGRAM FOR UPVOTE
Solve ASAP
Draw the root locus of the system given in the figure for K > 0.
Q2) Find k and for the system shown in Figure 2 by using = 0.5 and steady-state error (ess) 0.1 for a unit ramp input. R(s) Figure 2 k s(s+B) C(s)
help on this electronics question?