1.5 m3/min of a gas is emitted from a process at T=10 oC and 1.05 atm. Calculate the mass flow rate of sulfur dioxide if the gas stream contains 2.5 ppmv SO2.

Q: Natural gas at 70°F is flowing at a steady mass rate through a steel pipe with an inside diamete of…

A:

Q: Saturated steam at 1 atm is discharged from a turbine at a rate of 1150 kg/h. Superheated steam at…

A: Considered saturated steam and superheated steam is mixed together to form superheated steam as a…

Q: practical quantitation of dioxane leaked from the underground storage tank into the aquifer,…

A: GivenPQL for dioxane=1 μg/Lvolume of dioxane leaked=32 gallons=32×0.00378541 m3=0.1211 m3To findm3…

Q: Problem 2 NO₂ is released at 0.50 g per min into a container with a volume of 10 m³. At the same…

A: Mass flow rate of NO2 = 0.5 g/min or 30 g/h Volume of container = 10 m3 Ventilation rate of gas =…

Q: A section of an industrial process is made up of an evaporator to which 35,000 kg/h of a 15% KNO3…

A: Given that: input stream (M1): flow rate =35000 Kg/hr concentration : KNO3=15% ; H2O=85% output…

Q: calculate the change in gibbs free energy in kJ for the reaction below at 7l0.4°C when there is a…

A: The standard Gibbs free energy change (ΔGo) is the energy change that occurs in going from the…

Q: Carbon dioxide (CO2, molecular weight of 44.01 kg/kmol) is being pumped through a smooth pipe at the…

A:

Q: A 5 ft' tank is initially evacuated (total vacuum). A leak develops and air enters the tank at a…

A: Initially, there is vacuum in the tank and then air start to enter into the tank, pressure at the…

Q: As oxygen flows from a point A to a point B its temperature increases from 50°C to 73°C and its…

A: Initial temperature of O2 at point A, TA = 50ºC = 323 K The initial pressure of O2 at point A, PA =…

Q: Saturated steam at 1 atm is discharged from a turbine at a rate of 1150 kg/h. Superheated steam at…

A: In thermodynamics, the amount of energy absorbed by the substance to increase the temperature of the…

Q: Atmospheric air at 30°C and with a density of 1.12 kg/m³ enters an air-conditioning unit through a…

A: Given Inlet condition Air Temperature=30℃ Density of air=1.12 kg/m3 Area A1=0.06m2 Velocity V1=10…

Q: 30,000 m³ of coal gas measured at 289 K and 1 atm is saturated with water vapour. This is compressed…

A: We know that... H1=MAMB·PAPt-PA where, H1= Humidity at initial condition…

Q: - You are heating motor oil to make it flow better from the original shipping container to the new…

A:

Q: 8. Pressurized air cans are used to blow dust out of electronic equipment. At 300.0 K the air can's…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: An open test tube at 293 K is filled at the bottom with 12.1 cm of Hg, and 5.6 cm of water is placed…

A: Given that, The height of the mercury hm = 12.1 cm The height of water hw = 5.6 cm Atmospheric…

Q: Wet steam at 10 bar and vapor mass fraction xv =0.25 is fed to a boiler and converted to superheated…

A: Wet Steam P=10 bar Vapor mass fraction xv =0.25 Superheated Steam P=10bar T=300˚C Find a)Heat…

Q: A fuel is burned in a cylinder equipped with a piston. The initial volume of the cylinder is 0.250…

A: The work done for the given process is to be determined.

Q: Water at 20°C is pumped at a constant rate of 9 m3/h from a large reservoir resting on the floor to…

A: Given, Volumetric flow rate = 9 m3/h

Q: Saturated steam at 1 bar and mass flow rate is 113.63 kg/h is mixed with a second stream of…

A: Given data: Mass flow rate of saturated steam = 113.63 kg/h. Temperature of superheated steam = 400…