1.4-12 A rigid member DAC as shown in Fig. P1.4-12 carries the load P. Bar AB js an aluminum bar whose cross-sectional area is 0.5 in², and it is pinned at A and B by 0.5-in-diameter pins in a single-shear configuration. If the maximum allowable normal stress in AB is 7000 psi and the maximum allowable shear stress in the pins is 15,000 psi, find the maximum allowable load P. For aluminum E = 10 x 10° psi. |3D

Q: The pin-connectsed structure consists of a rigid bar ABCD and two bronze alloy [E = 100 GPa] bares,…

A: GivenE=100GPaA=340mm2L1=810mmL2=1080mma=480mmb=38mmc=600mmσlim=165MPa

Q: = A solid steel cylinder with diameter of 40 mm and a shear modulus of G = = 75 GPa has fixed ends.…

A: Step 1: Step 2: solution is given above Step 3: Step 4:

Q: A tent peg made from a circular steel rod is embedded in the ground as shown in the figure below.…

A: Given data: Overall length of the peg =150 mm=0.150 m embedded length of the peg L=117 mm=0.117 m…

Q: 3) The rigid horizontal bar AB is supported by three vertical rods as shown in the figure and…

A:

Q: A hollow circular stainless steel bar is loaded in tension by force P. The bar has a length…

A: Given data is

Q: In the structure shown below (Figure 3), two forces of equal magnitude (P) are applied along the…

A:

Q: A stepped bar is fixed at end C. The bar has a cross sectional area of 1000 mm² in AB, and a 2000…

A:

Q: x = A cylindrical rod is made of three segments and is subjected to axial loads as indicated in the…

A: Basic concept used for tension and compression,If a force is acting away from the section, it will…

Q: Q.2) For the figure shown, if a load P₁ = 120 kN at A and load P₂ 100 kN is uniformly distributed…

A: Given:Find:Poisson's ratio for the pipe material.

Q: *5-32. The pump operates using the motor that has a power of 85 W. If the impeller at B is turning…

A: Power P=85W Speed N=150rev/min diameter D=20mm To find Maximum shear stress τ

Q: Т2 KN KN MPa MPA MPa MPa

A: Given data as per questiondimensions of  steel plate = 2.5 x 1.5 x 0.08 m weight of the steel plate=…

Q: An aluminum rod is rigidly attached between a steel rod and a bronze rod as shown in figure. Axial…

A:

Q: The rigid bar AB as shown in Figure Q1(a) is supported by a steel road AC having a diameter of 22 mm…

A: Diameter of steel rod = 22 mm Cross section area of aluminium block = 2000 mm2 Diameter of pin = 20…

Pressure Vessels

The term pressure vessel refers to a closed container that contains gas or liquid at a different pressure than environment pressure. The pressure vessels have a wide scale of applications in our day-to-day lives and other industrial places. Some common examples of pressure vessels are gas cylinders, autoclaves, compressor vessels, etc.