1.30 The lap joint is connected by three 20-mm-diameter rivets. Assuming that the axial load P= 50 kN is distributed equally among the three rivets, find (a) the shear stress in a rivet; (b) the bearing stress between a plate and a rivet; and (c) the maximum average tensile stress in each plate, P 130 mm 0 0 0

1.30 The lap joint is connected by three 20-mm-diameter rivets. Assuming that the axial load P= 50 kN is distributed equally among the three rivets, find (a) the shear stress in a rivet; (b) the bearing stress between a plate and a rivet; and (c) the maximum average tensile stress in each plate, P 130 mm 0 0 0

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

INTRUCTIONS: Read the problems carefully. Show your COMPLETE and NEAT solution. Box ALL intermediate and final answers, round them to the nearest thousandths (three decimal places). Do not forget to affix the corresponding units. Situation 1. Locate the Centroid from point O. Also, determine the moment of inertia about ë and x 10m 18m d = 4m 45° 5m 8m 12m ----
The pressure on a closed tank reads 68.86 kPa. What is the equivalent height in terms of Oil having a sp.gr of 0.85? Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: m Decimal Places required in the final answer: 3
A pressure gauge at elevation 12m at the side of an open tank containing a liquid reads 80 kPa. Another gauge at elevation 7m reads 120 kPa. What is the elevation of the liquid surface? Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: m Decimal Places required in the final answer: /Zero
Show neat solutions Fluid mechanics
A manometer is attached to a water tank (s=1) as shown in the figure.Find the height of the free water surface above the bottom of the tank in m. Round your answer to 2 decimal places.
Show complete solutions Fluid mechanics
Write your solution in paper (manual handwriting) with the following content: Given with figure, Required, Equations, Solution and Final answer/s.
Using the concepts discussed in this chapter, measure the volumetric flow rate of water out of a drinking fountain.
I need a quick solution within 15 minutes With my best wishesTon.
A cylindrical tank having a diameter of 2.0m and height of 10m is open at one end and closed at the other end. It is placed below the water surface with its open end down. How deep below the water surface should the tank be placed if the depth of water inside is 3.6 m. Do not write the unit. You will only input the numerical answer in the space provided. Unit of the Correct Answer: m Decimal Places required in the final answer: 2
Part A Determine the moment of inertia of the overhung crank about the x axis. The material is steel having a destiny of p= 9.85 Mg/m³. (Figure 1) Express your answer to three significant figures and include the appropriate units. HA Iz = 0.003078 kg • m? Submit Previous Answers Request Answer Figure 30 mm 90 mm 50 mm 180 mm 20 mm 30 mm 20 mm- 30 mm- 50 mm
A person by the name of Huebscher developed a relationship between theequivalent size of round ducts and rectangular ducts according to D = diameter of equivalent circular duct (mm)a = dimension of one side of the rectangular duct (mm)b = the other dimension of the rectangular duct (mm)Using Excel, create a table that shows the relationship between the circular and the rectangular duct dimensions, similar to the one shown in the accompanying table.