Answered: 1. Z parameters=? 492 392…

1. Z parameters=? 492 392 a.)z11=7ohms,z12=z21=z22=3ohms b.) a.)z11=8ohms,z12=z21=z22=4ohms c.) a.)z11=9ohms,z12=z21=z22=5ohms

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

DISCUSSION:- 1. From procedure (A), draw the relation between the practical current (I) and resistance (R) in graph paper. Then show this relation is directly or inversely proportional? 2. From procedure (B), draw the relation between the practical current (I) and voltage (V) in graph paper. Calculate the value of R from this graph. Then show this relation is directly or inversely proportional ? 3. 3. What is the potential voltage drop (V) across a resistor (R) 60 if the current(I) 2.5A ? 4. 4. What is the current (I) passing through a 72 Q resistor (R) if voltage drop (V) across it is 12 V ? 5. 5. How much resistance (R) is required to limit the current (I) to 0.76A if the potential drop (V) across the resistance(R)it is 120V ?
In solving a network, what rule must you observe when writing KCL equations? Why?
Answer this problem and show your step by step solution.
A metallic wire is stretched from original length of 2 m to 5 m. If the original cross-sectional area is 4 square millimeters and original resistance is 8 ohms, determine the new resistance (in ohms) of the metallic wire. Assume the volume of the wire is preserved.
Q3) The self capacitance of each unit in a string of four suspension insulators is C. The shunting capacitance of the connecting metal work of each insulator to earth is 0-2 C. Calculate (i) the voltage across each insulator and (ii) string efficiency.
During the Wheatstone Bridge experiment, when the pointer is at the balance point then: O a. The potential difference across the unknown resistance is equal to the potential difference between the end of the wire connected to the known resistance.the balance point. O b. The potential difference across the known resistance is equal to the potential difference between the balance point and the point of contact between the known andunknown resistances. O c. The potential difference across the unknown resistance is equal to the potential difference across known resistance. O d. The potential difference across the unknown resistance is equal to the potential difference between the balance point and the end of the wire connected to the unknown resistance. O e. The potential difference across the unknown resistance is equal to the potential difference between the balance point and the end of the wire connected to the known resistance. Clear my choice
1. A given material has a resistance of 20 2 at room temperature (20°C) and 25 2 at a temperature of 85°C. a) Does the material have a positive or a negative temperature coefficient? Explain briefly. b) Determine the value of the temperature coefficient, a, at 20°C. c) Assuming the resistance versus temperature function to be linear, determine the expected resistance of the material at 0°C (the freezing point of water) and at 100°C (the boiling point of water). 2. Find the equivalent resistance Rab in the circuits of Figure below. a o 10 Ω 60 Ω 30 2 ww 20 Ω
a) Find and explain the Ohm conservation expression.b) Stable current circulation is desired for the lamp connected in a circuit to light. Accordingly, discuss with the conservation law of the charge how a stable current circulation can occur from any part of the circuit.I need to explain the answers to these questions, please can you explain in detail. Thanks in advance.
Give 15 Electrical Components and Materials that can be found in every houses. Briefly explain its functions.
Q3: Is it preferable to have an insulating material with a high tand or a low tand use in :(1) Low voltage cables, and (2) High voltage cables? Give reasons for your answer.
A piece of wire has a resistance of R. Another piece of wire has twice the length and also twice the diameter of the first piece of wire. Find the resistance of the second piece of wire in terms of R.
Given, A=5 B=2 c=4 Given circuit Diagram R₁= AA.C2 = 55.4-2 52.42 R2 = AB.C 223 R3 = BCA = 24.52 R4 CA.B 2 $ 45.22 RS = AC-BR 54-2-2 R6 = BA. C 22 ⇒ 25-4-2 42052 R7= (BAR X = 2 AB V ⇒ 25.2 V I = 0 BCA 0.245 A