ANSWER QUESTIONS FOR THE EXPERIMENT TITLE “Water Content In Soil” Answer to "Questions"1. Why is it not recommended to leave an oven-dried sample in the open air for along time before measuring its dry weight?2. Excluding oven drying, are there other methods to determine the water content ofsoils?3. Is it possible to measure the water content of sands?4. Why do we use a fixed temperature range to dry soils? What is the effect on soilsof microwave drying?5. What is the function of the container lid and dessicator when determining thewater content of soil?

Oven Dried Method is one of the most accurate methods. In this method water content in sample is…

1. Why is it not recommended to leave an oven-dried sample in the open air for a long time before measuring its dry weight? 2. Excluding oven drying, are there other methods to determine the water content of soils?

1. Why is it not recommended to leave an oven-dried sample in the open air for a long time before measuring its dry weight? 2. Excluding oven drying, are there other methods to determine the water content of soils?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: You have been assigned to check the stability of the dam at the nearby lake. You ran a soil…

A: From the above figure and data, we have to find out the followings: Seepage beneath the dam per…

Q: Calculate the arithmetic average and thickness-weighted average oil saturation. SAMPLE THICKNESS ,…

A: GIVEN Six samples, n =6 Thickness of each sample, h1, h2, h3, h4, h5, h6 H = Σh = 14.5 Percentage…

Q: What are the gravimetric water contents just before and just after irrigation

Q: A large laboratory has four types of devices used to determine the pH of soil samples. The…

A: Consider the given data. (a) The spread of data shows that mean of the device D is larger than that…

Q: Volume by immersion vs. volume by measurement Provide a comparison about the two methods on how to…

A: comparison about the two methods on how to determine the unit weight of the soil

Q: Soil B Soil C Sieve No. Diam Soil (mm) A 92 78 No. 10 2.000 77 0.420 53 No. 40 84 0.074 No. 200 17…

Q: Q1: The results of a standard Proctor test are given in the table. The volume of the proctor mold…

A: Standard proctor test is a laboratory method used to determine the moisture content at which soil…

Q: An analysis of city drinking water for total hardness was done by two students in the laboratory and…

A: Disclaimer: Since the question has more than 3 subparts so, only the top 3 parts will be prioritized…

Q: Question 7 Listen Moisture content specimens should be discarded after testing and not used in any…

A: 1. True. Moisture content specimen should be discarded after testing and should not be used in…

Q: The soil passing the no. 200 sieve was used to conduct a hydrometer test. The results are shown in…

A: Plot a semi-log graph with Percent finer on y-axis and grain size on x-axis.

Q: The calcium carbide method is used to determine the water content of a soil. The weight of water…

Q: 5. The homogeneity of the chloride level in a water sample from a lake was tested by analyzing…

Q: , g 19.44 18.78 18.75 22.10 Weight of container, g 12.74 13.24 13.20 13.27 Weight of…

Q: 1. Why is it not recommended to leave an oven-dried sample in the open air for a long time before…

A: It is well known that the water content of soils significantly influences their behavior, strength,…

Q: What is the % natural moisture content of the soil sample tested in the laboratory with the…

Q: Determine the moisture content, the moisture content by dry weight per trial based on the table…

A: The moisture content of a material indicates how much moisture is present. The percentage of the…

Q: Question 4 Listen The principal objection to the use of the microwave oven for water-content…

Q: Select True or False The modified proctor test yields a higher value of T4-max at a lower water…

A: The purpose of the proctor test is to determine the relationship between a soil's moisture content…

Q: The table below shows the test result Trom a certain soil laboratory test. Approximate the largest…

A: Moisture Content (%) Mass of moist soil (gm) 5 1776 7.0 1890 9.5 2006 11.8 2024 14.1…

Q: Why it is necessary for the water samples collected during site investigation be tested for…

A: Chloride test - It is present in salt water and pure water. In excess level ,the water becomes worst…

Q: A standard Proctor test was performed on a soil which has a G = 2.75. The moisture content and total…

A: We have to determine the value of dry unit weight for each sample and dry unit weight for 12% and…

Q: The following table was obtained from a standard proctor test. Fill-up the table a sure to provide…

A: Weight=mass9.811000 KnUNit weight=WeightVolumeDry unit weight=UNit weight1+moisture100 No Mass of…

Q: Based on my data and result could be the recommendation and conclusion. This laboratory test is a…

A: Given data, Average specific gravity = 2.47

Q: The dimensions of a cylindrical core sample are 10.16 cm long and 3.81 cm in diameter after it was…

A: This question is related to the Soil Mechanics.

Q: Question 19 A water content test was conducted and the data were recorded as follows: The mass of…

Q: Standard Proctor test was conducted on a silty clay soil collected from a proposed construction…

A: As per our guidelines we are supposed to answer only first three subparts. So kindly please repost…

Q: Given following data, calculate a. Average specific gravity b. Average absorption value

Q: A sample of soil was tested in the laboratory, and the test results were listed as shown in the…

A: As percent passing No. 200 (58.8%)is more than 36%, the soil is either A4,A5,A6 or A7 depending on…

Q: In a falling head permeameter test, the head drops by 5 cm in 10 minutes from the initial head of 30…

Q: The lab methods discussed in class are not the only means of measuring specific gravity- one can…

A: Given SSD WEIGHT= 618 g

Q: From the given data, shows a sieve analysis of soil samples A and B. Classify the soil according to…

A: We need to find group symbol and Group index number based on the given data Since we are given %…

Q: A mercury manometer type tensiometer has been installed in a mustard field. The manometer shows a Hg…

A: Given- Manometer reading=55cmLevel of mercury in the cup=10 cmDensity of Hg =13.6 The diagram is…

Q: A liquid limit test conducted on a soil sample in the cup device gave the following results: Test…

A: Note : Since you have posted a question with multiple sub-parts, we will solve the first three…

Q: A liquid limit test conducted on a soil sample in the cup device gave the following results: | 27 N…

Q: A Standard Proctor Test was completed according to Method A described in Chapter 12. The following…

Q: Mass of can, lid and moist soil (g) 29.24 28.69 28.98 Mass of can, lid and dry soil 28.47 26.91…

Q: You are given three soil samples. Soil sample 1 is silty sand. Soil sample 2 is clay. Soil sample 3…

Q: one is finer: Soil A or Soil C?

Q: A Standard Proctor Test was completed according to Method A described in Chapter 12. The following…

A: Standard Proctor test: By eliminating air spaces, compaction densifies soil by making it more…

Q: How temperature plays an important practical role in capillary rise in soil?

Q: If you placed a thermometer inside soil that has been heated, would you expect the soil to show a…

A: Brief concept- Carbon dioxide gas- It is a combination of two elements carbon and oxygen. It is a…

Q: the 100 cubic centimeter soil sample above starts to drain. calculate the volume of air at the…

Concept explainers

Integrated Solid Waste Management

Integrated Solid Waste Management (ISWM) is a thorough waste suppression, compost, removal and recycling Program. An effective ISWM system considers how to suppress, manage and recycle solid waste in a manner that is most efficiently to protect human health and the surrounding. ISWM system requires evaluation of public wants and demands and then selecting and merging the most effective waste management activities for the proposed demands. The main ISWM activities for solid waste management are Waste prevention, Recycling and Composting, and Combustion and Removal and waste collection in a properly planned, constructed, managed and mitigated landfill areas. Each of these requires careful designing, financing, accumulation, and delivery of activities.

Question

ANSWER QUESTIONS FOR THE EXPERIMENT TITLE “Water Content In Soil”

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given Data

Step 2: Solution

Step 3: Solution

Solution

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

LIQUID AND PLASTIC LIMIT Please help me analyze data obtained from our atterberg experiment. What do these findings say about Liquid and Plastic limit. How can I relate these to real-world engineering practice?
Q16. The data in the accompanying table resulted from performing Standard Proctor Tests on a soil. Plot the data and determine the soil's laboratory optimum moisture content. Dry Density Ib/ft3 Moisture Content 12 103.1 14 106.2 16 108.9 18 112.8 20 110.5 22 105.5
Based on my data and results can you please provide me a conclusion. and recommendation.
can you answer Questions 2 and 3 on Homework questions.jpg
Calculate the followingi. Liquid limitii. Plastic limitiii. Plasticity index
help me solve the following problems. thank you!
Determine the average water content of a certain soil sample with the following data: Specimen Number Mass of empty, clean moisture can and lid Mass of moisture can, lid, and moist soil Mass of moisture can, lid, and dry soil Round your answer to 3 decimal places. 1 31 70 61 2 30 71 62
1. From the given data, shows a sieve analysis of soil samples A and B SIEVE PERCENT NO. PASSING SOIL SOIL A B 4 100 100 8. 97 90 10 92 77 20 87 59 40 53 51 60 42 41 100 26 35 200 17 33
Please try to solve in 1 hour
What is dry unit weight of the soil sample below (ya) in Ib/ft ? The combined weight of a mold and the compacted soil sample is 8.8 lb The mold's volume is 1/30 ft3 The mold's weight is 5 lb The soil sample's water content is 14% Please ROUND to the nearest Thousandth (i.e., 0.001). Enter only numbers (Do not enter units!). Answer:
Outline the basic principles involved in the process that enables the nuclear moisture–density testing equipment to provide a data readout on soil density (or unit weight) and moisture content.
You are studying the mineralogy of a soil and have made the following measurements in the lab: The soil is composed of 64% clay, with 3% organic matter. The soil pH is 6.5. The total soil CEC is 70 cmolc/kg. Using the assumption that the CEC of organic matter is 150 cmolc/kg at pH 6.5. please determine the most likely kind of clay mineral that is present in the soil sample. allophane gibbsite ilite O smectite Cation exchange occurs because cations are bound to soil colloids through O inner sphere complexes O cation bridging pH dependent complexes outer sphere complexes