1. Which of these statements is TRUE about smooth surfaces and friction? A. Smooth surfaces will always have a higher normal force than rough surfaces. B. Smooth surfaces will always have a higher coefficient of friction than rough surfaces. C. Smooth surfaces will always have a lower coefficient of friction than rough surfaces.

1. Which of these statements is TRUE about smooth surfaces and friction? A. Smooth surfaces will always have a higher normal force than rough surfaces. B. Smooth surfaces will always have a higher coefficient of friction than rough surfaces. C. Smooth surfaces will always have a lower coefficient of friction than rough surfaces.

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

1. Two blocks are connected by an ideal string that passes over a pulley. Both lie on a smooth, frictionless inclined surface. The lean angle for the M1 is 30 degrees and the lean angle for the M2 is 60 degrees. Draw the free body diagram of the system. a. Determine what is the acceleration of the system and the tension in the string if M1 = 5 kg and M2 = 3 kg. b. What if there was a coefficient of friction that was 0.47 for both masses? How does acceleration and tension change?
2. In the figure shown, the spherical ball has a diameter of 12 cm and weighs 20 kg. A 30.0-cm rope is used to hold the ball against a frictionless wall. A. Draw the FBD and show all of the forces acting on the ball. B. How much tension does the rope experience? C. How much force is applied by the ball against the wall? 30.0 cm->
1 po A cart of weight W is lifted up at constant speed by a steel cable attached to an electric pulley. Assuming there is no resistive forces and the mass of the steel cable is negligible compared to the mass of the cart, what can we conclude about the force T. exerted by the cable on the cart? T=W, T is directed upward T
A 10-kg wooden box rests on a ramp that is lying flat. The coefficient of static friction is 0.50, and the coefficient of kinetic friction is 0.30. What is the friction force between the box and ramp if a 30 N horizontal force is applied to the box? A.50 N B.20 N C.0 N D.30 N
2. A two body system is set up on an inclined surface with M = 5 kg and m = 4 kg. The angle is 25 degrees. And the static frictional coefficient is 0.25, and kinetic frictional coefficient is 0.20. i. Find the parallel and perpendicular components of the Mg. ii. Find the static frictional force and kinetic frictional force. iii. Determine which way the system will move, uphill or downhill. iv. Once it starts, find the tension T =? v. Once it starts, find the acceleration, a=?
An orthodontist places 35 pounds of tension on the wire across your teeth.The insicor is just forward so that the wire is bent at 15 degrees on either side. a. What net force does the wire apply to the tooth? b. The tooth shifts and the ledt angle becomes 10 degrees while the right angle becomes 20 degrees. Assuming that the tension stays the same, what force is now applied to the tooth?
4. The force system shown consists of the couple C and four forces. If the resultant of this system is a 75000-N mm counterclockwise couple, determine P, Q, and C. Q y 12 A 400 N 100 N 30 mm B 30 mm² X
2. A block of mass 3.00 kg is pushed up against a wall by a force P that makes a 50.0° angle with the horizontal as shown in the figure. The coefficient of static friction between the block and the wall is 0.250. Determine the possible values for the magnitude of P that allow the block to remain stationary 50.0° P
9. A ball rolls down a slope and off a flat floar. ignoring air resistance, what force or farces act on the ball as it moves through the air just after leaving the flat floor? a. The weight of the ball acting vertically down. b. A horizontal force that maintains the motion. C A force whose direction changes as the direction of motion changes d. The weight of the ball and a horizontal force. e. The weight of the ball and a force in the direction af motion.
4. A block of mass 3.00-kg is pushed against a wall by a force P that makes an angle of 50.0° with the horizontal as shown in the figure below. The coefficient of static friction between the block and the wall is 0.250. a. Determine the possible values for the magnitude of P that allow the block to remain stationary. P
2. Determine the minimum value of P to just lift the block W = 500 N, where 0 = 20°, as shown. The coefficient of static friction at all contact surfaces is Hs = 0.30. Neglect the weight of the wedge. W
1. A box with mass m is dragged across a level floor with coefficient of kinetic friction by a rope that is pulled upward at an angle above the horizontal with a force of magnitude F. In terms of the variables given, write an expression for the mass of the box needed so that it moves across the floor at a constant speed.